振量法 的英文怎麼說
中文拼音 [zhènliángfǎ]
振量法
英文
oscillometry-
Magnetoelectricity gear method is a general torsional oscillation measurement method. it has disadvantages on less measure point and improved - needed dynamic characteristic. in the paper a new method of measuring torsional oscillation of the turbine - generator shaft was proposed on the basis of high speed ccd ( charge coupled device ) photography
現行的扭振測量方法以磁電式齒輪測量法為主，這種方法存在測點少，動態特性有待提高的缺點，就此本文提出了一種基於高速ccd （ chargecoupleddevice ）攝像技術的汽輪發電機組軸系扭振測量的新方法。Methods for the calibration of vibration and shock transducers - primary shock calibration using laser interferometry
振動和沖擊傳感器的校準方法.採用激光干涉測量法的主要沖擊校準Textile fibres - determination of linear density - gravimetric method and vibroscope method
紡織品.線密度的測定.重量法和示振儀法By the result of these experiments, acoustic emission ( ae ) was chosen to use in the research. at the same time, we analyse the phenomenon of acoustic emission at the base of theory, the characteristic signal of acoustic emission which comes from the faulty bearing at the angle of application, and the expression of the characteristic signal. contrast was also made on the data achieved separately from vibrational signal and ae signal, and it is proved that ae is feasible and available to the diagnosis to the fault of the rolling bearing
主要工作有如下幾方面：對本段前期實驗室階段採用的振動法幅值域無量綱處理進行了分析，並研製了現場所使用的滾動軸承故障檢測裝置，將無量綱參數診斷法應用於段修現場，且做了大量試驗；對于現場試驗中所出現的問題進行了分析，提出將聲發射的方法用於軸承的在線故障診斷；從理論上分析了聲發射現象，從應用的角度分析故障軸承的聲發射信號的特徵以及聲發射信號特徵的表示方法，並在實驗室中，採用振動法和聲發射法實時檢測的實驗數據進行了對比和分析，證明了使用聲發射法對軸承故障檢測的可行性和有效性。At present, surge control method for centrifugal compressor being used is commonly by least - flow method. it can ’ t make compressor working within operating condition area, sometimes starts the surge control system earlier, which will waste energy sources and depress economy benefit. even, its control system commonly consists of simulation instrument, can ’ t modify the changing surge curve of compressor in time and can ’ t control nonlinear surge curve preferably
目前，在用的離心壓縮機的防喘振方法一般採用最小流量法，它不能充分使壓縮機工作在其工況區，往往過早起動防喘振系統，浪費了能源，降低了經濟效益。且控制系統一般採用模擬儀表構成，在壓縮機的喘振線發生變化時不能及時修正，對非線性的喘振線不能較好的實施控制。The result of the experiment shows that the proposed forced vibration method device has the quality of stability and repetitiveness of the data, the wide range of the testable reduced velocity, the exactness of coupled and direct flutter derivatives. and it does not need to employ any complicated identification system to check it further
結果顯示：本文提出的強迫振動法裝置具有試驗數據穩定、數據重復性好、可測量的折減風速范圍寬、交叉項導數與對角項導數具有同等精度和不需要復雜的系統識別過程等一系列優點。Then the dynamic behavior analysis and harmonically excited transient response analysis are conducted. the time increment method achieves the nonlinear discretized dynamic equations
接著進行了懸索的動力特性分析和簡諧激振的瞬態響應分析，利用增量法實現了離散化的非線性動力方程組的迭代求解。We research on the thermal buckling characteristics of double layer membrane which is composed of different materials with different thermal expansion coefficiens under uniform temperature elevation. the energy method is proposed which is used to solve the problem and the symbolic relation between central buckling height and substrate height under small buckling height is also given. it is the primary theory of membrane resonant sensor, which makes the research and development of novel thermal sensor possible
本文對微機械中熱脹系數不同的材料構成的雙層復合薄板在均勻溫升下的撓曲特性進行了研究，提出了在均勻溫升下雙層薄板熱撓曲求解的能量法，並給出了小撓度下中心撓度與板厚的解析關系，為薄膜諧振式傳感器溫度特性的研究和新型溫度傳感器的設計與開發打下了基礎A monte carlo algorithm was presented to model the relation between the scattering phenomenon, depolarization changes and sea water depth, it is discovered that the radius of scattering point and the degree of depolarization increase with increasing of the sea water depth. at last, a optical engineering software ( lighttools ) is introduced to simulate optical scattering in the deep sea water, and studys the corelation between scattering and relative refractive index, particle density and particle size in the sea water. the experiment results show that the intensity of scattering will increase evidently with the increasing of particle size, particle density and relative refractive index. the methods and results in the article provide the basic theory and experiment validation for improving performance of communication, detection and imaging under sea water
本文以球形粒子的mie散射理論、 stokes矢量法以及mueller矩陣來研究海水的散射特性和散射中的退偏振度變化;通過montecarlo方法模擬藍綠激光在海水傳輸過程中的散射現象以及散射中的退偏度變化與海水深度的關系，發現隨著海水深度的增加，散射后的光斑半徑、退偏振度將逐漸增大。最後通過光學工程軟體（ lighttools ）對海水中的散射進行模擬實驗，研究散射與海水中粒子密度、粒子大小和相對折射率的關系。實驗結果表明，隨著粒子半徑、粒子密度和相對折射率的增加，散射的強度將顯著增加。Acoustics - determination of sound power levels of noise sources using vibration velocity - measurement for seal machinery
聲學振速法測定噪聲源聲功率級用於封閉機器的測量An application of vibration reed to intelligent measurement system of young ' s modulus
舌簧片振動法在楊氏模量智能測量系統中的應用Based on analyzing the circumstance factor that influence the qualitative change of the nuclear material of uranium and plutonium during their stockpile, nuclear materials detection technology with nmr method was discussed, and at the same time, moisture measurement the water molecule moving rule in nuclear materials during their stockpile were also studied with the same method in this paper
在分析環境因素對鈾、鈈核材料貯存期間品質變化影響的基礎上，探討了核磁共振方法對核材料進行探測的技術，研究了核材料貯存中濕度的測量和水分子的遷移規律。The dissertation refers to comparatively full literatures in the field of vsc, and the development history and characteristics of vsc are summarized, and the elementary concepts, elementary definitions, elementary properties, elementary principles and design methods are particularly introduced, and the causes of the chattering phenomenon are systematically analysed, and the study status of the chattering phenomenon and the main methods to eliminate the chattering are elaborated. for the deficiencies of traditionary methods, three improved methods are developed, which are improved exponent reaching law solution, variable boundary layer solution and the solution by adding an auxiliary continuous control term. for uncertain linear systems, an adaptive fuzzy integral variable structure control stategy ( afivsc ) is put forward to eliminate the chattering around the sliding plane, which introduces fuzzy logic to soften the non - linear discontinuous sig nal in the control variable and utilizes adaptive theory to adjust output membership function according to how much the uncertainty of the system is
比較全面地查閱了關于變結構控制理論的文獻，總結了滑模變結構控制的發展歷史和特點，詳細介紹了變結構控制的基本概念、基本定義、基本性質、基本原理以及設計方法；系統分析了變結構控制系統抖振產生的機理，並闡述了國內外目前對抖振問題的研究現狀以及消除抖振的主要方法；針對傳統抑制和消除抖振方法的不足，改進了傳統方法，得到了三種新的消除抖振的方法? ?即改進的指數趨近律法、可變邊界層法和附加連續項法；針對不確定性線性系統，在變結構控制策略中引入模糊邏輯和自適應理論來消除滑動平面上的抖振，提出了一種自適應模糊積分變結構控制方案（ afivsc ） ，利用模糊邏輯來柔化控制量中非線性不連續部分，採用自適應理論，根據系統不確定性大小在線調整模糊輸出量的隸屬函數，另外，鑒于模糊控制本質上是有靜差的，所以本文選擇了帶積分項的切換函數，由於積分項的存在使系統較正為無靜差系統。Method for measuring amplitude by a wedge gauge
量楔測振幅法Finally, we put forward a method to compensate the amplitude and phase of the input. mom is an effective method to analysis the thin dipole
論文的主要工作:矩量法是一種分析細線對稱振子天線準確而有效的方法。By means of the theoretical analysis of the micromachined vibratory rate gyroscope, we get following conclusions : the microgyroscope can be driven by tangent electrostatic force produced by fence structure electrodes, and the normal electrostatic force can be neglected for the influence of the device property ; the parasitical capacitance and fringing effect can ’ t be neglected for the calculating of the detection capacitance ; the coefficient of damping force is comparatively little when the air damping in the driving mode and the sensing mode of the device is the couette flow damping
主要內容如下: 1 .分析了微機械陀螺的運動特性、靜電驅動特性和在大氣下的阻尼特性，分析結果表明，可以運用切向靜電力驅動質量塊振動，法向靜電力對器件特性的影響可以忽略;在計算微結構電容時，電容的邊緣效應和寄生電容不可忽略;在器件所受阻尼主要為庫埃特流阻尼的情況下，阻尼力系數較小。Calibration of vibration and shock pick - ups - methods for primary vibration calibration by laser interferometry
振動和沖擊傳感器的校準.採用激光干涉測量法對主振動的校準方法Analysis on the coupling dynamic model of piezoelectric resonator of ultrasonic motor based on energy method
基於能量法的超聲電機壓電振子的耦合動力學模型分析Mechanical vibration - vibrotactile perception thresholds for the assessment of nerve dysfunction - part 1 : method of measurement at the fingertips
機械振動.評定神經功能障礙用振動感知閾值.第1部分:指尖測量法The compute model of shafts of the machines is built by adopting concentrated mass method. taking into account the different support conditions of the shafts that workshop is considered as rigidity or elasticity ; the natural characteristic and unbalanced response of the shafts are computed by integrating with high stable riccati transfer matrix method
採用集總質量法對機組軸系建立了計算模型，並結合穩定性良好的riccati傳遞矩陣法，分別考慮機組軸系的支撐基礎（廠房）為剛性、彈性兩種情況，計算了機組軸系的自振特性、軸系的不平衡響應。分享友人