撕斷形 的英文怎麼說

中文拼音 [duànxíng]
撕斷形 英文
tear type
  • : 名詞(解凍時流動的冰) ice floating on a river during the spring thaw; drift ice
  • : Ⅰ動詞1 (分成段) break; snap 2 (斷絕;隔斷) break off; cut off; stop 3 (戒除) give up; abstai...
  1. Variation ratio of dimensional after water rinse, ultimate strength, neps and pile, tearing resistance, bursting strength, joint strength, commissure ' s swerve strength, fabric shift ( slip ), ventilate degree, elasticity ( resilient rate / deformation rate ), anti - water permeability ( hydrostatic pressure ), extension and resilience, abrasive resistance, gets wet the nature, hydroscopicity, stock ' s transverse ductility, fire resistance, antistatic

    水洗尺寸變化率(縮水) ,裂強力,起毛起球,破強力,彈子頂破強力,脹破強度接縫強力,縫口脫開程度,紗線滑移性能(滑脫) ,透氣量,彈性(回復率/變率) ,抗滲水性(靜水壓) ,延伸及回復性,耐磨性,沾水性,吸水性,襪子橫向延伸,阻燃性能,抗靜電。
  2. Flexion and extension of the joints were normal in 19 cases and mainly normal in 7 cases. lateral crush injuries usually caused transverse rupture in the middle of icl, whereas torsion injuries usually resulted in both ligament rupture and avulsive bone fractures

    側方擠壓傷可造成韌帶中部橫行裂;扭轉傷常伴有帶骨塊脫;側方擠壓加扭轉傷常致韌帶中部斜裂。
  3. The elephant foot bulging deformation develops with the increasing stress of the rigid wall, which is caused by the uplift of the tank bottom and the impaction between the tank bottom and the foundation

    因罐底提離導致的罐底與基礎反復撞擊加大了作用在罐壁上的應力,使罐壁底部「象足」變發展,最終導致罐壁裂。
  4. The cracks extend along the matrix / strengthening - phases interfaces and form the cleavage steps and tear ridges. there appear some very small dimples on the fracture surfaces of the directionally solidified samples, which come from the nb - based solid solution particles in the big plates of the strengthening phases, but no dimples on the fracture surfaces of the as - cast sample. it can be concluded from above results that niobium - niobium silicide based in - situ composites ( rmics ) with a uniformly orientated microstructure can be produced by the ebfzm with high temperature gradient, and their mechanical properties can be increased

    隨著抽拉速率的提高和硅化鈮強化相間距與尺度的減小,材料的室溫拉伸強度和裂韌性均有提高, _ b最高可達778 . 4mpa , k _ ( ic )達到了46 . 3mpa ? m ~ ( 1 / 2 ) ;試樣的拉伸口基本表現為脆性解理裂的花樣,裂紋沿基體強化相界面繞過強化相進行擴展,在裂紋擴展方向存在解理臺階,並裂棱。
分享友人