擬等溫的 的英文怎麼說

中文拼音 [děngwēnde]
擬等溫的 英文
quasi-isothermal
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • : Ⅰ量詞1 (等級) class; grade; rank 2 (種; 類) kind; sort; type Ⅱ形容詞(程度或數量上相同) equa...
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 4次方是 The fourth power of 2 is direction
  1. In section one, by using fice scheme and time - gcm, a model of trace gases and oh airglow affected by gravity wave is set up, then the propagation of nonlinear gravity wave and the effect on trace gases and oh airglow are analyzed. the result shows gravity wave excited by tropospause forcing can propagate stably to the mesosphere through the stratosphere so that energy and momentum can be transferred from one region to another. in this process, gravity wave undergoes growth, overturning, convection and breaking

    在第一部分工作中,利用全隱歐拉格式和全球熱層-電離層-中間層-電動力學環流耦合模式( time - gcm ) ,對重力波非線性傳播及其在傳播過程中對中高層大氣中氧族和氫族成分和與之密切相關oh氣輝輻射影響進行了數值模,結果表明,從對流層向上傳播重力波經歷了產生、發展、飽和、對流產生直至破碎非線性演化,大氣結構加速了重力波在中層頂區破碎,重力波非線性傳播是小尺度對流和湍流產生一個重要源。
  2. Phase - field simulation of non - isothermal solidification of binary alloy

    二元合金非凝固過程相場法模
  3. Numerical simulation of dendrite growth for binary alloy during non - isothermal solidification

    二元合金非凝固枝晶生長數值模
  4. Numerical simulation of non - isothermal dendritic growth of binary alloy using phase - field method

    二元合金非凝固枝晶生長相場法模
  5. The experimental results show that these models can express precisely the isotherm hydration heat emission curve of portland cement and the autogenous shrinkage process of concrete prepared with portland cement

    實測數據檢驗結果表明,這2個模型可以用於模硅酸鹽水泥水化放熱曲線,以及用硅酸鹽水泥配製混凝土自收縮發展過程。
  6. Calculation and isotherm adaptation of gas - solid adsorptionequilibrium of complicated components

    復雜組分氣固吸附相平衡計算及
  7. The anion surfactant nals was the most efficient in the process and was selected as collector by orthogonal method. the interfacial tension and cmc of nals ( cmc 6. 5 10 - 3m ) in the solution was measured by hanging ring test, the function relationship between interfacial tensions and nals concentration was : = - 0. 9523 in 2c - 24. 534 in c - 81. 411. the relation of interfacial adsorption equilibrium in the solution system was respectively tested and calculated with gibbs equation and dynamic method. the conclusion showed that ( 1 ) the experiment result of dynamic method with was highly in coordination with the value which from theoretical calculation. ( 2 ) the surfactant molecule was in arrangement of monomolecular layer at the gas - liquid interface

    用吊環法測定了十二烷基硫酸鈉水溶液不同濃度與其界面張力關系,合得到回歸方程為= - 0 . 9523ln ~ 2c - 24 . 534lnc - 81 . 411 ,同時還測得其臨界膠束濃度值( cmc為6 . 5 10 ~ ( - 3 ) m ) ,運用吉布斯方程和動態法分別計算和測定了該溶液系統界面吸附平衡關系,結論表明: ( 1 )動態法測定結果基本吻合吉布斯方程理論計算; ( 2 )表面活性劑分子在氣?液兩相界面是以單分子層形式定向有序排列
  8. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發過程進行干濕對比數值模試驗,得出:潛熱釋放使對流層項和面抬高,氣流在高層上升冷卻形成擾動槽,其適應過程使高層出現慣性不穩定。
  9. Numerical simulation of non - isothermal temperature field in tundish

    中間包非度場數學模
  10. Firstly, the computer simulating model of the limited volume unit is established. then pet is chosen as sample. generally, under predetermined nucleation condition, the course of pet isothermally crystallized at 170 c in limited volume unit is simulated

    計算機模實驗首先建立了有限體積元模型,然後選定了pet為樣品,一般模其在預先成核條件下、 170時結晶過程。
  11. In general, a precise resistor is in series with one of the resistors in wheatstone bridge to compensate the zero offset, and the other one is in parallel with another arm of the wheatstone bridge to compensate thermal zero drift. based on this principle, in this paper, a compensation method based on virtual instrument technology has been put forward. actuated by current source, a good calculation method of compensation resistors and their position in the bridge is deduced

    本文基於串並聯電阻補償法原理,提出了一種基於虛儀器誤差補償方案,推導了在恆流源供電下可以精確計算出補償電阻大小和補償位置演算法,並且在虛儀器軟體平臺labview上完成了數據採集、處理、顯示軟體設計,經過實驗驗證,對傳感器零點度漂移補償取得較好效果,而對靈敏度度漂移工藝補償亦有一定效果。
  12. This paper establishes a model simulating dam actual placing process and considering the non - continuity of initial temperature on the boundary of new and old concrete, daily air temperature change, concrete - placing temperature, hydration heat, heat insulation on boundary, water - storing process, placing intermission and curing with water. the calculation of stress field considers the concrete weight, static water pressure, thermal stress, different autogenous volume change between rcc and normal concrete, change of elastic modulus of concrete with age and creep action

    考慮了乞今最為全面初始條件和邊界條件,包括模壩體實際升程過程,考慮了新老混凝土接觸面上初始度不連續,逐日變化,混凝土入倉度,水化熱升,邊界保,水庫蓄水過程,澆築間歇以及灑水養生因素;應力場計算考慮了混凝土自重,靜水壓力,度應力,常態混凝土與碾壓混凝土不同自生體積變形,混凝土彈性模量隨齡期變化以及徐變作用。
  13. E have a full set of precise reliability equipment including constant temperature and humidity cabinet, thermal shocking cabinet, which were built by espec in japan, can simulate any ambient conditions of - 99 300

    我們擁有一整套進口和國內領先水平信賴性試驗設備,其中恆恆濕箱高低度沖擊箱度設備由日本espec公司生產,可模- 99
  14. Thirdly, adsorbents used for separating propylene were studied, and agno3 / sio2 with 15. 4 % ag + load showed superior adsorption properties. the adsorptive behavior of propylene was studied and it ' s adsorption balance isotherm was fitted by langmuir equation either

    然後研究了丙烯吸附劑,發現銀離子負載量為15 . 4gsb硅膠負載agno _ 3 ,吸附劑具有良好分離丙烯能力,研究了丙烯在該吸附劑上吸附行為並用langmuir方程合了其吸附線。
  15. The testing of thermal environment in one urban residential district of changsha city in sep, 2002 is retrospected and concluded. variations of surface temperatures of the buildings various terries, urban streets in that day are discussed, inflow boundary conditions and partial thermal boundary conditions for thermal environment simulation are obtained. the thermal environment status in this region could be macro - discerned

    2002年9月在長沙市某住宅小區進行了熱環境測試工作,討論了當天墻體表面度變化、不同鋪墊表面度、街區測點度變化,獲得了熱環境模計算來流邊界條件及部分熱邊界條件,宏觀定性地了解了該區域當天熱環境狀況。
  16. Taking the suspended sediment as the sand for the experiment and the normal nutritive matter - phosphorus in water as the contamination for simulation, the effect on the equilibrium adsorption of phosphorus from the initial concentration of the water phase phosphorous pollutant and the influence of sediment content on the isothermal adsorption of phosphorus are studied through the experiment

    摘要以懸移質泥沙為試驗用沙,以水體中常見營養物質磷為模污染物,通過試驗研究了含磷污染物水相初始濃度對磷平衡吸附量影響和含沙量對含磷污染物吸附影響。
  17. For adi researchers to refer, the paper describes conceptually some view points on the property characteristics of the adi, its application expansion, squeeze - casting process of adi, numerical simulation and adi casting weight - lightening

    筆者就淬火球鐵材料性能特點、擴大應用、擠壓鑄造、數值模、輕量化五個問題介紹一些情況,並概念性地論述一些觀點,供從事這方面研究同行參考。
  18. Finally, some experiments are carried out to examine the results of molecular dynamic simulation

    與分子模得到吸附線相比,結果具有可比性,並對其差別作了分析。
  19. The characteristic curves and diagrams which described the pressure, velocity, and concentration of the indirect evaporative cooler were presented by the software of tecplot and smartdraw. the differences between the condensation condition and non - condensation condition were compared and analyzed

    對比考慮與不考慮冷凝情況下速度、度、濃度分佈差異,分析了模參數變化對冷凝影響。
  20. This work include : in order to demarcate chemical kinetic model inwhich organic matter generate oil and gas, constant velocity, rising temperature thermal modeling experiment is designed ; in order to demarcate chemical kinetic model inwhich oil crack into gas, isothermic thermal modeling experiment inwhich oil crack into gas is designed ; in order to establish chemical kinetic model inwhich family constituents in oil ( saturated hydrocarbon, arene, non - hydrocarbon, bitumen ) change into gas, isothermic or constant velocity jsothermal modeling experiment is designed

    這一工作包括:為標定有機質成油、成氣化學動力學模型,設計進行了恆速升熱模實驗;為標定油成氣化學動力學模型,設計進行了油裂解成氣熱模實驗;為建立油中各族組分(飽和烴、芳烴、非烴、瀝青質)成氣化學動力學模型,進行了恆或恆速升實驗。
分享友人