損耗失效 的英文怎麼說

中文拼音 [sǔnhàoshīxiào]
損耗失效 英文
loss failure
  • : Ⅰ動詞1 (減少) decrease; lose 2 (損害) harm; damage 3 [方言] (用尖刻的話挖苦人) speak sarcas...
  • : Ⅰ動1 (減損; 消耗) consume; cost 2 [方言] (拖延) waste time; dawdle Ⅱ名詞1 (壞的音信或消息) ...
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • 損耗 : 1. (損失消耗) loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. First, it is compressible and cushiony ; second, it can be transported to a long distance with a little power loss ; the last, its flux and velocity of flow are quite high, so the reaction time of the operators can been considerably shortened. aiming to solve the problems of vibrating machinery such as short life - span, poor cushion and high energy consumption, the writer, on the basis of characteristic of pneumatic mentioned, contrives a set of valve controlled pneumatic vibrator, which has larger output vibrating force and longer life - span with simple structure. then, it is applied to drive a vibrating screen and the result is fairly well

    文中針對氣動技術本身的特性及優點,如:可壓縮,具有緩沖性;能小,便於遠距離輸送;流量大、流速高,執行元件響應速度快等,以解決振動機械在應用過程中的緩沖、能以及使用壽命等問題為目的,設計出一套輸出激振力大、結構簡單、使用可靠的閥控氣動激振器,並將其成功地運用到振動篩上,取得了較好的果。
  2. Commercial building telecommunications cabling standard - part 2 : balanced twisted - pair cabling - addendum 3 - additional considerations for insertion loss and return loss pass fail determination

    商用建築電信電纜敷設標準.第2部分:對稱雙絞合線電纜敷設.補充件3 .插入和回波通過確定的附加考慮要素
  3. This paper introduces that the diffuse heat heating furnace is reduced the consumption of fuel is debased and the preferable effect is got, using the multicrystal mullite fibrous stickup lump to heat preservation in heating furnace wall

    摘要採用多晶莫來石纖維貼面塊對加熱爐爐內壁保溫,減少了爐體的散熱,降低了爐子燃,取得了較好的果。
  4. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能加大,頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同,形成的室內熱環境特徵不同,通風換氣時產生的通風熱也有所區別,為了提高大換氣量房間的供暖節能果,必須對不同供暖方式在大換氣量情況下的熱舒適性與節能應進行研究。
  5. Electromotor joins with high efficiency selected water pump, scm ( single chip micyoco ) control system commands water pump according to cooling water temperature which substitutes traditional strap - driving mechanism pump and forms tael - level intellectualized control cooling system combining with electromotion control of cooling fan. consequently it realizes that water pump and fan autoregulate with engine working status and assures t hat cooling water temperature keeps in the best range all the time and advances the reliability of engine working and realizes exact control of cooling water temperature in deed

    選用高率水泵與電機聯接,改由單片機控制系統根據冷卻水溫控制水泵的工作,代替傳統的皮帶帶動的機械水泵,結合冷卻風扇的電動控制形成兩級智能化控制的冷卻系統,從而,實現了水泵和風扇轉速隨發動機工況變化的自動調節,真正實現了冷卻水溫的精確控制,保證了冷卻水溫始終保持在最佳范圍內,大量減少傳熱降低油,並提高了發動機工作的可靠性。
  6. The aerodynamic losses and the coolant consumption due to endwall film - cooling are quantified, thus providing data on both the aerodynamic costs and the cooling benefits of endwall film - cooling

    這種氣動力和冷卻空氣的定量化,可為端壁氣膜冷卻技術的氣動力成本和冷卻益提供數據。
  7. The ejected coolant interacts with the external flow near the endwall and generates aerodynamic and thermodynamic losses in the process. this reduces turbine stage efficiency and together with the consumption of cooling air is detrimental to the overall cycle efficiency

    但這種方法中噴射的冷空氣與端壁附近的外流場相互作用產生氣動力和熱動力,並且消冷卻空氣,從而害渦輪的整體循環率。
  8. Clbs grain moisture conditioner, solving the problem of grain moisture losses during venting process in winter season or in storage period, improving quality and keeping grain flavor in storage period, lower immaterial grain losses, increasing economic benefits of grain depots

    Clbs糧食儲藏保水機能有解決糧庫糧食冬季通風降溫和儲藏過程中的水分,提高糧食儲藏品質,改善糧食加工工藝品質,降低糧食,提高儲備庫經濟益。
  9. Based on the method of energy consumption, an analysis is given of the impact, which the dirt growth of a tube and shell sewage heat exchanger will have on transfer intensity, flow pressure drop and their energy losses

    本文運用熱力學能分析法,分析了管殼式污水換熱器中軟垢的厚度對換熱強度、流動壓降及其有的影響。
  10. In at power supply system some transformers with special connection mode, such as scott transformer, anti - scott transformer, balance transformer and so on, are usual used. the voltage ratio is one of important parameters of transformer

    採用斯科特變壓器、平衡變壓器等特殊接線方式變壓器作為主變壓器,能有抑制負序電流,減少有功和電壓,提高牽引機車的過負載能力。
  11. Ceramic grain filters ard made of refined pottery clays added with certain modifiers, and processed of grinding, mixing, shaping and high temperature sintering. they do not contain any substances that harmful to people or environment. they are hard and rough in surface, porous inside the structure, and have the advantages of high mechanical strength, large specific surface area and porosity. when used in water treatment, they behave a activated surface property, a great amount of pollutant entrapment, less water head loss in the filter bed, lower consumption of back - flush water, stable in chemical and gbiologic property, and long service life, ceramic grain filters is a new and efficient filter material to increase the water yield, upgrade the water quality, and save chemicals and energy

    陶粒濾料是以精製陶土為主要原料,摻加適量改性劑,經粉碎,混練,成型和高溫煅燒而製成的,不含任何對人體和環境有害的物質.其表面堅硬,粗糙,內部疏鬆,多孔,具有機械強度高,比表面積大,孔隙率大的特性.用於水處理中,具有表面性狀好,截污能力強,過濾水頭小,反沖洗水量低,化學穩定性和生物學穩定性好,使用壽命長的特點.陶粒濾料是一種能增加水產量,提高出水質量,節省藥劑和能的新型高過濾材料
  12. After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise

    通過對水壓閥模型的cfd穩態和瞬態解析,可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈,據此定性分析流道結構(速度、壓力、流動的分離與再附壁,旋渦的產生與消等)與能量、負壓分佈等的關系,從而為設計出高率、低能、低噪聲的水壓閥提供理論依據。
  13. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析,得到了如下主要結論:採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍,減小了次級占空比丟,降低了逆變電阻點焊電源的開關;諧振電容是影響軟開關工作狀態的重要因素,其大小不僅影響開關管的零電壓關斷,同時也影響開關管的零電壓開通范圍,因此,諧振電容應該綜合考慮;功率變壓器漏感越大,越容易滿足滯后橋臂的軟開關條件,但是大的漏感也使變壓器的通態增加,降低了軟開關逆變器的率。
  14. With the elevation of the power factor, stator electric current decrease obviously and its range is about 20 %. so voltage loss and electric power wastage decrease effectively on electromotor power supply circuitry consequently

    隨著功率因數的提高,定子電流明顯的減小,減小幅度在20左右,從而有地減少電動機供電線路的電壓及電力
  15. Wear - out failure period

  16. Firstly, the basic theory of full - bridge phase - shift zvs pwm converters are expatiated and another three kinds of circuits of full - bridge phase - shift zvs pwm converters are discussed. there are four kinds of problems which are emphasized : how to expand the zvs range ; how to reduce the circulation in the primary side of the transformer in order to minimize the on state losses ; how to decrease the loss of effective duty circle and how to eliminate the parasitic oscillation of the output rectifiers

    本文首先分析了基本的全橋移相zvsdc dc變換器的工作原理,為解決滯后橋臂不易實現零電壓開關( zvs )的情況,討論了另外三種全橋移相zvsdc dc變換器的電路拓撲,重點分析並解決了四個方面的問題:如何擴大zvs的負載范圍;減小變壓器原邊環流,降低變換器系統通態;減少變壓器次邊有占空比丟;消除輸出整流二極體的寄生振蕩。
  17. All machinery motion is relative movement relying on its " spares pairs. abrasion happened with relative movement, and abrasion is the main cause of surface damage, spares invalid, and material friction loss

    所有機器的運動都是依賴其零件副的相對運動,有相對運動就有磨,磨是導致表面壞、零件和材料的主要原因。
  18. In the end, the fatigue wastage coefficient was derived and the reference values of the calculation parameters were given to determine the fatigue wastage coefficient for different non - survivorship probabilities

    文章最後推導出了疲勞系數的計算式,給出了不同概率下的算式的系數參考值,供道路工程設計人員參考使用。
  19. Real - time, automatically - captured product information results in improved product movements, as well as better inventory management and replenishment practices, thus reducing sales loss due to out - of - stock. epc will also give companies the ability to dramatically reduce shrinkage

    實時自動收集的產品信息不僅有助加快產品流轉、庫存管理和補給的率,更可降低因缺貨造成銷售方面的。此外,電子產品碼也可幫助企業大大降低商品的
  20. Wherefore, other two energy - based fracture parameters are put forward : the stable fracture energy gfs, indicating the average energy dissipation during the crack stable propagation and the unstable fracture energy gfu, corresponding to the crack unstable fracture stage. wedge. ? splitting specimens are tested with a view to understanding those two parameters " size effect in terms of the initial crack length a0

    本文提出兩個能量型斷裂參數即穩定斷裂能g _ ( fs )和穩斷裂能g _ ( fu )分別表示裂縫穩定擴展和穩擴展階段的能量,並採用楔入劈拉試件( ws )對這兩個參數相對初始縫長_ 0的尺寸應進行了分析。
分享友人