推挽制 的英文怎麼說

中文拼音 [tuīwǎnzhì]
推挽制 英文
push-pull system
  • 推 : 動詞1 （向外用力使物體移動） push; shove 2 （磨或碾） turn a mill or grindstone; grind 3 （剪或削...
  • 挽 : 動1 （拉） pull; draw 2 （向上卷） roll up 3 （牽引） pull; draw 4 （哀悼死者） lament sb s death...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  1. Ppfc working principle, circular current and effects of clamping capacitor are studied in this paper in detail. because of the clamping capacitor, ppfc have some good features compared with ppc : reducing the fluctuate of the input current ; restraining the voltage spike of the power mosfet ; avoiding the bias - magnetic of the transformer

    由於箝位電容的加入，相對于推挽電路而言，該拓撲具備了一些獨特的優點：減小了輸入電流的脈動：削弱了開關管的關斷電壓尖峰；有效抑制了變壓器的偏磁。
  2. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  3. The push - pull mode switch power supply is chosen as the main circuit of the other voltages with pwm control circuit, over - current protection circuit, insulated drive circuit, mosfet buffer circuit and so on

    採用高效的推挽式電路作為中低壓電源的主電路，並以pwm控制電路、隔離式驅動電路、過流保護電路、 mosfet緩沖電路、軟啟動電路、穩壓電路等作為輔助電路。
  4. With the best modulation strategy which was found on condition that it must have largest energy transfer ratio, smallest current ripple of the inductor, and realizing zvs of each switches, the converter overcomes the drawbacks presented by the conventional zvs fb converter, such as high voltage stress of each switches, large current ripple of the inductor, and severe parasitic ringing on the rectifier diodes, so it can get higher efficiency, faster respond speed, and wider application area. the operation principle of the proposed converter is analyzed and verified by a 3kw, 50khz experimental prototype. experiments and research results show that the scheme of the tl topology derivation is reasonable, adjusted modulation strategy makes some other severe problems in conventional topologies easy to solve or makes the converter more competitive

    研究結果表明，本文提出的三電平拓撲變換方案合理，針對各種三電平拓撲尋找到的控制策略可以解決變換器存在的某些問題或使變換器表現出更突出的優勢：例如針對單管直流變換器三電平拓撲的控制策略可以減小電感的設計值，針對推挽直流變換器三電平拓撲的控制策略可以實現開關管的軟開關、解決變壓器偏磁問題等，針對全橋直流變換器三電平拓撲的控制策略可以減小電感的設計值、實現開關管的軟開關等。
  5. Comparing with usual push - pull converter, the bias - magnetic can be retrained due to the clamping capacitance. but bias - magnetic can not be avoided

    推挽正激變換器相比普通的推挽式變換器，由於箝位電容的存在，偏磁可以被抑制，但並不能完全消除。
  6. （ 2 ） the major circuit has been established, composed of rectifier 、 buck - chopper 、 push - pull inverter and matching network, which realizes high - power supersonic ac output. to achieve maximal output power, the pulse frequency modulation ( pfm ) has been applied to auto - adjustment of output frequency, which corresponds to the load ' s resonant frequency

    （ 2 ）建立了超聲電源主電路，其中包括：整流、直流斬波、推挽逆變器和匹配網路等部分，實現了大功率超聲頻交流電的輸出，輸出頻率的脈頻調制（ pfm ）和輸出功率的脈寬調制（ pwm ） 。
  7. This conclusion is useful to optimize the converter. then it is proposed that the effects of retraining bias - magnetic and reducing the voltage stress of mosfet should be both considered in selecting the clamping capacitance

    本文提出對于推挽正激的關鍵參數? ?箝位電容的選取要綜合考慮對偏磁的抑制作用和對功率管尖峰的抑制作用，並給出了選取方法。
  8. The whole high power switch supply have four bidirectional dc / dc converters which are parallel connection. the theory of phase - shifted full - bridge zvs pwm dc / dc converter and the theory of push - pull boost converter are introduced. the methods of realize zvs ( zero voltage switching ) is studied in detail

    文中介紹了移相全橋式軟開關變換及推挽式dc dcboost變換的工作原理，分析了移相全橋zvs的實現和占空比的丟失，並設計了各自的控制電路和保護電路。
  9. To provide leadership in and to ensure the effective and efficient implementation of human resources policies, systems and practices, including, but not limited to, those relating to staff relations, staff training, compensation and benefits, payroll, performance management, compliance, recruitment, retention and succession

    領導人力資源政策、制度和常規的推行，並確保推行工作快捷和有效地進行。有關的人力資源政策、制度和常規包括但不限於員工的薪酬與員工關系、員工培訓、薪酬、補償和福利、工作表現管理、遵守規定、招聘、挽留員工和安排接任人手等范疇；
  10. This paper proposes a two - armed push - pull inverter, including its topologies, power distributions in every switching devices and modulation schemes. the major parameters such as thd and df of this vsi are analyzed. comparison study shows that the quality of two - armed push - pull vsi is better than those of square - wave vsi. and the switching loss is lower than that of pwm scheme at same time, especially used in wide frequency range. detailed calculating formulae and experimental results are presented

    該文介紹了一種雙臂推挽式逆變器，包括其電路拓撲、每個開關器件的功率分佈和調制策略.分析了這種電壓源逆變器的主要參數，如總諧波失真度（ thd ）和失真指數（ df ） .比較研究表明，這種逆變器的質量明顯優于方波逆變器，同時開關損耗明顯低於pwm調制方式，特別適用於寬頻范圍.介紹了計算公式和實驗結果
分享友人
分享到 Line

分享到臉書