控制穿孔 的英文怎麼說

中文拼音 [kòngzhìchuānkǒng]
控制穿孔 英文
control punch
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 穿 : Ⅰ動詞1 （破; 透） pierce through; penetrate 2 （通過孔、隙、空地等） pass through; cross; go thro...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 穿孔 : 1 （鉆孔; 鑿孔; 打孔） bore a hole; punch a hole; punching; piercing; tresis; key punching 2 [醫...
  1. Automatic card programmed rolling

    穿孔帶程序控制自動軋機
  2. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  3. Associated with a practical example of pipeline crossing with directional drilling technique in yizheng - changling crude oil pipeline, this paper analyzes the characteristics of crossing through rocky stratum with directional drilling, deliberates the stratum status, drilling machine selection, drilling tool assembly, direction control, mud control ; drilling process as well as emergency dealing scenarios at the stages of guiding - hole drilling, aperture expanding and back - towing

    摘要結合儀征長嶺原油管道洪湖長江定向鉆穿越工程實例，分析了管道定向鉆穿越長距離巖石層的特點，論述了定向鉆穿越巖石層的地層狀況、鉆具組合、控向措施、泥漿控制、鉆進工藝以及導向孔鉆進、擴孔、回拖階段的應急預案，針對在鉆導向孔過程中因泥漿壓力高、信號線多次出現被高壓泥漿沖壞、造成控向信號不穩定甚至中斷的情況，對信號線的安裝提出了改進措施。
  4. Using extremum statistical method to predict pit corrosion sizes of the pipeline in service and further to evaluate the residual strength of the pipeline has a great significance for controlling accidents of corrosive perforations, guiding pipeline rehabilitation and replacement as well as prolonging service life of pipeline

    長輸管道的腐蝕類型多為均勻腐蝕或點腐蝕，採用極值統計方法對在役管道的點蝕尺寸進行預測，進而評價管道的剩餘強度，對于控制管道的腐蝕穿孔事故、指導管道的修復更換、延長管道的使用壽命具有重要意義。
  5. Card programmed computer

    穿孔卡片程序控制計算機
分享友人
分享到 Line

分享到臉書