插入單元 的英文怎麼說

中文拼音 [chādānyuán]
插入單元 英文
insert cells
  • : 動詞1. (把細長或薄的東西放進、擠入、刺進或穿入; 插上; 插進) stick in; insert 2. (中間加進去; 加進中間去) interpose; insert
  • : Ⅰ動詞1 (進來或進去) enter 2 (參加) join; be admitted into; become a member of 3 (合乎) conf...
  • 插入 : insert; infix; run in; break in; patch; insertion; plug in; intercalate; intercalation; intromiss...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控電路連接器設計製成輸輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸輸出檢測端子和故障模擬處理實現對電噴發動機電控系統各傳感器、電控、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了傳感器和執行器典型故障波形。
  2. Secondly, the effort is made to develope new type of transition element for multi - scale fatigue damage simulaton of long - span structures for the transition between elements for the hot spot stress analysis and the structural element. the linear and piecewise linear interplotion function for displacement interplotion are used for the transition element formulation according to the displacement compatibility requirement between element interfaces

    在綜合已有的構造過渡模型關于位移值形式的基礎上,通過採用分段線性位移值模式和線性位移值方式,並在位移模式中引非協調位移模式,強迫構造通過分片試驗,構造了一種用於疏密網格連接過渡
  3. As one of the design for testability technology, boundary scan test ( bst ) fixes boundary scan cells between the device pins and core logics. thus, the bsc acts as the virtual test probe that carries out the test stimulus and captures the test response

    作為一種結構的可測性技術,邊界掃描測試( bst )技術將邊界掃描寄存器在集成電路內部的每個引腳上,其作用相當于設置了施加激勵和觀測響應的內建虛擬探頭。
  4. The results showed that the rubber latex particles separated the clay into nanometer units, accompanied with the competition between separation of rubber latex particles and re - aggregation of single silicate layers upon addition of flocculant during the process of co - coagulating, while the intercalation of rubber molecules into clay galleries did not occur

    結果表明,在加絮凝劑使橡膠乳液黏土水懸浮液共凝聚的過程中,由於存在膠乳粒子對黏土片層的隔離作用與在混合液中分散的黏土片層的重新聚集作用的競爭,因此,在絮凝物中,橡膠大分子將黏土片層隔離成納米分散(包括片層和多片層的聚集體) ,在多片層的黏土聚集體層間沒有橡膠大分子
  5. Insert update delete triggers attached to a table can detect changes made to data units and record the changes in a change log table

    附加到表上的/更新/刪除觸發器可以檢測到對數據所做的更改,並在更改日誌表中記錄這些更改。
  6. Hg2f touch screen plug - in modules can be connected oi, and provide more support up to 15

    式oi連接,提供多點支持最多可達15
  7. Rs232 rs485 and rs422 compatible with plug - in modules can be connected oi, and provide more support up to 15

    與rs232 rs485和rs422兼容可式oi連接,提供多點支持最多可達15
  8. Taking the pinboard of input converter train control signal as an example, this paper introduces the fault detection principle and the implementation, holds that the testing system will provide an effective method for sibas16 traction control unit

    以列車控制信號輸變換件板為例,介紹了牽引控制件板故障檢測的實現方法。
  9. ( 3 ) the free - standing porous silicon films with continuous porous structure were prepared on single crystal silicon wafer by the method of anodic oxidation and electrochemical etching - electropolishing, and firstly used as the anode materials for lithium ion secondary batteries. the capacities of lithium ions storage and the process of charge and discharge of this nano - silicon anode materials as well as the influence of the structure of ps on behavior of storing lithium ions were inspected at length. on the other hand, through the process of charge and discharge in cells, the lithium of light metal element could be electrochemically doped into ps at different doping levels

    胡勁松河北師死大學碩士學位論文( 3 )利用陽極氧化法在晶硅基底上制備了多孔硅自支撐膜,並首次將這種具有連續多孔結構的硅材料用作了理離子電池的陽極材料,考察了這種納米級硅陽極的儲鉀性能和充放電過程,分析了材料結構對其儲理行為的影響;另一方面,利用這種電池充放電過程在多孔硅中電化學引了不同點綴程度的輕金屬鉀素,考察了鉀點綴對多孔硅自身結構,及至性質所帶來的影響,提供了一種通過電化學方法埋離子從而連續調整多孔硅發光性質的有效方法。
  10. These power chips changed the technology landscape by implementing two cores so the ability to have two separate circuitry units executing compute instructions on a single chip something that plugs into the board

    這些power晶實現了到主板上的部件)上的雙核心(所以能夠讓兩個獨立的電路執行計算指令) 。
  11. For example, if you were authoring an xml schema, using the " complex type sequence element " and " simple type element " snippets inserts the following xml text to your file

    例如,如果編寫xml架構,使用「復雜類型序列素」和「簡類型素」代碼段將以下xml文本文件。
  12. Abstract : a new algorithm w - ecop is presented to effect incremental changes on a standard cell layout automatically. this algorithm deals with cell inserting and cell moving based on rows instead of on cells as most placement algorithms usually do. an integer programming problem is formulated to minimize the adjustment on the initial placement and a heuristic method is presented to search for a shifting path so as to optimize the wirelength. test of w - ecop on a group of practical test cases shows that the algorithm can successfully accomplish incremental placement with good quality and high speed

    文摘:提出了一種新的增量式布局方法w - ecop來滿足快速調整布局方案的要求.與以前的以為中心的演算法不同,演算法基於行劃分來進行和位置調整,在此過程中使對原布局方案的影響最小,並且盡可能優化線長.一組從美國工業界的測試例子表明,該演算法運行速度快,調整后的布局效果好
  13. Inserts a cell into the collection

    向集合中插入單元格。
  14. Corrigendum 1 - fibre optic interconnecting devices and passive components performance standard - part 051 - 3 : single - mode fibre, plug - style fixed attenuators for category u - uncontrolled environment

    勘誤1 .纖維光學互連器件和無源件性能標準.第051 - 3部分: u類模纖維式固定衰減器.非受控環境
  15. Insert table dialog box, click cell properties

    在「表」對話框中擊「格屬性」 。
  16. In the ibm token ring network, the transmit or output receptacle on an access unit

    在ibm令牌環網中,一個的發送或輸出座。
  17. Toggle between insert and overstrike mode while editing in a cell

    當在中編輯時,在和置換模式間切換
  18. Toggle between insert and overstrike mode while editing in a cell ins

    當在中編輯時,在和置換模式間切換
  19. The dissertation presents an automatic flow to characterize and model cells accurately and quickly by the stimulus reduction algorithm, the input signal driving algorithm, the characterization point dynamic insertion algorithm, the result table optimization algorithm and input signal integrity analysis algorithm, which reaches the advanced level in this field

    本文給出了深亞微米工藝條件下工藝參數提取和建模的完整流程,該流程能快速精確地完成工藝參數提取和建模。文中提出的激勵波形約簡演算法、輸信號驅動演算法、測試點動態演算法和結果表優化壓縮演算法等,達到了國際同類研究的先進水平。
  20. You can register a separate file for event categories, messages, and parameter insertion strings, or you can register the same resource file for all three types of strings

    您可以為事件類別、消息和參數串注冊獨的文件,或者,也可以為所有這三種類型的字串注冊同一個資源文件。
分享友人