接觸層 的英文怎麼說

中文拼音 [jiēchùcéng]
接觸層 英文
contact layer
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : i 量詞1 (用於重疊、積累的東西 如樓層、階層、地層) storey; tier; stratum 2 (用於可以分項分步的...
  • 接觸 : 1. (交往) come into contact with; get in touch with 2. (沖突) engage 3. (挨上; 碰著) contact; touch
  1. If the gouge layer is thin, contact between asperities on the rock surfaces can occur.

    如果充填物很薄,兩個巖石表面上的凸起物就有可能互相
  2. Stability of rock slopes is generally controlled by the structure of rock masses, especially the soft structure surfaces. analysis of rock mass structures is a key to establish geological models and numerical simulation and a foundation to assess the stability of rock slopes. the weak structure surfaces are mainly bedding planes, faults, joints, schistosity plane and contact zones of intrusive bodies. since they are different in genesis and scale, the rock masses are different in features and mechanical intensities. based on the combination of rock structure bodies, 15 basic modes of deformation and failure of rock slope are systematically summarized. the deformation and failure of rock masses actually result from the recombination and rearrangement of these rock bodies. there are 11 types of rock mass structures and various deformation and failure of bank slopes are present in the reservoir area of the three gorge project

    巖體結構,特別是軟弱結構面對基巖斜坡變形與破壞具有顯著的控製作用,巖體結構模式分析是建立斜坡地質模型和數學模型的關鍵和評價斜坡穩定性的基礎。巖面斷裂構造節理裂隙片理與劈理以及侵入體和圍巖的帶等是控制基巖斜坡穩定的軟弱結構面,這些成因不同大小不一的結構面將巖體分割成性質各異力學強度不均的各種巖體結構體,構成了15種基巖斜坡變形破壞的巖體結構基本模式。不同結構體的重新組合與排列是斜坡失穩的內在原因。
  3. The cause that it produces is to there exist a thin layer in the surface that liquid and the gas contact, to be called a surface layer, molecule inside the surface layer is more sparse than the inside of liquid, molecule room distance is a few bigger than the inside of liquid, molecule room coactions shows for the gravitation

    它產生的原因是液體跟氣體的表面存在一個薄,叫做表面,表面里的分子比液體內部稀疏,分子間的距離比液體內部大一些,分子間的相互作用表現為引力。
  4. The oil is injected into the bed of fluidized coalite and cracks on contact with hot solid.

    該油注于流化焦粉床中,與熱固體而裂解。
  5. Antigone represents " family values " but at the same time something " deeper " ( if not higher ), connected with religion, the unwritten dateless laws

    安提岡尼代表的家族價值,也更深(如果不算更高)的到宗教面,一種非成文的、不知何時頒布的法律。
  6. At deanery and parish levels, priests, pastoral workers, members of parish formation groups and social concerns groups have to understand the problems faced by workers today in order that they can give more support to the labor

    培育神職人員牧民工作者堂區培育組及關社組在鐸區面及堂區面認識工人問題,並工人。
  7. Most author agree that they include interactions at the contact of solid particles and electrolytic solution which exist in the ground.

    大多數作者認為,它們包括了地中固體顆粒與電解質溶液面上所發生的相互作用。
  8. Properly designed heat exchangers substantially improve the contacting in the bed by breaking up growing bubbles.

    合理設計的熱交換器能使長大的氣泡破碎,以有效地改善床中的
  9. Many experiments indicate that flocculus steel balls possessing reticulate veins surface tend to elastic fluid kinetic lubricating layer and improves of the lubricating conditions of bearings. the bearings become quite, and have long life. therefore, in this paper we bring forward a new method to process flocculus steel balls possessing reticulate veins surface

    而且許多實驗表明:表面呈現網狀紋理形貌的「絨面」鋼球,有利於鋼球和套圈之間的點區域形成全膜彈流潤滑,使得軸承的潤滑狀態得到改善,從而實現軸承減振降噪和提高壽命的目的。
  10. Individual layers generally have sharp contacts.

    間一般具有截然的帶。
  11. Secondly, through analyzing the failure instance of electrical connectors in using and testing environment, educed contact fault was a main mode of failure of electrical connectors. on natural working conditions, the main reasons which caused fault of electrical connector were contact stress decreasing, microseism wearing and tearing and surface film growing

    而在正常的工作條件下,造成電連器電失效,即決定電連器工作壽命的主要原因是壓力減小、微動磨損和表面膜的生長,而影響壓力、微動磨損和表面膜變化的主要因素是環境振動和溫度。
  12. Considering the gap between steel lining and concrete lining as the imperfect contact, contact layer is proposed to simulate the gap in the combined work analysis

    針對這種不密實問題,採用厚壁圓環組合環法,提出了在鋼襯和混凝土之間設置接觸層的鋼襯、混凝土襯圈和圍巖三者聯合受力分析方法。
  13. The intention of the paper is to study the deposition and properties of znte ( znte : cu ) polycrystalline thin films and to apply znte ( znte : cu ) as a complex back contact layer between cdte and metal electrode to obtain ohm contact and high efficiency cdte solar cells

    本論文目的在於研究znte ( znte : cu )多晶薄膜的制備和性質,並把znte znte : cu多晶薄膜作為復合背接觸層應用於cdte和背金屬電極之間以獲得歐姆和高效cdte太陽電池。
  14. Last year, a series of short radio and tv programmes broadcasted on commercial radio 881 and tvb jade respectively was produced to widen the coverage of public education on information security

    為擴闊資訊保安公眾教育的接觸層面,去年,我們製作了一系列簡短的電臺和電視節目,于商業電臺881頻道及無線電視翡翠臺播放。
  15. Cdte solar cells with the complex back contacts do not have roll - over

    復合背接觸層能消除cdte的roll - over現象。
  16. That znte / znte : cu layer used as a complex back contact improves the performance of cdte solar cells has been studied

    研究了把znte znte : cu作為復合背接觸層對cdte太陽電池性能的改善。
  17. Parameters of contact layer are determined when deformation of contact layer is equal to initial gap which is proposed in the criterion of penstock

    另外,接觸層參數可通過其變形與規范建議的初始縫隙相匹配的原則加以確定。
  18. The results show that znte / znte : cu layer can improve back contacts and largely increase the conversion efficiency of cdte solar cells under the same technical condition

    結果表明在同等工藝條件下復合背接觸層能改善背,且能較大幅度提高cdte太陽電池的轉換效率。
  19. The result from different contact case shows that the elastic modulus of contact layer is sensitive to pressure - bearing ratio when its elastic modulus is less than one percent of concrete ' s

    不同情況下的受力分析結果表明,當接觸層彈性模量小於混凝土彈模的1 / 100時,接觸層的彈性模量變化對鋼襯和圍巖壓力分擔比的影響較大;而接觸層厚度對壓力分擔比的影響不甚明顯。
  20. Contact layup molding

    接觸層疊模製法
分享友人