拉緊裝置 的英文怎麼說

中文拼音 [lājǐnzhuāngzhì]
拉緊裝置 英文
slack adjuster
  • 拉 : 拉構詞成分。
  • 緊 : Ⅰ形容詞1 （物體受到幾方面的拉力或壓力以後呈現的緊張狀態） taut; tight 2 （物體受外力作用變得固定...
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 拉緊 : cocking; tensioning; straining; forehand; effort拉緊螺母 tightening nut; 拉緊螺栓 draw in bolt ; ...
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Draw - in collets ; collets, holding fixture

    內拉簧套圈.筒夾.套筒夾緊裝置
  2. Reform of the fixed belt conveyor tension device used for cleaned powder coal

    洗末煤上倉帶式輸送機拉緊裝置的改造
  3. Application of tension unit on dyl - 02 long distance belt conveyor

    02拉緊裝置的應用
  4. Fixed railway installations. equipment for overhead telecommunication and signalling lines. stay - tightener with standard eye

    鐵路固定設備.通訊和信號裝置架空線路用器材.帶標準孔的固定拉緊器
  5. Fixed railway installations. equipment for overhead telecommunication and signalling lines. stay tightener with reinforced eye

    鐵路固定設備.通訊和信號裝置架空線路用器材.帶加強孔的固定拉緊器
  6. Fixed railway installations. equipment for overhead telecommunication and signalling lines. tie and bracing bolts

    鐵路固定裝置.通訊和信號裝置架空線路用器材.系緊和拉緊螺栓
  7. Analysis of tensioning device for belt conveyor

    帶式輸送機拉緊裝置的分析
  8. Influence of tension device on starting of belt conveyor

    拉緊裝置對帶式輸送機起動的影響
  9. On hydraulic strain device for belt conveger

    帶式輸送機液壓拉緊裝置
  10. The intelligent hydraulic press tension device of the belt conveyor

    帶式輸送機智能液壓拉緊裝置
  11. Analysis on tensioner of conveying belt

    帶式輸送機拉緊裝置分析
  12. The application of yzl - 200 automatic tensioner of belt conveyor

    200型帶式輸送機自動拉緊裝置的應用
  13. Szl automatic hydraulic devices in belt conveyor create applications

    型自動液壓拉緊裝置在帶式輸送機上的應用
  14. The rational maintenance of diesel power system for mine trackless tyre - vehicle

    帶式輸送機自動拉緊裝置的計算方法
  15. Based on the analysis of designed cad graphics and the given parameters, computer can convert the cad graphics to a acdbpolyline which can simulate the routine of the conveyor chain. then by using the method of point - by - point strain calculation, computer could figure out each point ’ s strain of the chains under different load states, and get the results such as strain ’ s maximal and the minimal values and their positions, weight of the strain equipment and power of the drive electric - machinery that the conveyor need

    通過對設計的cad圖形和給定參數的分析，將輸送鏈運行軌跡轉化為一條可模擬輸送鏈軌跡的多義線，然後用逐點張力計演算法動態地計算出各種加載狀態下輸送鏈上各點的受力，得出最大、最小受力點的力的大小和位置，拉緊裝置的重量，驅動電機所需的功率等結果。
  16. Based on the application of long belt conveyor, introduced in brief the design essential - layout of the whole machine, requirements of the start - stop control and the caculation of dynamic analysis ; summarized on emphasis collocation and requirements of the main components ( including drive device, turn - over device, tension device, cleaning device, cylinder and supporting roller ) and introduced the start - stop control and measures of deflection - proof

    摘要針對國內長距離帶式輸送機的應用情況，概要介紹了長距離帶式輸送機的主要設計環節整機總體布置、起制動控制要求、動態分析計算；重點總結了其主要部件（包括驅動裝置、翻轉裝置、拉緊裝置、清掃裝置、滾筒、托輥）的配置方式和要求；並就其啟制動控制和防偏措施進行了的歸類總結。
  17. Band conveyers used in fishery docks. essential parameters, dimensions and technical requirements of screw with slide jockey - pulley tensioner

    漁業碼頭用皮帶輸送機.滑塊式螺旋拉緊裝置基本參數尺寸與技術要求
  18. The program scheduled in this paper has simulated several event including different layout of take - up and various starting accelerations curves. at the same time, the laboratory experiment has done to do the confirmation

    編制的模擬程序對所建的連續模型針對拉緊裝置不同的布置方式和不同的激勵方式等工況進行了模擬，並在此基礎上進行了實驗驗證。
  19. Improvement of small vehicle take - up device for gds - 100 type wirerope belt conveyor

    100型鋼纜帶式輸送機輸送帶張緊小車拉緊裝置改進
  20. Gravity take up

    重力拉緊裝置
分享友人
分享到 Line

分享到臉書