推換電路 的英文怎麼說

中文拼音 [tuīhuàndiànlù]
推換電路 英文
push pull circuit
  • 推 : 動詞1 （向外用力使物體移動） push; shove 2 （磨或碾） turn a mill or grindstone; grind 3 （剪或削...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  2. This paper introduces the fundamental and characteristic of the fuel cell, analyzes the necessity and detail scheme of adding assistant energy sources to the fuel cell power generation system. considering for the special demand of the fuel cell power generation system, this paper gives out a push pull forward converter ( ppfc ) with passive and lossless dual cdd snubber circuit

    本文首先闡述了燃料電池的基本原理和性能特點，分析了在燃料電池發電系統中引入輔助能源系統的必要性及具體的配置方案，然後針對燃料電池發電系統對dc / dc變換器設計的特殊要求，提出了一種加雙cdd無源無損緩沖電路的推挽正激變換器（ pushpullforwardconverter ， ppfc ） 。
  3. The three - phase distribution flow method on combining the back / forward sweep algorithm and circuit calculation is studied. as a result, the transform model from the apparent power of low voltage side to the current of high voltage side is built

    研究了電路計算與配電網潮流計算的前推回代法相結合的（基於電路分析的）三相潮流計算方法，在該演算法的基礎上建立了配變低壓側的功率到高壓側的電流的轉換模型。
  4. This paper gives a comprehensive presentation about the fundamental of the flow - measuring method by flume, the design of khafagi flume and the buoy - level mechanism, the signal conversion by the angle measuring sensor and the deduce of the flow equation. it also introduces the hardware design, the development and emulation on software of the intelligent measuring meter in detail. the error of flow measurement is analyzed and calculated in the end either

    本文對槽式流量測量的基本原理、卡發基槽和浮桿測量機構的設計、角度傳感器的信號轉換以及流量計算公式的推導做了全面的闡述；詳細介紹了智能儀表應用系統的硬體電路設計和應用軟體的開發及模擬調試；最後對測量系統的各項誤差進行了分析和計算。
  5. Based on the output - voltage error function, a novel time discrete modulation technique is proposed for matrix converters ( mcs ) and time - discrete difference equations of a mc circuit are derived

    摘要針對矩陣變換器調制方式的特點，提出了基於輸出電壓誤差函數分析的矩陣變換器離散調制技術，推導了基於時間離散和差分原理的電路方程。
  6. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  7. Short message service ( sms ) over mobile network has become one of the most popular wireless services. recently, china telecom offers sms as a profitable added - value service that allows text messages to be sent and received over the pstn

    在移動短消息日漸被人們所接收，並在國內外通信市場取得巨大成功以後，中國電信推出了固網簡訊業務作為公共電話交換網路（ pstn ）的一項增值業務。
  8. This paper analyzes the unitary structure and work principle of the power source and explains the work principle of scr pre - regulate circuit, serial voltage regulate circuit and high frequency switch circuit

    文章中分析了電源的整體結構和工作原理，並詳細的講述了預穩壓電路、線性串聯穩壓電路、功率推挽變換電路等電路的工作原理。
  9. In this paper, the basic commutation cell in multilevel converters is proposed, based on which a series of multilevel converters with flying capacitors are derived. the operation principle of buck ml converter and its output characteristics are analyzed in details in this paper

    本文總結了飛跨電容型多電平變換器的拓撲變換思路，並將其推廣到boost 、 buck - boost 、 cuk 、 zeta和sepic變換器中，得到一族飛跨電容型多電平直流變換器。
  10. The question of magnetic path is transformed into the form of circuit topology to derivate the equivalent circuit between stator and rotor

    為了便於分析，將磁路問題轉換成電路拓撲的形式，推導出定轉子之間的等效電路。
  11. The whole high power switch supply have four bidirectional dc / dc converters which are parallel connection. the theory of phase - shifted full - bridge zvs pwm dc / dc converter and the theory of push - pull boost converter are introduced. the methods of realize zvs ( zero voltage switching ) is studied in detail

    文中介紹了移相全橋式軟開關變換及推挽式dc dcboost變換的工作原理，分析了移相全橋zvs的實現和占空比的丟失，並設計了各自的控制電路和保護電路。
  12. In this dissertation, a novel bidirectional dc / dc converter ' s topology was designed, witch used in vehicle power supply systems. the converter is composed of fundamental bidirectional switch cell, using phase - shifted full - bridge zvs pwm dc / dc converter in buck circuit and using push - pull boost converter in boost circuit

    文中從雙向dc dc變換基本單元入手，針對某大型車載電源系統設計了一種新型雙向dc dc變換器拓撲電路，降壓變換採用移相全橋式zvs ? pwm功率變換，升壓變換採用推挽式dc dcboost功率變換。
  13. This converter is thermally protected and current limited, protecting the load and regulator during fault conditions. in the circuit design chapter, the basic charge pump operation principle and equivalent circuit model are given first. then two control modes, pulse skip mode and linear mode, are analyzed

    在電路設計中，首先分析了跨周期調制的電荷泵dc / dc轉換電路的基本原理，然後推導出電荷泵等效模型，以此為理論依據分析了電荷泵的兩種控制模式:線性調制模式和跳周期調制模式。
  14. Then two kinds of simple passive lossless soft switching cells, which are applicable to non - isolated multilevel converters, are introduced in the thesis. their operation process is analysed in detail with figures and equations

    然後對適用於多電平非隔離直流變換器的兩種最簡無源無損軟開關單元電路的工作過程進行了詳細的分析與推導。
  15. The analysis of harmonic balance and transpositional matrix is used to get the formula of conversion loss in the later according to equivalent circuit design the whole circuit

    詳細介紹了二極體的混頻原理，以及常見的二極體混頻器電路的實現形式。採用諧波平衡分析方法和變換矩陣分析方法，推導出平衡混頻器變頻損耗公式。
  16. The principle of circuit is presented, and also the principle a ~ nd design consideration of the flyback converter. to establish the foundation of following design, the paper deduces the calculative formulas of the main ciituit parameters

    分析了電路的工作原理，對反激變換器的原理與設計做了詳細的介紹，推導了電路主要參數的計算公式，為下一步設計奠定了基礎。
  17. The article generalized the interception mode of packed switched network, viop system based on sip and ip network from circuit switched network. the voip system based on sip is distributed system

    因此，本文在無線通信系統電路交換域的合法偵聽系統研發的基礎上，將其偵聽模型推廣到包交換域、基於sip的voip系統和ip網路。
  18. This structure is kind of outer - coalescent. it adopts neural network ' s clustering function to classify the system output, then link a fuzzy controller in form of series which rules are made through the classified result. the design process and the experiment shows the well control effort to the full - bridge series type resonant dc - dc converter, at the same time the whole process avoids not only the modulating parameter process of the traditional method, but also the complexity of the traditional fnn design

    然後本文又對全橋式串聯共振型dc - dc變換器的主電路的狀態方程進行了理論上的推導，從而確定了這種全橋式dc - dc變換器的各種工作模式；然後通過分別對模糊控制和神經網路進行介紹，提出了一種新型的模糊神經網路控制器模型，該控制器模型是一種外接式結合? ?串聯式結合方式，它利用了神經網路的聚類功能，採用了一種再生式神經網路，即elman網路來對系統輸出進行分類，然後根據分類結果設計模糊控制器，這樣就簡化了整個模糊神經網路控制器的設計過程。
  19. The origin and evolvement of cuk converter are introduced and the voltage and current waveforms of every period are analyzed and presented. the state differential equations of ideal cuk converter are deduced and the simulation models of ideal cuk converter, ac power supply and pulse width modulator ( pwm ) are erected

    論文介紹了cuk型dc / dc變換器由來、演變；分析了各個環節、期間的電壓、電流的變化情況及波形；推導了理想cuk變換器的狀態方程；建立了cuk主電路以及相關交流電源、脈沖寬度調制器的simulink模擬模型。
  20. The circuit topologies family of voltage mode ac - ac mode ac / ac converters with high frequency link include eight circuit topologies, such as single forward mode, interleaved - forward mode, push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. the circuit topologies family of current mode ac - ac mode ac / ac converters with high frequency link include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controll is introduced

    電壓源交?交型高頻環節ac ac變換器電路拓撲族，包括單正激式、並聯交錯正激式、推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式八種電路；電流源交?交型高頻環節ac ac變換器電路拓撲族，包括單四象限功率開關式、推挽式、半橋式、全橋式四種電路。
分享友人
分享到 Line

分享到臉書