拋擲藥包 的英文怎麼說

中文拼音 [pāozhìyàobāo]
拋擲藥包 英文
pin-point charge
  • : 動詞1. (扔; 投擲) throw; toss; fling 2. (丟下; 拋棄) leave behind; cast aside; abandon
  • : 擲動詞(撒下) throw; cast
  • : Ⅰ名詞1 (藥物) medicine; drug; remedy 2 (某些有化學作用的物質) certain chemicals Ⅱ動詞1 [書面...
  • 拋擲 : [書面語] throw; cast; loft; flip; match
  • 藥包 : blasting cartridge
  1. The experimental result indicated that when the spacings meet some area, the blasting can gain the least visible depth, the biggest open area of blasting craters, the biggest thrown distance and a better accumulation state

    實驗結果表明,當平面間、排距滿足一定范圍時,爆破漏斗的可見深度較小,而開口面積和距離最大,爆堆形態較好。
  2. Through a lot of small scale simulated tests in construction field, this paper systemically analyzed the dependence of the open area and visible depth of blasting craters, the thrown distance and the accumulation state of rock on the row spacing and the column spacing of plane charge

    本文通過在施工現場進行的大量小型模擬實驗,對平面間、排距與爆破漏斗的開口面積、可見深度、爆巖的距離和堆積形態等關系進行了系統分析與研究。
  3. The relative problems , whlchare charged factor that the part thro ’ blasting influence o 幾 the divided charges and the choice of blasting network in chamber blasting , are studied on the basis ofyuncheng ? ? sanmenxlaexpressway large scale blasting engineering in this paper firstly , the latter chamber ’ s charged factor influenced by part throwblasting , are discussed the comparable figobtained from above discussion can reflect the influence clearly the divided charges are studied systematically by theoretic analysis , engineering calculate and simulated experiments the simulated experiments and engineering practice have been proved that intervals bet ’ een the divided charges , which are engineering calculated , are practicable ; and blasting effect s good in order to find proper blasting networks for types of chamber blasting , several familiar nonelectrlcal blasting networks are analyzed and calculated by probability theory and numerical stat

    本文以運城三門峽路塹大爆破工程為實驗基礎,對峒室爆破中局部對裝系數的影響、分裝以及大爆破網路的選擇等相關問題進行了研究。從大爆破裝系數分析了局部對后續的影響,並得到了它與常規裝系數的比較圖,從而更直觀地反映出局部對裝系數的影響。運用理論分析、工程計算和模擬實驗相結合對分裝進行了系統的研究。
分享友人