摩擦提升 的英文怎麼說

中文拼音 [shēng]
摩擦提升 英文
friction winding
  • : 摩構詞成分。
  • : 動詞1 (摩擦) rub 2 (用布、 手巾等摩擦使干凈; 揩拭; 抹) wipe; scrub; clean 3 (塗抹; 搽) spre...
  • : 提動詞(垂手拿著) carry (in one's hand with the arm down)
  • : Ⅰ動詞1 (由低往高移動) rise; hoist; go up; ascend 2 (等級提高) promote Ⅱ量詞1 (容量單位) lit...
  • 摩擦 : 1 (互相接觸的兩物體作來回相對運動) rub; chafe 2 [物理學] (相互接觸的兩物體在接觸面上發生阻礙相...
  • 提升 : 1 (提高職級) promote; advance 2 (向高處運) hoist; elevate3 [數學] lifting; 提升器 lifting mec...
  1. This article takes the lagrange equation as the principle, establishes mathematics modeling to the inertia brake vibration when it brakes, then simulates it with matlab. this paper educed the relation equations between, which are the inertia brake ' s friction coefficient of the brake ring and the friction disk, the mean radius, the braking force, rotation inertia of the driving top and the spline shaft, spiral climbing angle of the brake ' s concave - convex helicoid, the mean effort radius of the concave - convex helicoid, elasticity coefficient of the spring, quality of the driving top and the spline shaft, rotations inertia of the brake ' s rotation part besides the driving top and the spline shaft, suppresses sleeve. provides the theory basis for the inertia brake structure optimization

    本文以拉格朗日方程為理論基礎,對慣性制動器在制動時的振動進行數學建模,然後用matlab對其進行模擬,得出了慣性制動器在制動時振動角頻率分別與制動環和片之間的系數、制動力的平均半徑、主動頂和花鍵軸的轉動慣量、慣性制動器的凹凸螺旋面的螺旋角、凹凸螺旋面平均作用力的半徑、彈簧的彈性系數、主動頂和花鍵軸的質量、慣性制動器除主動頂和花鍵軸外其他部分的轉動慣量和、頂壓套的質量等慣性制動器各零部件的物理參數之間的關系,為慣性制動器的結構優化供了理論依據。
  2. Friction drive hoist

    傳動
  3. Discussion on the safe operation of the friction winding in the mine

    礦井摩擦提升安全運行的探討
  4. Friction pulley linings for winches and winders in mining

    礦井機和卷揚機用輪襯層
  5. Friction and wear performance on fretting wear of steel wires in hoisting ropes

    鋼絲繩的鋼絲微動磨損特性研究
  6. This paper discusses the calculation of moment of friction and provides theoretic reference for heat output calculation and temperature rise

    通過對滾動軸承力矩的分析計算,為計算軸承的發熱量和軸承溫供了理論參考。
  7. Study on hoist and transport equipment protective device in wangjiazhai coal mine and its safe operation protecting way

    型多盤式緩沖裝置在立井中的應用
  8. The study of reliability optimum design of self - energizing overrunning spring clutch is raised to meet the following requirement : smaller size, less producing heat and overrunning friction loss in opposite direction. it is important investigating substance in the field to all the country in the world. it is application of modern advanced design method in engineering practice

    自激式超越彈簧離合器可靠性優化設計的研究,是針對超越式離合器要求空間尺寸小、溫小、反向超越時損耗小而出的,這也是世界各國在該領域中的重要研究內容,是現代先進設計方法在工程實際中的具體應用。
  9. Method of replacing the tail rope of the multi - rope friction hoist

    多繩摩擦提升機尾繩的更換方法
  10. Comments on anti sliding calculation of multi rope frictional hoist

    淺談多繩摩擦提升機配置恆力矩液壓站緊急制動系統防滑驗算
  11. Method of replacing rope of floor type multi - rope friction hoist

    落地式多繩摩擦提升機換繩方法
  12. Application of bs type multy - disk friction buffer in mine hoist

    礦井機分繩器改造
  13. Design of the hoist house of service shaft with multi - rope friction hoist

    淺談設計多繩式副立井機房
  14. Multi - rope mining friction hoist

    多繩
  15. Anti - skidding of friction - based multirope hoist

    淺談多繩摩擦提升中的防滑
  16. Application of dual - purpose friction hoist in mine building

    兩用摩擦提升機在礦井建設中的應用
  17. Regulations on test for registration of import medical devices

    多繩摩擦提升機防滑安全性能的分析和測試
  18. Method of malfunction analysis of friction hoist with many steel ropes

    多繩摩擦提升機故障分析方法探討
  19. Discussion on friction factor increase of multi - rope friction hoist

    高多繩摩擦提升系數的探討
  20. Experimental analysis of four - ropes friction hoist without rope grooves cutting

    四繩無車槽摩擦提升實驗分析
分享友人