掏槽爆破 的英文怎麼說

中文拼音 [tāocáobàopò]
掏槽爆破 英文
aump shot
  • 掏 : 動詞1 （拿出; 取出） take out; fish out; draw out; pull out 2 （挖） dig （a hole etc ）; hollow ...
  • 槽 : 名詞1 （盛牲口飼料或飲料等液體的器具） trough; manger （for water animal feed wine vat） 2 （兩邊...
  • 爆 : 動詞1. （猛然破裂或迸出） explode; burst 2. （放在滾油里快炒） quick-fry
  • 破 : Ⅰ動詞1 （完整的東西受到損傷） be broken; be damaged 2 （使損壞） break; break down; damage 3 （使...
  • 爆破 : blow up; blast; burst; demolish （by explosives）; detonate; explode; dynamite
  1. The loosening holes outside the plough cut are also drilled at an angle which improves the breakage possibility.

    在楔形掏槽眼外側的擴槽眼也要有角度以改善爆破效果。
  2. The norwegian cut can provide more dependable advance per round than the plough cut.

    挪威掏槽與楔形掏槽相比，可以提供更可靠的每次爆破的進度。
  3. Study on blasting mechanism and its engineering use of spiral cutting with big empty hole in rock under - excavation

    巖石工程大空孔螺旋掏槽爆破機理研究及應用
  4. Analyses of rational stemming length for burn - cut blasting

    直眼掏槽爆破炮眼合理堵塞長度的理論分析
  5. Application of staged burn - cut in shaft blasting in limestone

    分層分段直眼掏槽在石灰巖井筒爆破中的應用研究
  6. Researches on blasting parameters of triangle burn cut

    三角柱直眼掏槽爆破參數研究
  7. Dynamic caustics experiment of cut hole control blasting

    掏槽控制爆破動焦散試驗研究
  8. Study on the factors affecting parallel hole cut blasting

    直眼掏槽爆破效果的影響因素分析
  9. A model for analysis of the blasting effect of parallel cut

    含空孔直眼掏槽爆破效果分析模型
  10. Deep hole v cut blasting technology for tunnel excavation

    深孔楔形掏槽爆破技術在隧道掘進中的應用
  11. The grey situation method of optimizing cutting blasting plan of rock roadways

    優選巖巷掏槽爆破方案的灰局勢方法
  12. Application of cut blasting in trench digging technique in the middle of the stope

    掏槽爆破在采場中部掘溝工藝中的應用
  13. Parallel cut blasting

    直眼掏槽爆破
  14. Research and application of the cutting blasting technology of roadway excavation in hard rock

    堅硬巖石巷道掏槽爆破技術研究與應用
  15. Numerical simulation research of charging optimization in spiral cutting blasting in medium deep bore

    中深孔掏槽爆破裝藥優化的數值模擬研究
  16. In order to solve the shortcoming of traditional explosion w ; dge - shaped excavation in da ' anshan mine, improve the rate of excavation and reduce the consumption of explosive materials, a series of excavation shapes are applied and experimented in the rock tunnel excavate

    針對大安山煤礦傳統的楔形掏槽爆破方式存在的弊端，本文提出在該礦進行新型掏槽實驗研究，用以增加巖石巷道掘進效率和減少掘進爆破材料消耗。
  17. Based on the theory of detonation dynamics and fracture mechanics and combined with engineering experiences, the parameters of soft rock tunnel hole charge and smooth blasting are analysized to enhance tunnel excavation proficiency in soft rock and smooth blasting. value scope of smooth blasting is acquired, which can give some experience for parameters design and construction of smooth blasting in soft rock tunnel excavation

    摘要為提高軟巖巷道掘進效率和光爆效果，利用爆轟動力學和斷裂力學理論，分析了軟巖巷道掏槽及光爆參數，結合工程實踐經驗，得出了軟巖巷道光面爆破參數的取值范圍，對軟巖巷道爆破參數的設計和施工具有一定的指導意義。
  18. Optimization of cutting holes layout for the blasting of roadway excavation at a certain metal mine

    某金屬礦巷道掘進爆破的掏槽孔布孔優化
  19. In the conglomerate tunnel excavation, the semi - diamond shape can obtain high explosion rate, and the rate is up to 85 %

    對于礫巖巖石巷道掘進，採用似菱形掏槽形式其爆破效果良好，爆破效率達到85 %以上。
  20. Abstract : the application of cut blasting of the middle of the stope in ekou iro n mine was introduced, a set of practical blasting parameters were achieved and good blasting effect was obtained

    文摘:介紹了采場中部掏槽爆破在峨口鐵礦的應用，並得出了一組切合實際的爆破參數，取得了較好的爆破效果。
分享友人
分享到 Line

分享到臉書