支臂 的英文怎麼說

中文拼音 [zhībèi]
支臂 英文
support arm; bracket; [電學] hub spider
  • 支 : Ⅰ名詞1 （分支; 支派） branch; offshoot 2 （地支） the twelve earthly branches3 （姓氏） a surname...
  • 臂 : 臂名詞1. （胳膊; 從肩到腕的部分） arm 2. （人體解剖學上多指上臂） upper arm
  1. The trunnion assembly is supported by air bearings at the end of each arm and is held in position by brake shoes at each bearings.

    耳軸組件的支承是每根臂末端的空氣軸承，軸承上的閘瓦起定位作用。
  2. Supporting the patient ' s arm during the axillary examination allows the arm to be fully relaxed so that nodes deep within the axilla can be palpated

    腋下檢查時，支撐病人手臂，使其充分放鬆，這樣就可以摸到腋窩深處的淋巴結。
  3. To study the flexural behavior, ultimate bearing state and laws of internal force redistribution of prestressed concrete continuous beams cast by different construction methods, the model tests for three pieces of the continuous beams were carride out, in which three kinds of the construction methods, such as those of lowering formwork supports at one time, transferring simply - supported structure into the continuous one and casting the beam by cantilever construction, were considered

    摘要為研究不同施工方法下預應力混凝土連續梁的彎曲性能、極限受力狀態及內力重分佈規律，進行了3根連續梁模型試驗，分別考慮一次落架、簡支變連續和懸臂施工3種施工方法。
  4. He had to hold himself upright with both hands.

    他的雙臂必須拚命支撐著，才能保持挺直的姿勢。
  5. The effect of the support at the crest introduces in particular an inversion of the normal curvature of a free cantilever in free deformation.

    特別是壩頂支承作用使一個自由懸臂梁的變形曲線。
  6. Midge : it ' s brand new. revolutionary up - lift : no shoulder straps, no back straps, but it does everything a brassiere should do. works on the principle of the cantilevered bridge

    米姬：這是全新的。革命性的改良。沒有肩帶，也沒有背帶，但是所有胸罩的功能它都有。運用懸臂式橋梁的原理來支撐。
  7. For reinforcement concrete corbel with the shear span to depth ratio ( a / ho ) less than 1, has its performance of mechanics that is close to cantilever deep beams, it is an important kind of components in architectural structure which sustains roof trusses, brackets, tray " beams, frame " beams, wall " beams and crane " beams

    剪跨比a h _ 0 1的短鋼筋混凝土牛腿，其受力性能接近於懸臂深梁，在建築結構中是支承屋架、屋面梁、托架、托架梁、框架梁、墻梁和吊車梁等的重要構件。
  8. If the superstructure is crossways, make sure that the foot section is not lying on the track groups or the outrigger struts of the auxilliary support ( if required, props up the boom to a higher level )

    如果上車為十字交叉型的，則務必確保臂桿根部沒有接觸到履帶組或輔助支承上的支腿壓桿（如夠必要，可把臂桿墊得更高些） 。
  9. Boom type excavating machine

    支臂式掘進機
  10. The fracture failure analysis and prevention of front sloping supporting arm

    飛機前支柱斜撐桿支臂斷裂分析及預防
  11. Most sea stars have five arms ( or a multiple of five )

    大部分的海星有5支臂或若干組5支臂。
  12. Moving velocity programming of the supporting cylinders of double triangle boom

    雙三角鉆臂支臂缸運動速度的策劃
  13. Research on the dynamic stablity of arms in the radial gate under eccentric loading

    偏心荷載作用下弧形閘門支臂的動力穩定性研究
  14. Based on the analyzing results, the eccentric loading increased the dynamic - instability district of the arm and would be adverse to its dynamic - stability

    結果表明，荷載偏心增大了支臂的動力不穩定區域，不利於支臂的動力穩定。
  15. The dynamic - instability of radial gate was always due to the instability of arm under dynamic loading action, the security of gate spillway was dominated by the dynamic stability of arms

    摘要弧形閘門的動力失穩往往是由於支臂在動力荷載作用下喪失動力穩定的，支臂的動力穩定與否控制著整個水閘的泄洪安全。
  16. But the welding program is complicated and the construction is very difficult so that the welding deformation and welding quality should be seriously controlled

    轉子中心體與支臂連接採用工地組焊施工，可使轉子支架整體性能好，能夠保證轉子組裝質量，但焊接程序復雜、施工難度大，必須嚴格控制焊接變形和焊縫質量。
  17. For a project instance, it computes and analyzes the structure of madian radial gate with fem, which achieves the result of gate ' s structural stress, stiffness and surpport - bar ' s stability and gives comparative analysis

    作為工程實例，對馬甸弧形閘門的結構進行了有限元計算和分析，得到了閘門的結構應力、剛度以及支臂穩定的計算結果，並給予了比較分析。
  18. In this paper, ansys, the software on finite element analysis, is made use of processing the static and modal analysis on the preliminary models and its " modified ones. by analyzing the results, we can conclude that the stresses on the components of the modified models are tended to equilibration and the location of the branches " brace can also influence stresses and translations on the branches. in addition, the values of the intrinsic frequencies on modified models " are larger than the ones on preliminary models, but the ranges of the frequencies on both models are almost same

    傳統的弧形閘門的支臂結構基本上都是三角架式的，這主要是因為按平面體系進行計算的傳統設計方法忽略了結構的整體性及弧形閘門的空間結構特點，設計得比較保守，而實際上，將其改為a型結構也存在可行性，本文是利用有限元分析軟體? ? ansys對原模型及修改模型分別進行靜態和固有頻率的計算，通過分析比較其結果可知，支臂改為a型后會使閘門的整體受力趨于均勻，即原模型受力大的部件其應力變小，而原模型受力小的部件其應力會變大；而且a型支臂的支桿在不同的放置位置對支臂的應力和位移變化也有一定的影響。
  19. The long boom of the crane functions like our arms

    起重機的長支臂功能像我們的手臂。
  20. According to the research development of flow - induced gate vibration in recent years, the paper presents a retrospect and a summary on the relationship between hydrodynamic loads and gate vibration characteristics, the hydrodynamic load characteristics and controlling means, the optimum design methods for gate anti - vibration, the dynamic stability analysis of the radial gate ' s arm, the methods to simulate the gate ' s hydro - elastic vibration, as well as the simulation analysis of flow - induced gate vibration

    摘要從水動力荷載與閘門振動特性的關系、水動力荷載作用特點及其控制方法、閘門減振優化設計方法、弧形閘門支臂動力穩定性分析、閘門水彈性振動模擬方法以及閘門流激振動模擬分析等方面，對水工閘門流激振動的研究進行了回顧。
分享友人
分享到 Line

分享到臉書