接頭錯位 的英文怎麼說

中文拼音 [jiētóucuòwèi]
接頭錯位 英文
radius off set joint
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 錯 : Ⅰ形容詞1 （錯誤; 不正確） wrong; mistaken; erroneous 2 （用於否定: 壞; 差） bad; poor 3 （交叉; ...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
  1. By means of area method and stress field intensity approach and computational analysis of finite element, the fatigue strength of misaligned welded joint, " t " type of plate welded joint and cruciform joint are estimated. estimations are consistent with fatigue testes

    利用面積法和應力場強法，通過有限元計算分析，預測了錯位板接頭、 t型板接頭和十字型板接頭在對稱循環和非對稱循環時的疲勞強度，並與疲勞試驗進行了比較，理論預測與試驗基本一致。
  2. The stress fields in misaligned welded joints, " t " type of plate welded joint, flanged beam and perpendicular flanged beam are calculated respectively, and their stress concentration factors formulation are obtained

    採用這兩類單元計算了錯位板接頭、 t型板接頭、工字梁焊接鋼結構和工字梁十字接頭的應力場，得到了相應的理論應力集中系數公式。
  3. But displacement relatively value of pipe liner structure is very smallness, the tie - in of pipe liner would not move and come away. and it is bigger that the level displacement value of substrate tie - in of pipe liner than upper

    而管片襯砌結構的位移的相對值卻非常小，不會發生錯動和脫開，且管片襯砌結構接頭處的下管片較上管片的水平位移值稍大。
分享友人
分享到 Line

分享到臉書