接合梁 的英文怎麼說

中文拼音 [jiēgěliáng]
接合梁 英文
fished beam
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 梁 : 名詞1 （屋架中架在柱子上的長木） beam 2 （通常也指檁） purlin 3 （橋） bridge4 （物體中間條狀隆起...
  • 接合 : joint; zygosis; juncture; articulation; concrescent; nexus; coaptation; syndesis; synapsis; meet;...
  1. The system is composed with concrete filled cold - formed square steel tube column, the beam with two cold formed c type steel welded together back to back, the slab with profiled - steel and concrete, the beam and the slab joined into composite steel - concrete beam. they all together make up of the bearing members. and the house also includes the light economical - energy sources heatproof walls

    該體系是以冷彎薄壁方鋼管混凝土為柱、冷彎薄壁c型鋼背靠背高頻焊接組成工字型梁、壓型鋼板上現澆築混凝土組成組合樓板並與梁一起構成組合梁作為承重構件，以輕質節能保溫型墻體作為圍護結構組成。
  2. The cross - piece is mortised into the upright post

    橫梁和立柱是用榫眼接合一起的
  3. The experimental study of twelve push - out specimens with different hole molds and different materials filled in holes and two composite steel - fdpcp ( full - depth precast concrete panels ) beams of a full shear connection and different hole mold, as well as a composite steel - fdpcp beams of a partial shear connection and square holes was conducted in this paper, the authors gain following results : three composite steel - fdpcp beams all have good composite action and perfect work behaviors as a whole and the composite steel - fdpcp beams is a new - style structure which should get further research and development

    摘要對12個不同預留孔形、孔內不同填充材料的推出試件及2根不同預留孔形的完全剪力連接與1根部分剪力連接的鋼混凝土預制板組合梁進行了試驗，結果表明，只要預留孔形設計合理，灌孔混凝土強度得當，鋼混凝土預制板組合梁就具有良好的組合效應和整體工作性能，是一種有發展前途和廣泛應用領域的新型組合結構。
  4. During calculation of the ultimate flexural capacity of composite beams, it assumes steel beam, concrete board and connecter are plastic, calculates them by ultimate equilibrium method

    在組合梁受彎極限承載力計算中，認為鋼梁、混凝土板和連接件完全塑性，採用極限平衡法計算。
  5. ( 3 ) it is known that load effect is not consistent with the section resistance incommon section continuous composite beam. a kind of composite beam with itsrational section size is suggested, which is consist of the t shape concrete beam andsteel girder. this kind of composite beam not only has enough carrying capacity, almost has same positive and negative resistance moment, but can decrease theamount of the steel

    （ 3 ）分析可知連續組合梁的跨中、支座截面處荷載作用效應及截面抗力規律不匹配，本文提出了採用t形混凝土梁和工字鋼代替一般的混凝土板和工字鋼的組合梁截面形式，並給出了截面尺寸比例，能使正負截面抵抗矩接近，符合組合梁受力特徵，減少了材料用量，滿足承載力和剛度等要求。
  6. ( 2 ) based on the existing theory of lateral load distribution rule, and combined the structure characteristic of pre - stressed lager cantilever composite beam with corrugated steel webs, this thesis proposed the modified rigid beam method. taking this method, it is facilitated to compute the lateral load distribution factor of bearing composite cantilever beam with variable - stiffness under the load in arbitrarily position

    （ 2 ）以現有的橫向分佈理論為基礎，結合大懸臂波形鋼腹板組合挑梁的結構特點，提出了修正剛接梁法的計算方法，能夠方便地計算變剛度懸臂組合梁任意點位的橫向分佈系數。
  7. In this paper, the structural types and features of the joint parts and the latest development of the design technique for the parts are dealt with

    而混合梁接合部設計是關鍵技術問題之一，為此介紹了接合部的構造形式、結構特性以及設計技術的新發展。
  8. The result proves that composite beams with partial shear connectors have better performance to support fatigue load in that they can hardly be destroyed under general fatigue load if the welding quality is reliable

    試驗結果表明，重復荷載作用下的部分剪力連接組合梁具有良好的抗疲勞性能；在焊接質量有保證的情況下，處于正常使用范圍內的疲勞荷載作用下的部分剪力連接組合梁幾乎不會發生疲勞破壞。
  9. Analysis of slip property in steel - concrete composite beams and fem improvement

    組合梁滑移特性分析及連接單元改進
  10. Though investigation, it puts forward the formulas to slip strain and slip of the simply supported composite beams, establishs formulas of the carrying capacity, curvature and deflection to composite beams with partial shear connection, finds out relationships between shear connection degree coefficient and them. it can develop benefit of technology and economics in design to adjust the shear connection degree

    通過理論分析，本文提出了簡支組合梁滑移應變、滑移的計算公式；推導了簡文組合梁考慮滑移效應的承載力、曲率和變形的計算公式；得出了它們與剪力連接程度系數的關系，通過調整剪力連接程度可以提高組合梁設計的技術經濟效益。
  11. In addition, the calculating methods about the gap of the connectors and the maximum width of crack are discussed in the thesis

    另外，作者對組合梁剪力連接件的設計理論及組合梁最大裂縫寬度計算方法作了逐一地探討。
  12. Then calculate the member individually, including the calculation of load - behavior capacity, the calculation of high strong bolt with the method of connection with beam, the design method of stiffening rib, etc. the text educed the above - mentioned formula theoretically. 5. linking with windmill flat engineering example in the third youth flat engineering of yi zhuang development area, beijing, it and steel frame constitute the steel frame ? steel shear wall with slit system respectively are analyzed the whole structure by ansys and satwe

    既利用剛度等效的原則，把其轉換為工程計算軟體可以計算的支撐體系，然後對構件進行單獨計算，包括承載力的計算、和梁接合方法? ?高強螺栓的計算、加強肋的設計方法等內容； 5 、帶縫鋼板剪力墻與鋼框架形成鋼框架? ?帶縫鋼板剪力墻結構體系，結合北京亦莊經濟開發區青年公寓三期工程中的風車公寓工程實例，分別採用ansys和satwe進行了結構整體分析，兩者的計算結果相吻合。
  13. Though great progress has been achieved on researches on the design theory, structural type, structure details and construction method of the composite bridge, there are still many problems, such as crack control of the concrete deck, influence of the connecting rigidity over the structural mechanical characteristics and mutual depende ncy between design and construction, need deeper researches for better solutions

    對組合結構橋梁的設計理論、結構形式和構造細節、施工方法等方面的研究已經取得了很大進展，但仍然存在許多問題需要深入研究和完善，例如：混凝土板裂紋控制、接合剛度對結構受力性能的影響、設計與施工的依存性等。
  14. To these problems, this paper researchs on the slip property of the simply supported composite beams of steel and concrete with partial shear connection, based on the concepts of the slip strain and the slip

    針對上述問題，本文從滑移應變和滑移的基本概念入手，對部分剪力連接簡支組合梁的滑移性能進行了系統分析。
  15. Abstract : this paper introduces the calculating methods, develops procedures in the research of the slip and lift displacement on the composite beam of steel and concrete, which lay foundation for the design of the composite beams

    文摘:介紹鋼與混凝土組合梁計算分析方法，建立其分析單元模型，研製計算分析程序，研究鋼與混凝土組合梁交接面的滑移、豎向掀起位移及連接件剛度變化對其影響等工作性能，為鋼與混凝土組合梁設計提供理論依據
  16. A high degree of continuity can be achieved just providingthe slab with rebar running along the column. furthermore, stiffness and ultimate resistancecan be controlled in a rather simple way by a suitable selection of steel connection detailingand amount of reinforcement

    這種組合節點可以通過混凝土板內的縱向鋼筋實現組合梁在不同跨之間的連續性，而且通過選擇合適的型鋼樑柱連接方式和縱向鋼筋數量，可以有效地控制節點的剛度與承載能力。
  17. The study on the behavior of semi - rigid joints in steel - concrete composite frames gets widely attention recently. a high degree of continuity can be achieved at a very low cost just providing the slab with rebar running along the column. furthermore, stiffness and ultimate resistance can be controlled in a rather simple way by a suitable selection of steel connection detailing and amount of reinforcement

    鋼-混凝土組合框架中半剛性組合節點性能的研究近來引起了廣泛的關注，這種節點形式花很低的成本就可以通過混凝土板內的縱向鋼筋實現組合梁在不同跨之間的連續性，而且通過選擇合適的型鋼樑柱連接方式和縱向鋼筋數量，可以有效地控制節點的剛度與承載能力。
  18. Through testing eight composite beams with partial shear connectors under dead load and repeated load, the effect that repeated load acts on composite beams is analyzed on the basis of the test process, phenomena, and result

    摘要通過8根部分剪力連接組合梁的靜載和重復加載試驗，在對試驗過程、試驗現象以及試驗結果分析的基礎上研究了重復加載對部分剪力連接組合梁受力性能的影響。
  19. The emphases of the research works of this thesis are laid on the mechanical performance of the shear connector of the continuous composite bridge, the crack status and design method for crack control of the concrete deck in the negative moment zone of the continuous composite bridge, the influence of the connecting rigidity and the construction method over the structural mechanical characteristics of the continuous composite bridge, and the force transmission mechanism and the stress distribution of the rigid node connecting the girder and the pier in the mixed bridge and so on

    其中重點研究了組合結構橋梁中剪力鍵性能，負彎矩區混凝土板裂紋狀態及控制裂紋的設計方法，鋼與混凝土的接合剛度和施工方法對結構受力特性的影響，以及混合結構橋梁中梁墩剛性連接的傳力途徑及應力分佈等。
  20. Based on the experimental study and inelastic theory, the ultimate flexural capacity of steel encased concrete composite beams are derived. the difference between steel encased concrete composite beams with full shear connection and beams with partial shear connection, together with the relationship between the inelastic neutral axis of steel parts and concrete parts, are considered in the formulae. the calculation results of the eight specimens with full shear connection and the three specimens with partial shear connection are in good agreement with the experimental data, which validates the effectiveness and efficiency of the proposed calculation methods. furthermore, the nonlinear finite element analysis of the ultimate flexural capacity of the steel encased concrete composite beams is performed. nonlinear material properties and nonlinear contact properties are considered in the finite element analysis. the finite element analytical results also correlate well with the experimental data

    基於外包鋼混凝土組合梁的試驗研究和塑性理論，按照鋼梁和混凝土塑性中和軸相對位置的不同，分別推導了完全剪切連接和部分剪切連接的外包鋼混凝土組合梁的正截面極限抗彎承載力的計算公式，並對外包鋼混凝土組合梁進行了非線性有限元分析，分析中重點考慮了材料非線性和接觸非線性. 8根完全剪切連接和3根部分剪切連接試件的正截面極限抗彎承載力的計算結果及有限元分析結果與試驗結果吻合良好
分享友人
分享到 Line

分享到臉書