挺度 的英文怎麼說

中文拼音 [tǐng]
挺度 英文
stiffness
  • : Ⅰ動詞1 (伸直或凸出) stick out; bulge or protrude; straighten up 2 (勉強支撐) stand; hold out;...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  1. Performance and useness : right grammage and thickness, smooth surface, high whiteness, high deflexion, low dirt count, good print ability. wide used for print books, color insert, brand, account paper and product catalogue, etc

    部優產品性能用途:定量厚薄一致,表面平整細膩,白挺度好塵埃少,具有良好的適印性能。
  2. Textile glass. determination of stiffness of rovings

    紡織玻璃纖維.粗紗硬挺度的測定
  3. Through experiment and analyzing the changes of the thickness, rigidity, tensile strength and the opening rate of the conduits caused by the different kinds of coating material, the thickness of the coating and the different braiding structures, we investigate the physical and mechanical, properties of the braided conduits. the results show : the chitosan is easy to form the film structure on the surface of the conduits increasing the conduits ' rigidity clearly ; the rigidity and opening rate of the braided structure with inserted reinforcing yarn are better than the others, this will prevent the conduits collapsing and distorting effectively in the practical uses, so we select conduits of this structure for animal experiment

    在導管的物理機械性能研究方面,本課題通過塗層劑的種類( pgla丙酮溶液和甲殼胺漿液) 、塗層劑的厚、導管的編織結構三個方面分析它們對導管的厚、硬挺度、拉伸強力和孔隙率等性能的影響。測試結果顯示:甲殼胺塗層易於在導管表面成膜,對導管的硬挺度有明顯提高,塗層效果較好;加筋結構神經導管在硬挺度和孔隙率方面優于其它導管,能有效防止導管在實際應用中的塌陷變形。
  4. Paper and board - determination of resistance to bending

    紙和紙板挺度的測定
  5. Paper and board - determination of resiseance bending

    紙和紙板挺度的測定
  6. Paper and board - determination of bending stiffness - resonance method

    紙和紙板彎曲挺度的測定法
  7. Standard test method for stiffness of fabric by the circular bend procedure

    用圓形彎曲法測定織物挺度的標準試驗方法
  8. Paper and board tests. method to determine the stiffness of paper and board by static bending

    紙張和紙板試驗.紙張和紙板靜態彎曲挺度測定方法
  9. Iso 9969 : 1994 ; thermoplastics pipes - determination of ring stiffness iso 9969 : 1994 ; german version en iso 9969 : 1995

    熱塑塑料管.環壓挺度的測定
  10. Stiff arc, with heat concentrated, easy to fill welding wire, so especially suitable for wire filling welding in bicycle area

    電弧挺度好,熱量集中,填絲容易,特別適宜自行車等行業的填絲焊接。
  11. Patent control technology of dynamic characteristics and waveform, hard arc, stable welding current, little spatter, good welding surface, optimized matching parameters, welding speed increased by 100 - 200 %

    專利動特性及波控技術,電弧挺度大,焊接過程穩定,飛濺少,成型美觀,優化參數匹配,焊速可提高100 - 200 %
  12. You can adjust the flow in accordance with the applied welding current to save gas, but if the flow is too small resulting in the insufficient stiffness of the protecting gas, the welded point will not be covered completely

    為節約氣體,你可以根據不同的焊接電流工況選擇不同的流量,但過小的流量可能導致保護氣體挺度不夠,不能全部覆蓋焊點。
  13. Bituminous mixtures - test methods for hot mix asphalt - part 26 : stiffness

    瀝青混合物.熱混瀝青的試驗方法.第26部分:硬挺度
  14. Specification for compression, stiffness and labelling of anti - embolism hosiery

    抗栓塞襪類的壓縮硬挺度和標記規范
  15. Rotational - lateral stiffness test method for beam - to - panel assemblies

    梁板組件的側面轉動硬挺度試驗方法
  16. Standard test method for determining thermoplastic pipe wall stiffness

    測定熱塑管壁硬挺度的標準試驗方法
  17. Standard test method for measuring stiffness and apparent modulus of soil and soil - aggregate in - place by an electro - mechanical method

    用電動機械法測量土壤和土壤集料實體的硬挺度和表觀模數的標準試驗方法
  18. Methods of testing doors. test for the change in stiffness of the door leaves by repeated torsion

    門的檢驗方法.通過反復扭轉檢驗門扇硬挺度變化
  19. Standard test method for stiffness of fabric by the blade slot procedure

    切口法測定織物硬挺度的標準試驗方法
  20. Standard test method for determining stiffness of geosynthetics used as turf reinforcement mats

    測定用做草地增強墊層的土工合成物硬挺度的標準試驗方法
分享友人