掃描狀態 的英文怎麼說

中文拼音 [sǎomiáozhuàngtài]
掃描狀態 英文
scanning mode
  • 掃 : 掃構詞成分。
  • 描 : 動詞1. （照底樣畫） copy; depict; trace 2. （在原來顏色淡或需改正之處重復塗抹） retouch; touch up
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. The silt particles shape and its floccules configuration is observed by tem and sem

    利用透射電鏡、掃描電鏡觀測了泥沙的顆粒形狀、泥沙絮體形態。
  2. The cuticular membrane in the species of physochlaina is simultaneously striate, granular and scaly, while only striate, or occasionally granular in the species of hyoscyamus. 2. seed morpholoy seed morphology of 25 species in seven genera of the tribe hyoscyameae and three related genera was investigated under sem for the first time

    種子形態學在掃描電子顯微鏡下首次全面研究了天仙子族及顛茄屬和茄參屬等共10屬25種植物的種子形態學特徵，結果表明：該族植物種子表面紋飾有腦紋狀或近腦紋狀和網狀兩大類，除了山莨菪屬anisodus和hyoscyamus
  3. It combained potentiostat, potentiostatic circuit instrument and ac impedance measurement organticace, which can measure usual dynamic potentio - scan, experiment of dynamic potentio - scan, but also unique measurement of ac impedance measurement, also, this new type electrochemical workstation can carry on complex experiment, sucn as potentio / current scan ac impedance measurement procedural measurment, life - span - circle ac impedance measurement procedural measurement in order to fullfill the goal of track and analysis of parameter in various electrochemical conditions. this graduation thesis indicate the structure, function of the multifunct - ional electrochemical workstation

    它把恆電位儀，恆電流儀和電化學交流阻抗分析儀有機地結合到一起，既可以做常規的基本測試如動電位掃描、動電流掃描試驗和電化學交流阻抗測量，也可以做基於這三種基本試驗的程式化試驗，如恆電流充電-電化學交流阻抗測量，電池壽命循環試驗-電化學交流阻抗測量試驗，從而完成多種狀態下電化學體系的參數跟蹤和分析。
  4. In the present dissertation, friction - induced noises emitted by a flat specimen rubbing against another flat specimen or a ball specimen under reciprocating sliding are studied. the detailed observation of the scars is conducted by means of a scanning electrical microscope ( sem ), laser scanning microscope ( lsm ), optical microscope and profilometer. the dynamic state variables are analyzed in detail using the discrete wavelet transform

    使用電子掃描顯微鏡（ sem ） 、激光掃描顯微鏡（ lsm ） 、光學顯微鏡和表面輪廓測量儀等設備對摩擦噪聲發生的區域進行了詳細的觀察和分析，運用小波變換技術對摩擦噪聲狀態下的動力學變量進行了深層次的研究，應用matlab simulink語言對摩擦系統進行了振動動力學模擬，系統地研究了摩擦噪聲的形成機理。
  5. On the backgrounds of researches inside and outside country, and cooperating experiments with theories analyses, the influence of different processing technology parameters and different sbs modifier sorts on the sbs modified asphalts " properties has been studied. at the same time, their microstructure are observed through fluorescence optical microscopy and scanning electronic microscopy, thus to direct modified asphalt production. on the above conclusion ' s basement, analysing some disadvantages of the storage stability test of sbs modified asphalt in the current specification, a new storage stability test apparatus is developed

    本文在參考國內外研究的基礎上，採用理論、試驗相結合的方法，研究加工工藝參數以及改性劑種類等對sbs改性瀝青性能的影響，並通過熒光顯微鏡、掃描電鏡分析其微觀形態，從而指導sbs改性瀝青的生產；在此基礎上，分析我國現行規范用來評價sbs改性瀝青儲存穩定性方面的不足，開發了新的試驗儀，根據動態剪切流變試驗結果和微觀狀態分析，提出一個新的指標? ?離析率r _ s來評價sbs改性瀝青的儲存穩定性；最後，針對不穩定的改性瀝青提出改善措施，研究證明摻加增容劑和穩定劑是行之有效的方法。
  6. It is an up - to - date intelligent measuring calibrator. the instrument has the preset unctions o scanning requency, mode, multipoint scanning, and power o protection

    該儀器為新一代智能化測校驗設備，具有預置掃描速率、狀態、多點、掉電保護等功能。
  7. Study on branchlet surface sculpture does not reveal any hair - like structures as recorded by previous authors ; only some warty cuticles on the ridges and variable stomata in the grooves are noted. the surface of synangium in ephedra has secondary sculpture while the lip of the openings of synangium resembles the cerebral waves

    對小枝表面掃描電鏡下的微形態構造的研究並沒有發現前人報道的毛狀體特徵，而只有一些疣狀角質突起和有變異的氣孔，同時注意到，麻黃屬植物的小枝表面特徵受到生境、發育階段的影響。
  8. Once the scanned host returns a syn ack packet, the connection will go into a pending state on the server side, indicating that the connection is in the process of being established, but is not fully established yet

    在被掃描主機返回了syn / ack包后，連接在服務器端將進入掛起狀態，表明連接正處于建立的過程中，但還沒有完全建立。
  9. This study was focused on the occurrence characteristics of the cryptomelane - bearing ores and the mineralogical characteristics of natural cryptomelane. the morphology, chemical and structure features of natural cryptomelane were characterized by means of powder x - ray diffraction, scanning electron microscopy, electron probe microanalyzer, energy dispersive spectrometer and x - ray fluorescence

    利用x -射線粉晶衍射掃描電鏡電子探針電子能譜和x熒光光譜對天然錳鉀礦的形貌特徵化學成分結構特徵進行研究，結果表明天然錳鉀礦晶體形態主要為針狀纖維狀，沿
  10. The photograph of sem showed that its surface have homogenously coated with nickel, although the hollow glass beads were crashed by agitation and heating. after pretreatment and nickel plating, the dispersity of mica powders evidently improved and the infrared emissivity decreased from 0. 85 to 0. 43, and has certain wave absorbability of radar

    對雲母的化學鍍鎳工藝研究中，發現經過預處理后雲母表面獲得了鎳層，通過掃描電鏡分析，鍍鎳后雲母的分散性提高，表面狀態發生了較大的變化，法向積分發射率顯著降低，由0 . 85降低為0 . 43 。
  11. The main results show that : ( 1 ) the mechanism of laser bending is very different from that in bending with hard tools. ( 2 ) the bending angle is varied along scanning direction, and there is a deformation wave in the process. ( 3 ) the effects of sheet length on bending can be neglected while the length is more than 10 times of thickness. ( 4 ) the sheet width has much higher influence on the bending process

    分析發現：激光彎曲成形時板料的應力狀態與機械折彎時有根本不同；當激光束沿直線單向掃描時，板料兩端的彎曲角度不同；板料的長度大於10倍板厚或5倍光斑尺寸時，板長對彎曲角度的影響不再顯著；沿掃描方向，距離光斑中心3倍光斑尺寸以外的區域，仍然對彎曲變形量產生影響。
  12. In order to discuss the friction and wear mechanisms of mos2 nanoparticles, it was analyzed that the chemical status of elements existed on the rubbed surface by x - ray photoelectron spectroscope, and it was observed that the surface topography of wear zone by scanning electron microscope

    通過x射線光電子能譜儀（ xps ）分析磨痕表面元素的化學狀態，掃描電子顯微鏡（ sem ）對磨痕的表面形貌進行分析，從而總結了納米二硫化鉬在n46機械油中的摩擦磨損機理。
  13. By contrasting the dimension and appearance of fe of different precursors, verified it is true that the dimension and appearance of precursor affect these facets of fe. modern measures, for instance xrd, tem, sem, laser and infrared technique etc. are used to research the technique indexes of sfp of fe, such as crystalline, dimensions and its distribution, shape and appearance, assemble status and its oxygen content

    對所制備的超微fe粉，採用x射線衍射法（ xrd ） 、透射電鏡法（ tem ） 、掃描電鏡法（ sem ） 、激光衍射粒度分佈測定法以及紅外測氧法等現代分析測試手段，詳細考察了超微fe粉的晶態、尺寸、粒度分佈、形貌與團聚狀態、氧含量等多項技術指標。
  14. The mechanical modifying equipment was used to prepare compounded micro - spheres from pmma particles and ps particles with metal particles and tio2 nano - particles. the sem was used to observe the images of particles and x - ray photoelectron spectroscopy ( xps ) is used to obtain surface spectrum. herein the tio2 nano - particles can be dispersed on larger polymer particles and their surface morphology is different by using different polymer particles

    使用掃描電鏡和光電子能譜對制得的復合微粒子進行表徵，發現該方法可以使納米tio _ 2粒子呈很好的分散狀態復合在聚合物微球及金屬粒子上，而且隨著聚合物微球原料的不同，納米tio _ 2粒子能在高聚物的表面的復合狀態也不同。
  15. By making a systematic study on botanical and morpholigical to the 6 species, a few characteristics have been summarized for identification. with the method of tissue clearing and scanning electron microscope, the characteristic of oil cell of leaves and the micromorpholocal characteristic of fruit surface were found to be quite well differentiated and to have taxonomic value. by investigating the source of fructus listeae in sichuan, guizhou and hunan province, we found that the fruits of l. mollis hemsl are the main current species

    對上述6種木姜子屬藥用植物進行了較系統的形態學研究：包括對植物形態、藥材性狀及顯微特徵的比較，總結出種間鑒別特徵；採用組織透明法對葉片中油細胞的形態及分佈進行研究發現， 6種植物葉片油細胞的分佈差異較大，種間鑒別特徵顯著；首次採用掃描電子顯微鏡對木姜子屬植物果實的微形態進行比較研究，發現不同種的果皮紋飾具有明顯差別，從而為種間鑒別提供了微形態學的證據。
  16. Inquiry scan state

    查詢掃描狀態
  17. This paper introduces the general design method of soc ( system on a chip ) using eda tools, gives some cases of ip, then implement a real system on epm7128slc84 - 15, a chip of altera company, this system including : scan and recognition of matrix keyboard, calculation of add, sutu multiply under the control of state machine, the display of result on computer screen

    本文首先介紹了用eda工具設計片上系統的一般方法，給出了幾個ip ，然後在altera公司的晶元epm7128slc84 - 15上實現了一個soc實例，該實例包括：對矩陣式鍵盤的掃描、識別，在狀態機控制下進行加、減、乘法運算，以及結果在計算機屏幕的顯示。
  18. Observation of perfusion of cerebral blood flow and metabolism of brain cells in transient ischemic attack patients with single photon emission computerized tomography

    單光子發射計算機斷層掃描符合線路顯像觀察短暫性腦缺血發作間期患者腦血流灌注及腦細胞代謝狀態
  19. 2. while scanning and minimize the window, a tool window scan status will be showed above all nontopmost windows. 3. you can stop scan using menu command

    .當你掃描文件並最小化窗口時，一個掃描狀態的工具條會始終顯示在計算機上方，便於用戶掌握掃描進
  20. Page scan state

    尋呼掃描狀態
分享友人
分享到 Line

分享到臉書