收到功率 的英文怎麼說

中文拼音 [shōudàogōnglǜ]
收到功率 英文
received horsepower
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 功 : 名詞1 （功勞） exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 收到 : receive; get; achieve; obtain
  1. Power controls, including discontinuous receiving and transmission ( drx dtx ). provide longer handset working without frequent alternation of battery

    包括不連續收發技術在內的系統功率控制，使得手持式ms的功耗問題得到一定的緩解。
  2. In this thesis, wide - fov ( field - of - view ) optical systems with optical gain based on fov and optical gain of laser detection and warning optical system are studied. it can solve the problem of wide fov matching with small photosensitive surface, enhance the power received, increase detecting sensitivity, reduce the power of laser and decrease the cost of laser accordingly

    本文正是針對上述問題，從激光輻射探測光學系統的視場和光學增益出發，研究寬視場有增益光學系統，解決大視場和小光敏面匹配的矛盾，增強接收到的光功率，提高探測靈敏度，降低對激光輻射源功率的要求，從而降低相應激光器的成本。
  3. By calculating parameters including the link length, the azimuth angle, the elevation, the optical power that the inter - satellite optical cdma communication system will receive, the variation range of the azimuth angle and the elevation from the optical antenna of atp are understood well. by analyzing the factors to impact bit - error - rate ( ber ) from the received power, multi - user disturbing, background noise, wavelength, bit rate etc, measures to guarantee high performances of the system are obtained, especially those for smoothing the fluctuation of the received optical power from host platform vibration

    分析研究了衛星光cdma通信系統中衛星仰角、方位角和距離，給出了探測器能夠接收到的光功率以及atp子系統捕獲及跟瞄的范圍;對衛星光cdma通信系統性能模型和基於衛星振動系統性能模型的研究，分析了多用戶干擾、接收光功率、背景光噪聲、振動偏差以及碼速率對系統誤碼率的影響，給出了相應的改進措施。
  4. 3. the admirable incidence angle of the laser on the surface of the detector is zero

    入射光線要垂直入射到功率計接收面的中心，且反射光線應與入射光線基本重
  5. Adopts vdsm process technology however two outstanding problems are faced to ic layout design when the feature size reaches to 0. 18 m or lower : 1. timing convergence problem seriously affects the circuits schedule, and the interconnect - delay has exceeded more than 70 % of the total circuits ’ delay. 2. si problem, usually it consists two aspects of ir - drop and crosstalk. these problems often affect the chip function after tapout

    本篇論文就是針對超深亞微米階段soc晶元後端設計所面臨的挑戰，提出了運用連續收斂的布局布線策略，尤其是虛擬原型的設計理論，來快速驗證布局，進而提高布線的成功率，並且提出了一種改進的布局評估模型，提高對soc晶元預測布線的準確度;同時，對于時鐘驅動元件選擇，文中提出了一種基於正態分佈模型來達到更有效的選取。
  6. Thirdly, the relative theories of the limiter and rectifier are studied. in order to make the passive responder work stably under the conditions of large dynamic range of the receiving power and the high efficiency requirement, a two - stage limiter circuit and a voltage - doubler rectifier circuit with several diodes parallel are developed

    3 ，對應答器地面裝置中的能量轉換電路進行了研究，針對應答器地面裝置接收到的載波功率具有大動態范圍的特點以及系統能量轉換的高效率要求，設計了一種兩級級聯二極體限幅電路和多管並聯的倍壓整流電路。
  7. When the power supply begins to fail, you may receive power at one device and not another. for example, the hard drive may receive power but the cdrom drive has nothing at all

    當電源開始看，你可以得到一個功率器件，而不是相隔來說，可能硬盤接收功率無關，但在所有的光盤驅動
  8. It is also discussed how to get the optimum polarization state of the antenna when the scr is optimum. not only the power of cylinder in air but in rain are used in calculating the scr

    對于非相干目標，文章用kennaugh矩陣得到接收功率，然後用拉各朗日乘子法求出最佳極化狀態和最優接收功率。
  9. Power control and multiuser detection are two key technique to cope with the multiple access interference and near - far effect in cdma mobile cellular communication systems, power control is a resource allocation technique that balances the received powers of the users so that no one user creates excessive interference

    功率控制和多用戶檢測是cdma移動通信系統中克服遠近效應、多址干擾的關鍵技術。功率控製作為一種可以平衡接收功率，減小對其他用戶干擾的技術得到廣泛的應用。
  10. To construct and analysis the ttd demo module, the mems devices substitute for the former electric devices, then succeed to obtain the rf mems front - end r / t system which can communicate with each other

    最後，用mems器件代替傳統電子器件，成功建立1 . 88ghzpcb級rfmems前端收/發模塊，達到了合理的發射功率和接收靈敏度，成功收發信號。
  11. At first, modeling of these divvies by rate equations to obtain expressions for threshold and slope efficiency is given. on the case of this theory, the large numbers of literatures and datum are consulted, and the laser is home studied. through rationally selecting and improving the reflector surface, ensuring the beam quality, increasing farthest the absorption path, and improving effective pumping frequency ; through designing the water cooler of yag bar, the volume of laser is half the same internal and international production, and the output power is get to the extremum of the same international production

    並在此基礎上查閱了大量文獻和資料，對該種激光器進行了深入的研究，通過對yag棒直徑的合理選取併合理地改進反射鏡面，從而既保證了光束質量又最大限度的增加了吸收長度，有效的提高了泵浦效率；在不影響泵浦的前提下，通過有效縮短yag棒的長度減小輸出損耗；對yag棒的水冷系統進行優化結構設計，使激光器體積減小到國外同類產品體積的一半，而輸出功率已達到國外同類產品的極限值。
  12. Traditional laser iff has poor security because of low frequency of laser beam coded pulse. this can be greatly improved when the pulses are modulated by continuous wave laser, but the power of this laser beam output is so low that it ’ s difficult to be detected and received by laser warning subsystem

    傳統的激光敵我識別器激光編碼脈沖頻率低，通信保密性差，使用連續波激光器經調制后激光編碼脈沖頻率高，保密性好，但輸出激光功率較低，難以達到激光告警分機探測接收的要求。
  13. The experimental study is performed on the c - band tapered milo designed with the help of the simulation. the whole system is calibrated separately by parts. from milo to microwave receiving hom, the special system is simplified to be a two - port network and its s parameter is measured to calculate the attenuation factor a

    對于微波功率的標定問題，我們根掘實驗條件，將整個系統劃分為幾個部分分別進行了標定，包括：從milo到接收喇叭組成的特定系統，將該特定系統簡化為一雙口網路，並測量出了其s參數，從而計算出與頻率密切相關的衰減量a ；對固定衰減器在不同微波頻率下的衰減量進行了標定。
  14. While speaking highly of railway ' s achievement since the 16th cpc national congress, chairman jia noted that the chinese people have built the world ' s top - notch qtr line while relying on our own strength, and chinese railway people have developed and manufactured 200km / h and 300km / h emu trains and high horse - power locomotives through introduction, digestion, absorption and re - innovation, thus making a major contribution to the building of an innovation - oriented country

    他對黨的十六大以來鐵路工作取得的成績給予充分肯定，指出，中國人依靠自己的力量，建設了具有世界一流水平的青藏鐵路；通過引進消化吸收再創新，設計製造了達到世界先進水平的時速200公里、 300公里動車組和大功率機車，中國鐵路為建設創新型國家作出了巨大貢獻。
  15. The low - power, silicon microchip radios in the devices can transmit and receive data about as fast as a dial - up modem, but their range is limited to less than 30 meters ? sometimes much less

    塵粒內的低功率矽晶片無線電，發送與接收數據的速度大約和撥接數據機一樣，但是作用距離卻不到30公尺，有時還會更短。
  16. Based on the convergence criterion of root - mean - square ( rms ) of phase and output power, the actual intensity on reflectors are solved with fox - li iteration so that the deformations of mirrors and one - way phaseshifts are calculated. by simulating one - way phaseshifts with zernike polynomial, the laser modes are studied with method of iteration and geometriy. the evaluation factors of components influences on beam quality is discussed

    根據相位均方根值迭代收斂準則和輸出功率，用fox - li迭代法求出反射鏡上實際的光強分佈和熱源，得到鏡面的位移變形和單程附加相移，以zernike多項式擬合單程附加相移，分別用迭代法和幾何法計算了腔鏡變形時的腔模光場，建立了光學元件對光束質量影響的評價因子，研究腔鏡冷卻效果和冷卻方式，對輸出耦合鏡的變形進行了分析。
  17. Some researches about frequency doubling are made, and two methods to improve intensity of second frequency generation are given. we realized q - switched 532 nm laser, by using nd : gdvo4 as laser crystal, using cr4 + : yag as saturable absorber, using ktp as intra - cavity frequency doubling crystal. average power of 109mw, repetition of 40khz, pulse width of 30ns, pulse energy of 2. 6uj, peak power of 91w are obtained

    4 .對倍頻理論進行研究和分析:討論兩種提高二次諧波功率密度的方一法;實驗匕在國內首次實現ld端面泵浦nd : gdvo4 / ktp ，用cr4 + : yag作為可飽和吸收片的綠光激光器，腔內倍頻得到了平均功率為109mw 、重復頻率為40khz 、脈寬為3ons 、單脈沖能量為2 . 6閃、峰值功率為glw的調q綠光輸出。
  18. The nonuseful loss of cavity were got by measuring the threshold of laser under the different output mirrors. the loss was caused by prague angle unmatching. 3. the pulse train with minor pulse width 22ns and frequency 23khz, peak power 3. 5kw were obtained in cr4 " : yag passively q - switch experience. the stability of pulse is 6 %

    （ 3 ）實現了在大功率泵浦、無水冷的情況下cr ~ （ 4 + ） : yag飽和吸收體被動調q ，得到了最小脈寬為22ns 、重復頻率為23khz 、峰值功率為3 . 5kw的激光脈沖輸出，脈沖的穩定性為6 。
  19. In chapter 4, a joint power control algorithin is proposed, in which the performance of muhuser detection and the itefation mechanism of the coefficients of receiver filter in mulhuser detection are considered, and a new joint power control algorithin based on mmse multiuser detection is proposed finally

    本文在第四章中提出的聯合功率控制演算法考慮到了多用戶檢測的效果，將多用戶檢測過程中接收機濾波器抽頭系數的更新機制引入到功率控制演算法中，提出了基於多用戶檢測的聯合功率控制演算法。
  20. In order to really describe the time - varying feature of the channl, in chapter 7, kaiman filter is used to timely estimate the channl parameters and the performance of power control is improved with consideration of the chaiml parameters estimatd in power control algorithin

    為了能夠更好地反映系統內通道的時變特性，在第七章中，採用卡曼濾波的方法來對通道特性進行實時預測估計，並將這一預測的結果應用到功率控制演算法當中，收到了滿意的效果。
分享友人
分享到 Line

分享到臉書