改性劑調節劑 的英文怎麼說

中文拼音 [gǎixìngjìdiàojiéjì]
改性劑調節劑 英文
modifiers
  • 改 : Ⅰ動詞1 （改變） change; transform 2 （修改） revise; alter; modify 3 （改正） rectify; correct 4 ...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Theoretical analysis and testing results demonstrated that viton, a new substitute of the former plasticizer, could noticeably improve its performances, which has been proved as the important improvements of the mixture. due to the favorable thermochemistry performance, dicyandiamide can act as a good combustion - rate regulator. the addition of antistatic agent can desirably increase the antistatic capability of the mixture, and the testing results showed that the performance of the improved mixture was excellent

    理論分析和測試結果均表明了以氟橡膠取代耐水點火藥中原粘合劑將使藥劑的各項性能有明顯的改善，是耐水點火藥改進的重要方面；雙氰胺具有良好的熱化學特性，作為耐水點火藥改進中的燃燒速度調節劑具有很好的調速效果；抗靜電劑的加入，進一步提高了藥劑的抗靜電能力，測試分析表明改進后藥劑的性能更加優異。
  2. The results indicate that tuning chelate size can not only change the enantioselectivity, but also change the enantiofacial selectivity completely

    研究結果還表明除通過改變配體手性中心的構型，調節配體配位空間也可以改變催化劑的對映面選擇性。
  3. In order to study the expression of 3 - defensins in liver as acute phase response proteins, a murine systemic acute phase responsive model was established by intraperitoneal injection o f lipopolysaccharide ( lps ) in our study. the mbd3 cdna sequence ( 145 - 169 bp ) was labled with [ - 32p ] atp as a probe to detect mbd3 mrna in different tissues by northern blot and analyze the time - and dose - dependant expression caused by lps. the 5 " flanking sequence ( - 167 - 179 bp ) of the mbd3 gene was designed as the probe and labled with [ - 32p ] dctp to investigate the binding of transcriptional factors to this region by electrophoretic mobility shift assay ( emsa ) and south - western blot

    以小鼠mbd3基因145 ? 169bpcdna序列合成探針，經[ - ~ （ 32 ） p ] atp標記后通過northernblot方法檢測mbd3在肝臟中的表達，同時分析了mbd3基因誘導表達的組織特異性，劑效和時效關系；結合mbd3基因啟動子區序列分析，以- 164 ? - 179bp雙鏈dna序列合成探針，經[ - ~ （ 32 ） p ] dctp標記后通過電泳遷移率改變實驗（ emsa ）和south ? westernblot方法對參與mbd3在肝臟中誘導表達調節的轉錄因子進行分析。
  4. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  5. Simulation results show that based on the regeneration kinetics of the catalyst, properly raising the reoxidation temperature of the catalyst in the fluidized bed reactor either can obviously improve the performance of the system or can reduce the solid flux and hence the energy consumption

    結果表明，使烴類選擇氧化（催化劑被還原）和催化劑氧化再生分開進行，特別是根據催化劑氧化再生動力學的要求，適當調節再生過程的溫度，既能明顯改善反應系統的性能，又可以大幅度降低催化劑固體顆粒的循環量，取得節能降耗的效果。
  6. 4. in order to further improve and raise storage, energy and combustion properties of boron - based fuel - rich solid propellant, while the present slurries of boron - based fuel - rich solid propellant can be cast and cured to form defect - free propellant grain, ap grading and metal fuels changing including variety and addition amount have been adjusted and investigated. the result shows that, after the adjustment, all the slurries can be cast to obtain structural perfect propellant grain which may be used to test various propellant properties

    4 、為了使現有含硼推進劑的燃燒等性能進一步提高和改善，同時為了能使現有含硼推進劑藥漿澆鑄后得到結構完整性和均勻性更好的藥柱，在2 、 3研究的基礎上，對ap的級配、低燃點金屬燃燒劑的品種和加入量等進行了較深入的研究，結果表明：這些組分進行調節后的各藥漿的流平性變化均能滿足澆鑄要求，並製成能進行推進劑其它性能測試的小方坯。
  7. To improve the performance of ashp, an improved ashp system is presented. different from the original system, the new one can control the refrigerant flow rate by the sub - cooling of condenser and adjust the sup - heating of the compressor inlet vapor by the heater in accumulator. the simulation shows the new system not only has better dynamic characteristic of frost and defrost of ashp, but also has higher coefficient of performance

    為改善空氣源熱泵機組的結霜除霜動態性能，提出了一種利用冷凝器過冷度來調節製冷劑流量，在氣液分離器里增加電熱裝置保持壓縮機進口過熱度的改進型系統，結果表明這種改進型系統不但可以改善系統的運行性能，同時能改善系統運行的經濟性，為機組的技術升級和產品更新提供了一個新的途徑。
  8. But its sintering temperature is so high that it cannot be sintered under 1000 with low melting point electrode materials like ag, cu etc. presently investigations about this material are mainly via glass - ceramic technique to decrease the sintering temperature and the dielectric loss is high. for the first time, this investigation manufacture a casio 3 system low dielectric and high frequency microwave dielectric ceramic via tape casting with basic material altered and additives doped

    本文以casio _ 3體系為研究對象，首先對casio _ 3體系進行改性，並首次採用li _ 2o和bi _ 2o _ 3作為燒結助劑，降低體系燒結溫度，在此基礎上，採用catio _ 3調節陶瓷的頻率溫度系數，制備出微波介電性能優良的具有工業應用價值的casio _ 3系ltcc低介高頻微波介質陶瓷。
  9. The processing techniques to manufacture gap net polymer and gap fuel - rich propellant were determined by means of careful selections of curing parameter, proper curative and crosslinking agent, addition of stabilizer and etc. the mechanic property of gap propellant was modified by addition of chain extender. as a result, the gap fuel - rich propellant was developed. by means of dsc and pdta methods, the thermal decomposition characteristics of gap model fuel - rich propellant and its ingredients at both 0. 1 and 0. 5 mpa were investigated

    通過調節固化參數，選擇合適的固化劑和交聯劑體系，添加安定劑以及改進工藝步驟等方法，解決了gap預聚物及gap貧氧推進劑制備工藝中的關鍵技術；採用添加擴鏈劑的方法改善了gap貧氧推進劑的力學性能；最後研製出一個可實用的gap貧氧推進劑配方。
分享友人
分享到 Line

分享到臉書