搭板接合 的英文怎麼說

中文拼音 [bǎnjiēgě]
搭板接合 英文
strapped joint
  • 搭 : 動詞1 （支; 架設） put up; build 2 （把柔軟的東西放在可以支架的東西上） hang over; put over 3 （...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 接合 : joint; zygosis; juncture; articulation; concrescent; nexus; coaptation; syndesis; synapsis; meet;...
  1. Bonding structure and plastic : maxxon all the joints size lap, to adopt additional protection bao - belt take overlap joints used in combination of both methods and closure tape strengthen the protection, and it is designed specifically for marine use, this design yachts given stern plate on the floor of the high durability

    粘合結構和膠： maxxon的接縫是全部尺寸搭接，為了額外的保護採用保強帶在搭接縫內採用重迭方法並結合內外封膠帶做加強保護，並且它的設計是專為航海使用的，這種設計賦予遊艇艉板的地板部分極高的耐用性。
  2. Reinforcements set in the precast slabs lapped with each other at the side of the slabs. in this way, the floor stands loads in two ways. the prestress in precast slabs can improve mechanical performance and meet the demands of large room width in many building structures

    本論文主要研究單向預應力雙向疊合板樓蓋，其以預應力預制疊合底板為底模，利用板側伸出鋼筋的搭接實現橫向傳力，變單向受力為雙向受力；通過二次澆築混凝土形成整體樓蓋結構；通過預制底板中單向施加先張預應力改善了樓蓋的受力性能，滿足了大開間及不同型式建築的要求。
  3. 3 - wire strands with tensile strength of 1570 mpa were collocated in the lower precast concrete slabs of superposed floor. the manner of reinforcement lap and other detailing were brought forward. plane dimensions of the tested floor are 9m and 12m, and height is 180mm

    本論文通過對前期試驗的分析總結，選用1570mpa的三股鋼絞線作預制底板的預應力鋼筋，提出了合理的板側橫向鋼筋搭接方式和其它構造措施，並按照現行規范設計並製作了試驗結構，樓蓋平面尺寸9 12m ，樓板厚度180mm 。
  4. Pressing sheet metal components in supporting reliable lap, lap length comply with design requirements and should not be less than the numerical standards

    壓型金屬板應在支承構件上可靠搭接，搭接長度應符合設計要求且不應小於規范的數值。
分享友人
分享到 Line

分享到臉書