振蕩器噪聲 的英文怎麼說

中文拼音 [zhèndàngzàoshēng]
振蕩器噪聲 英文
generator noise
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 動詞1. (蟲或鳥叫) chirp 2. (大聲叫嚷) make noise; make an uproar; clamour
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中,作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;和控制電路中尖峰脈沖抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator

    本文研究了以低損耗、高q值表面波(其中包括表面瑞利波- - rayleighsurfaceacousticwave ,和表面橫波等)諧的工作原理、設計參數、製作工藝及其實驗結果,並且研究了以1ghzstw諧為頻控元件的高頻率、低相位表面波,以及低相位表面波的測試方法和最終的測試結果。
  3. The precise clock source is crystal oscillator made of 74hc04 ; the mute circuit can conceal the error and solve the problem of noise ; the antenna switching circuit in the receiver is to select one antenna from two which receives signal better. it can improve the quality of the receiving audio signal, restrain the noise effectively and promote the system performance

    高精度的時鐘源是由74hc04構成的晶體;靜音電路將出錯的音頻信號進行差錯掩蓋,很好地解決了問題;接收機採用兩副天線切換工作,提高了音頻信號接收質量,有效地抑制干擾,提升了系統的性能。
  4. With consideration of parameters trade - offs involved in the circuits, the vco ’ s topology is designed

    考慮壓控設計指標的相互約束條件,盡可能減小相位的來源,設計電路的拓撲結構。
  5. In this paper, the operation principle of the oscillator is analyzed first, from the point of view of theory the designs of crystal resonator and its equivalent circuit, crystal oscillator and thermostatic chamber are defined. the noise model of circuit is used to analyze key factors influencing phase noise of the crystal oscillator, in order to control phase noise of the crystal noise from the very beginning of the design

    本文首先分析了的工作原理,從理論的角度闡明了晶體諧及其等效電路、晶體和恆溫箱的設計,利用電路的模型來分析影響晶體相位的關鍵因素,從設計就開始控制晶的相位,為更好地實現課題的目標打下良好的基礎。
  6. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧網路(諧網路是通過cst模擬得到的,它是串聯反饋迴路,介質工作在te01模,對于其後的fet ,它又相當於一個帶阻濾波) ,然後設計輸入輸出匹配電路,使電路結構滿足起條件,之後繼續用諧波平衡法模擬和優化,使輸出功率合適,相位很低。
  7. 3 ) the quantum noise characteristics of the output of tropo are theoretically analyzed and the intensity - diflerence squeezing of two down - conversion beams was experimental obtained. the intensity - difference noise reduction was 0. 4db

    第三章:討論了三共光學參量的量子特性,並實現了兩下轉換光之間的強度差壓縮,壓縮度達0 . 4db 。
  8. First, the theory, the merit and noise analyzing is expatiated on, and then the hardware realizing process of if digital receiver is introduced concretely

    首先闡述了數控的工作原理、優點和分析,接著具體闡述了數控的硬體實現。
  9. First, an analysis for the design of the impulse phase lock oscillate, which includes impulse phase detector the dielectric resonant oscillate etc. secondly, presents an analysis for the design of wide band balanced low noise amplifier. the last two part simplify the theory and the electrical characteristics of the sub harmonic mixer, and the mmvco

    第一部分著重介紹了脈沖鎖相源的工作原理(主要包括取樣鑒相和介質穩頻的壓控) ,並介紹了研製結果的性能指標;第二部分介紹了平衡式寬帶低放大的基本理論
  10. There is a pll ( phase locked loops ) in system to get a high - stability low - noise high - frequency signal

    固定頻率通常採用鎖相環技術來獲得高穩定度、低相位的高頻輸出信號。
  11. Rc and other relaxation oscillators just will not do since amplitude noise in whatever circuit functions as a comparator will appear as phase noise on the output signal

    Rc諧以及其它一些張弛不能滿足要求,這是因為它們的核心是電壓比較,需要利用電壓信號的波動()來獲得穩定的輸出,這種波動就構成了時鐘的抖動。
  12. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素( ql值)超過1000的一系列低損耗、高q值表面波rayleigh波或stw諧,頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能表面波諧。並採用系數為1 . 25db的低系數放大,精心設計電路,優化設計布置印製電路板,用標稱頻率為1ghz的表面波諧為頻率控制元件,製作出在偏離載頻1khz處的單邊帶相位近- 120dbc / hz 、雜波抑制達80db以上的低相位表面波
  13. Understand the phase - noise limitations of the analyzer when making such measurements on oscillators

    當測量時,理解分析儀的相位限制。
  14. The adc aperture jitter must be minimal, and the sampling clock generated from a low phase - noise quartz crystal oscillator

    Adc的孔徑抖動必需盡可能的小,而且要使用低相位的石英晶體作為采樣時鐘發生
  15. It admits of no delay to develop high stability crystal oscillator and enhance its phase noise index to reduce the effect of jitter to the performance of the whole system

    研製高穩定晶體,提高相位指標、減少抖動對整體性能的影響,已經成為刻不容緩的任務。
  16. According to leeson model, which had proposed the relationship of noise between output and input in the feed - back oscillator, an experimental crystal oscillator circuit with high stability and low phase noise is designed

    參照提出反饋中輸出和輸入關系的李森模型,設計一高穩定低相位的實驗電路,並在實驗中分析電路關鍵元件對電路整體性能的影響。
  17. 2. the vco ’ s topology is presented according to the conditions of low voltage - supply, low power consumption, low phase noise and large tuning range

    2 .以低壓、低功耗、低相位和較大調諧范圍為原則完成壓控的電路結構設計。
  18. The vco is optimized according to the targets of low voltage - supply, low power consumption, low phase noise and large tuning range. with a voltage - supply of

    與由反型mos變容管調諧的壓控比較,結果表明積累型變容管調諧的vco具有更好的相位性能。
  19. On - chip vco is a key factor in lowering the cost of wireless transceivers and has sturdy requirements in system application. it ’ s an important subject in the area of rf ic to fulfill the noise and tuning range requirements with low power consumption

    如何在較低的功耗下設計性能和調諧范圍滿足系統應用要求的全集成壓控,仍然是目前射頻集成研究領域的難點。
  20. The article starts with the vibrating impact on the crystal oscillator in the radar frequency synthesizer, and analyses the phase noises of crystal oscillator under the random vibration condition

    摘要從動對雷達頻綜中晶體的影響入手,分析晶體在隨機動條件下的相位
分享友人