振蕩模式頻率 的英文怎麼說

中文拼音 [zhèndàngmóshìbīnlǜ]
振蕩模式頻率 英文
mode frequencey
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 模式 : model; mode; pattern; type; schema
  • 頻率 : frequency; rate
  1. Compared with non - slung - load flight, additional aerodynamic load, gravity load should be considered in the slung - load system. so the moment to the gravity center, flight mode and the natural frequency will change

    直升機吊掛飛行，與直升機非吊掛飛行狀態相比，增加了新的氣動載荷、重力載荷，和因此產生的對直升機重心的力矩，其飛行運動模式、低頻振蕩固有頻率均發生改變。
  2. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  3. The virtual cathode oscillator ( vircator ) is one of the most important devices that can produce high power microwaves. for the increasing of microwave power and the locking of operation frequency, researchers have proposed many different types of improved vircators

    軸向反饋式虛陰極振蕩器主要利用反饋微波調制電子束和虛陰極，從而增大微波輸出功率、提高效率、穩定頻率、凈化模式。
  4. Research on cmos implementation of wlan transceiver rf front - end is done in this thesis. the transceiver uses the most used super - heterodyne architecture, its rf front - end consists of low noise amplifier, down - converter, up - converter, preamplifier, lo buffer and pll frequency synthesizer

    本論文研究無線局域網收發機射頻前端的cmos實現，該收發機採用超外差式的拓撲結構，其射頻前端主要由低噪聲放大器、下變頻器、上變頻器、末前級、本地振蕩信號緩沖器和鎖相環型頻率合成器等模塊組成。
  5. The simulation results show the existence of both limits and optima for the studied parameters, related to the stable operation and the maximum efficiency, respectively. underlying the conditions that the longitudinal guiding magnetic field is 1. 8t, diode voltage is 250 kv, the impedance is 150, we got a peak power as high as 100 mw for the tm01 mode at 38ghz

    經優化設計，本文給出了一個相對論亞納秒毫米波返波振蕩器的物理模型，在引導磁場為1 . 8t 、二極體電壓為250kv 、阻抗為150的情況下得到了超輻射狀態下輸出微波峰值功率為100mw 、中心頻率為38ghz 、模式為tm _ （ 01 ）模的微波輻射。
  6. The equivalent cavity model is used to deduce the threshold condition of the ecld, and the expression of the threshold carrier density n ( v ) when ecld is tuned to oscillate at different frequencies has been obtained. using the expression of n ( v ) and the carrier dependent refractive index, the simple basic equation describing the bistable characteristics has been derived after choosing an appropriate reference frequency nf

    通過建立等效腔模型來推導外腔半導體激光器的閾值條件，得到ecld在不同頻率v振蕩所需的閾值載流子密度n （ v ）表達式，利用該表達式及相關的折射率表達式，在選擇合適的參考載流子密度n _ f后，導出了一個描述雙穩所需的基本方程。
  7. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
  8. Analog temperature compensation crystal oscillator ( atcxo ) is widely used in electronic equipments such as communications, navigation, radar, mobile telephone, program control telephone, measure instruments etc. as their reference frequency source, it is critical part of the above equipments, called as their “ heart ”

    模擬溫度補償晶體振蕩器（ atcxo ）廣泛應用於通信、導航、雷達、移動通信、程式控制電話、測量儀器等電子設備中。作為基準頻率源，它是上述電子設備的關鍵部件，被稱為此類電子設備的「心臟」 。
  9. This paper realized frequency modulation using the video signal to directly control the resonance loop ' s diode of the vco at the early stages, and then through using radio frequency bipolar junction transistor, designed a lc voltage controlled oscillator which was emulated by advance design system. in addition, it also implemented the design and debugged the hardware circuit

    本文第一次實驗採用視頻信號直接控制vco諧振迴路變容二極體的方式實現頻率調制，並且利用射頻雙極性晶體管（ bjt ）設計了一種lc壓控振蕩器，通過ads軟體進行了參數模擬，最後進行了硬體電路的製作和調試。
  10. Output window is the core of the gyrotron, which speciality can decide the speciality of the gyrotron greatly. the major subjects of output window design for high power gyrotron are to reduce the reflection and absorption power in order to enhance the gyrotron ’ s stability and protect the output window

    如果窗片的反射升高，在高功率情況下返回到高頻系統的功率將顯著上升，引起寄生模式在高頻系統中自激振蕩，從而降低迴旋管的高頻輸出功率和模式純度，乃至於使迴旋管不能正常穩定工作。
分享友人
分享到 Line

分享到臉書