接近曲線 的英文怎麼說

中文拼音 [jiējìnqūxiàn]
接近曲線 英文
approach curve
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 近 : Ⅰ形容詞1 （空間或時間距離短） near; close 2 （接近） approaching; approximately; close to 3 （親...
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 接近 : 1 （靠近; 相距不遠） be close to; near; approach 2 [天文學] approach; approximation; application;...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. A hyperbola approaches but does not meet its asymptote.

    雙曲線逐漸接近它的漸近線但不相交。
  2. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型，用該模型較好地描述了sicpmos器件閾值電壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線；分析了源漏寄生電阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響；論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性，分別模擬了室溫下和300時sicpmos器件的輸出特性，分析了柵電壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  3. From the result we get the following conclusion : for narrow - band signal, the effect of the method based on fft is best. for wide - band signal, when snr is up to certain degree ( higher than - 7db or so ), the curves of square error of modified methods are more obvious and closer to crb. for an echo composed of more than one frequency or direction, space - frequency distribution could show more direct information of frequency and direction, which is more advantaged to make precise judge and estimation for doa of echo

    從估計結果發現，對于窄帶回波信號，基於fft的方法估計性能大大優于其他方法；對于寬帶回波信號，在信噪比達到一定程度（高於約- 7db ）時，補償后的幾種估計法的性能改善均比較明顯，誤差曲線越來越接近crb曲線；對于回波中存在多頻率多方位的情況，空間?頻率分布圖能提供較為直觀的頻率及方位信息，因此應用空間?頻率估計法來進行方位估計，更有利於進一步對回波的具體方位進行準確判斷和估計。
  4. During the instantaneous frequency estimation of lfm, there exists some error in the edge, so in the dissertation, a fitting method is proposed to modify it. from the computer simulation, the following result is obtained : for cw, the method based on cwt is most effective, and with the snr rising, the error curve of it is more and more closer to crb. for lfm, the method based on wvd gives the best result, and the effects of cwt and stft are similar for multi - component signal, compared to stft and wvd, cwt is a better choice

    通過模擬發現，在單頻回波的瞬時頻率估計中，基於cwt的方法最為有效，隨著信噪比的提高，其均方誤差曲線越來越接近克拉美?羅界；在線性調頻回波的瞬時頻率估計中， wvd法得到的效果最好，而cwt與stft法的估計效果比較接近；在多分量信號的瞬時頻率估計中，相對于stft和wvd法， cwt法是一個更好的選擇。
  5. The only requirement is that you look at road at near glancing incidence because the rays bend very gradually.

    唯一的條件是要從接近掠入射的方向去看公路，因為光線彎曲得非常慢。
  6. In this paper, penman does some study - works as follows : the experiments of sixty jointing pieces and stressed skin diaphragm. through the experiment date researching and analyzing, the " p ? " curve of the stressed skin diaphragm is presented ; the analysis of jointing pieces data. the calculate method of loading capacity and range of shear rigidity value, the linker ' s dependability coefficient and the importance factor of linker are presented ; the calculate method definiteness

    本文針對國內常用板型自攻螺絲連接的蒙皮體組合體做了整體試驗，進行了以下幾個方面的研究工作：進行了60個小試件的拉伸試驗和蒙皮組合體的整體試驗，記載了試驗的應力應變數據，研究了連接點的受力狀態以及構件連接點附近壓型鋼板的應力狀態，得出蒙皮組合體的p ?曲線；小試件的拉伸試驗數據分析。
  7. To avoid the serious electromagnetic interferer, the analog signals are transformed to frequency pulses which are transferred to the kernel of the system. in the measure of the groove voltage, the method of float - ground is adopted to avoid the high common signal and the range switch circuit is designed to solve the conflict of the wide dynamic range and the high precision. least square curvefit is adopted to reduce the system error

    鋁電解生產現場電磁干擾非常嚴重，為此我們將需要測量的模擬信號就近轉換為頻率脈沖后再傳送到控制核心；採用浮地接入方式消除槽電壓信號中的共模成分；設計了量程自動切換電路以解決槽電壓的動態范圍寬和測量精度高的矛盾；用最小二乘法進行曲線擬和以降低測量的系統誤差。
  8. The normalized factorial moments ( nfm ) show good scaling properties in isotropical partition of phase space ; the nfm ' s projected into three directions versus the. partition. number appear, to be saturated curves with similar in scaling behavior ; and the three hurst exponents are very close to unity. the levy - stability holds for the q = 2 ~ 5 order moments in 3 - dimensional phase - space

    發現：三維歸一化階乘矩（ nfm ）的分佈呈現出很好的標度特性；階乘矩在各個方向上的一維投影呈現出彼此十分相似的飽和曲線，且特徵參量hurst指數都接近於1 ；高維相空間各階階乘矩的分佈滿足l vy穩定性的要求。
  9. The intake lag angle of the engine is optimized, and the dynamic effects of intake pipes and exhaust pipes to the improvement of motorcycle engine is applied to make the engine test performance curve approach the simulation curve

    本文介紹了從進氣晚關角及進排氣的動態效應幾方面著手，不斷改進發動機的配氣相位以及進排氣系統，使發動機的實際性能曲線逐步接近計算機模擬曲線。
  10. The dta curve of the fine clay fraction exhibits a major exotherm near 340℃.

    這種細粒土級分的DTA曲線接近340處有一個很大的放熱峰。
  11. The data analysis has to compensate for the doppler shift to make any signal as sinusoidal as possible, which helps pull it out of the noise ( with something based on a fourier transform )

    數據分析中比較對多普勒偏移進行補償以使信號盡可能地接近正弦曲線，以方便從噪音中提取真正的信號（通過傅立葉變換） 。
  12. A nearly ideal solution like benzene-toluene shows a vapor-pressure curve that conforms very closely to the plot.

    象苯一甲苯那樣的接近理想溶液，其蒸氣壓曲線與此圖板極為吻合。
  13. When the adhesion coefficient is close to the maximum tire - road friction coefficient, the current adhesion coefficient is used as maximum tire - road friction coefficient to control the drive torque

    當觀測到? -曲線接近於峰值點時，將該時刻的輪胎利用附著系數作為路面峰值附著系數，並根據識別的路面峰值附著系數進行驅動防滑控制。
  14. By changing the value of the shape parameter, we can adjust the approaching degree of the curves to their control polygon

    通過改變局部形狀參數的取值，可以調整曲線接近其控制多邊形的程度。
  15. A control method is presented where least square arc approximation and timed interpolation are employed. using it, the number of segments of fitted curves is made minimum while the accuracy is guaranteed, so that data transmission between cad and cnc systems is decreased and setted feeding rate can be realized. this method has already success fully been used for flame cutting and controlling saddle - backed curve for pipe connection when feeding rate is required to be higher

    提出了一種採用最小二乘法圓弧逼近及定時插補控制方法，在保證精度的前提下，可使擬合圓弧段數最少，從而減少cad系統與cnc系統的數據傳送，可實現給定進給速度.該方法已成功地應用於要求較高進給速度的接管馬鞍型曲線火焰切割擬合控制
  16. From some data, we got the result : xuansuo theory is better than the paowu theory, which ' s error is the largest

    因此，攝動法最接近懸鏈線，懸索曲線次之，拋物線的計算結果誤差最大。
  17. < uk > the dta curve of the fine clay fraction exhibits a major exotherm near 340. < / uk >

    < uk >這種細粒土級分的dta曲線接近340處有一個很大的放熱峰。 < / uk >
  18. Secondly, as for degree reduction of interval rational bezier curves, two methods are given : pseudo linear programming method ( plpm ) and pseudo optimal approximation method ( poam )

    接下來對區間有理bezier曲線，給出兩種降階逼近演算法：擬線性規劃法（ plpm ）和擬最優逼近法（ poam ） 。
  19. The program of data processing in determination of percent released of pharmaceutical preparation was developed ; two modules included in this program are connected but independence each other, one module calculate percent released, one module regress equation ; determination of percent released of pharmaceutical preparation, comparison of released curve in one reference frame and modeling mathematics model were realized by running this program. the program of formulation optimization based on artificial neural network was compiled to solve the nonlinear problem in formulation optimization. provided parameters were used to predict the released amount of a set of formulations

    簡便，其計算結果與現有其他程序計算結果基本一致：開發固體制劑體外溶出試驗數據處理程序，程序運行時分為計算累積釋放百分率和優選最佳數學模型兩個相互連接又各自獨立的環節，實現了累積釋放百分率的自動計算，同一坐標系下釋放曲線的直觀比較，常用數學模型的擬合；開發基於人工神經網路的處方優化系統，解訣處方優化這一多目標、非線性優化問題，利用符合擬合精度的訓練結果預測給定處方的釋放度，預測結果與實驗結果基本相近。
  20. When submarine curves close the water surface, the course is affected by the quasi white noise disturbances. the close water control structure is same with that in deep water. the simulations show that the control effects are close to the ideal situations

    由於在近水面航行時，航向所受到的主要是接近於白噪聲的干擾，所以採用了結構和水下相同的航向自動舵，由模擬曲線可看出控制效果比較理想。
分享友人
分享到 Line

分享到臉書