控制振蕩器 的英文怎麼說

中文拼音 [kòngzhìzhèndàng]
控制振蕩器 英文
control generator
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中,作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;電路中尖峰脈沖噪聲抑、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. Motion controller composed of general chip series is developed and quadruple differential circuit utilizing dual monostable multivibrators with schmitt trigger inputs and dual 4 _ line to l _ line data selectors or multiplexers is put forward

    本論文研製了一種用常規晶元系列組成的運動,提出了採用單穩態多諧和數據選擇的四倍頻辨向電路。
  3. In chapter three, the all sub - circuits including uvlo, current bias, ldo, oscillator, green mode, slop compensation, power limiting, pwm, ovp, blanking time generator, logic controller are designed and simulated. as a result, all of the sub - circuits are satisfied the requirements

    本文第三章對集成電路內各個模塊包括欠壓保護、電流偏置、 ldo 、、綠色模式、斜坡補償、功率限、脈寬調、過壓保護、前沿消隱、邏輯電路等進行了設計與模擬,且達到了預定的設計目標。
  4. The system exhibits fast response for the load current disturbance and the system always operates at discontinuous conduction current mode so that no slope compensation is required and high efficiency will be achieved when driving 4 leds. the design and analysis of sub - block circuits are provide in the thesis where band gap reference, oscillator, current sensing and over current protection, led load current

    本文完成了各個單元電路的分析與設計,著重分析了帶隙基準源、、采樣和過流保護、負載led電流和開負載保護五個子電路,對其餘子電路也作了簡要分析。
  5. Generic specification of crystal controlled oscillators

    晶體控制振蕩器的一般規范
  6. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中,作者介紹了直流電機的工作原理和數學模型、脈寬調( pwm )原理、 h橋電路基本原理和h橋功率驅動電路的兩種模式,設計了驅動電路的總體結構,給出了電路的功能模塊,確定了設計的可行性,然後在子電路模塊中,重點分析設計了基準源電路、電路、高端功率管柵驅動電路(電荷泵及自舉電路) 、低端功率管柵驅動電路和死區時間產生電路。
  7. The thesis discussed a parameter extraction program for the mosfet level1 model. in the analysis and design of circuit, at first, the thesis described the system function of the new dc - dc switching converter. then several sub - circuits of converter ic such as oscillator, over - temperature shutdown circuit, auto - restart counter circuit and control circuit were completely discussed

    在電路設計中,本文首先分析了開關電源電路的基本拓撲結構和psm調模式,接著對開關電源變換進行了系統的原理分析並設計了總體框圖,然後詳細設計了電路,熱保護電路,自動重啟計數電路和主門邏輯等子電路並進行了功能模擬。
  8. Vco input control voltage

    輸入電壓
  9. Voltage controlled oscillator

    電壓控制振蕩器
  10. Vco voltage controlled oscillator

    電壓控制振蕩器
  11. Capacitor - controlled oscillator

    電容控制振蕩器
  12. Mass - controlled oscillator

    質量控制振蕩器
  13. Quartz crystal controlled oscillators of assessed quality - standard outlines and lead connections

    經質量評定的石英晶體控制振蕩器.標準外形和引線連接
  14. Quartz crystal controlled oscillators of assessed quality - part 1 : generic specification ; amendment 2

    經質量評定的石英晶體控制振蕩器.第1部分:總規范.修改件2
  15. Quartz crystal controlled oscillators of assessed quality - part 4 : sectional specification - capability approval iec 60679 - 4 : 1997 ; german version en 60679 - 4 : 1998

    經質量評定的石英晶體控制振蕩器.第4部分:分規范.能
  16. Quartz crystal controlled oscillators of assessed quality - part 5 : sectional specification ; qualification approval iec 60679 - 5 : 1998 ; german version en 60679 - 5 : 1998

    經過質量評定的石英晶體控制振蕩器.第5部分:分規范
  17. These chip inductors provide maximum protection features for solder reflow, welding and come with precise formed caps of high temperature acrylic for perfect co - centering and vacuum pickup. they have excellent solderability and are able to withstand pull - up force, mechanical shock and pressure. available in sizes of 0402, 0603, 0805, 1008, 1206, 1210, our chip inductors have wide inductance range for virtually all broadband and rf applications

    臺達電子提供全系列之被動元件,包括0402 0603 0805 1008 1206與1210系列,可應用於行動電話基地臺寬頻通訊無線電話個人數位助理pda呼叫電視機上盒數據機電壓控制振蕩器與高頻模組等。
  18. Then the paper researches the operational principle and realization method of each subassembly of the digitized phase - locked loop, which includes numerical controlled oscillator, digital phase dectector, and digital filter etc., and also discusses the method of improving the performance of each subassembly

    接著闡述了數字化鎖相環各個部件的工作原理及實現方法,包括數字控制振蕩器,數字鑒相,數字濾波等,研究了改進各部件性能的方法。
  19. The frequency of the pulse is the same as that of the crystal oscillator. the pulses sampled the output of the vco and generate the error signal. the error signal is amplified,

    誤差電壓經放大後送入環路濾波進行濾波和再放大,然後去改變變容管偏置電壓,控制振蕩器輸出頻率,達到穩頻的目的。
  20. Quartz crystal controlled oscillators of assessed quality - part 4 - 1 : blank detail specification ; capability approval iec 60679 - 4 - 1 : 1998 ; german version en 60679 - 4 - 1 : 1998

    經質量評定的石英晶體控制振蕩器.第4 - 1部分:空白詳細
分享友人