振蕩倍頻器 的英文怎麼說

中文拼音 [zhèndàngbèibīnqì]
振蕩倍頻器 英文
oscillator doubler
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 倍 : Ⅰ名詞（跟原數相同的量） times Ⅱ形容詞（加倍） double; twice as much
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Motion controller composed of general chip series is developed and quadruple differential circuit utilizing dual monostable multivibrators with schmitt trigger inputs and dual 4 _ line to l _ line data selectors or multiplexers is put forward

    本論文研製了一種用常規晶元系列組成的運動控制器，提出了採用單穩態多諧振蕩器和數據選擇器的四倍頻辨向電路。
  2. It is transparent in a region from the visible to the infrared range ( 0. 45 - 13 ? m ) and has a fitful birefringence and a large nonlinear coefficient. aggas2 crystal can be made to be octonary device, difference - frequence device and parametric oscillator, and laser sources of different frequences in 1. 8 - 11 ? m band can be provided

    其紅外透波范圍寬（ 0 . 45 - 13 m ） ，具有適宜的雙折射率和大的非線性系數，可製成倍頻、差頻和光參量振蕩器件，在1 . 8 - 11 m范圍內可提供多種頻率的激光光源。
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. A x - band six - cavity tro is studied. with the voltage 760kv 6ka and the magnetic field 2. 6t in the simulation, output power is about 1. 5gw is obtained, and interaction efficiency is 31 %. a noveland high accurate numerical synthetic technique is presented for determining the high frequency characteristics of six - cavity with open boundary

    對粒子模擬的輸出微波功率的作出診斷，找到讀取微波功率快速有效的方法：在電場和磁場同相的前提條件下，對時域波形進行傅立葉變換，微波功率頻域的二倍頻所對應的幅度即為微波x波段渡越輻射振蕩器的理論和實驗研究平均功率的大小。
  5. At present, ktp has been widely used in second harmonic generation ( shg ), sum ( difference ) - frequency mixing, optical parametric oscillators ( opo ) and optical parametric amplification ( opa )

    目前， ktp已作為一種商業化的晶體廣泛應用於中小功率固體激光器的倍頻（ shg ） 、和（差）頻、光參量振蕩（ opo ）和放大（ opa ）等。
  6. In this chapter, the suitable devices and circuit structure have been choosed to design a second order multiplier, a fifth order multiplier, a sixth order harmonics mixer and a dro operating in 9. 4ghz. the forth chapter is a section of system realization and test, in this chapter, the system of low phase noise frequency source has been constructed and tested. the results show that the targets of the system have been achieved

    第三章的系統分器件與實驗數據部分，主要是以上述第二章的分析為基礎，以所推導的理論公式為指導選取必要的器件和合適的電路拓撲結構，分別設計實現了一個二次倍頻器，五次倍頻器， 6次諧波混頻器和一個9 . 4ghz的介質振蕩器，為後述整個系統的實現在硬體上做了必要的準備。
分享友人
分享到 Line

分享到臉書