故障幾率 的英文怎麼說

中文拼音 [zhàng]
故障幾率 英文
probability of failure
  • : Ⅰ名詞1 (事故) event; incident; happening; accident 2 (原因) cause; reason 3 (朋友; 友情) fr...
  • : Ⅰ動詞(阻隔; 遮擋) block; hinder; obstruct Ⅱ名詞(遮擋物) barrier; block; obstacle
  • : 幾代詞1. (多少, 用於詢問數量和時間) how many 2. (表示不定的少數目) a few; several; some
  • : 率名詞(比值) rate; ratio; proportion
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  1. The ground faults in the generator stator are by far common faults to which generators are subjected. internal short - circuit faults, which may immediately damage generator, are always preceded by the ground faults. the possibility of internal fault and damages caused by it can be decreased largely if the stator ground fault protection reliably and sensitively operates

    定子繞組單相接地是發電機最常見的一種,而且往往是更為嚴重的繞組內部短路發生的先兆,定子繞組單相接地保護的可靠與靈敏動作可以大大降低內部短路的發生,減少造成的損失。
  2. The system hardware circuits of tipct and the measures for improving the quality of original thermal image are mainly discussed. the primary research content and innovation are as follows : the innovation is that some methods have been proposed to impove the quality of orginal thermal image, such as controlling excitation time, increasing temperature, reducing noise and enhancing emissivity, and so on

    本文主要圍繞電路檢測儀的系統硬體電路和熱圖像質量改善方法進行闡述,主要的創新點和研究內容如下:本文主要的創新點是:提出了改善熱圖像質量的種方法,如激勵時間控制、增溫法、降噪法和提高發射法等。
  3. Abstract : this paper introduces the annual failure rate of a few kinds of domestic electric dynamometers as well as the failure situation of their control system including each measuring instrument

    文摘:介紹了種國產電力測功器的年及其控制系統包括各類檢測儀表的失效情況。
  4. With the wide application of electric load management information system ( elmis ), the installation quantity of terminal units is growing and the malfunction probability is increasing simutaneously

    摘要隨著負荷管理系統應用的愈來愈廣泛,負荷管理終端的安裝數量隨之增大,終端出現也相應提高。
  5. Abstract : based on the analysis of the physical structure, operati ng principle and dynamic characteristics of the power unit of an excitation cont rol system, a model of this power unit is firstly established with bond graph app roach. the operation of this unit in both normal and abnormal conditions is simul ated on the platform of matlab with simulink. this simulation results have compar ed with the real operation behaviors

    文摘:在對同步發電機自並勵系統功單元的物理結構、工作原理及動態特性進行分析的基礎上,建立了勵磁功單元分散式物理圖網模型,並在matlab的simulink平臺上對勵磁功單元正常和情況下的工作進行了模擬研究,並與實際工作情況進行了比較
  6. From theoretical analysis, we know the existing demodulation methods have limitations as following : one is that the subtraction of the two signals frequencies will display as the result of demodulation when we demodulate two time - domain adding signals without modulating information ( fault information ) ; the other one is that aliasing phenomenon will occur as a result of getting absolute value, detection or square in the process of generalized demodulation analysis, such phenomenon will result in some superfluous frequency composition on the frequency spectrum, which will puzzle the detec tion of mechanical vibration. if the sampling frequency is selected from a suitable range, the aliasing phenomenon will be avoided ; the last one is that aliasing frequencies will be produced in zoom demodulation analysis because this algorithm cannot employ digital low - pass filtering to avert the folding frequencies of higher harmonics in the process of zoom sub - sampling

    現有的解調分析方法存在以下三種局限性:將不包括調制信息(信息)的兩時域相加信號,也以其頻之差作為解調信號而解出;廣義檢波濾波解調分析中,由於取絕對值、檢波或平方過程可能產生混頻效應,在解調譜中表現為無法分析的頻成分,並由此推導出避免這種混頻現象的采樣頻的選取范圍,從根本上避免此類誤診斷的產生;種細化解調分析新演算法中,因為無法在細化分析的選抽時進行數字低通濾波,有可能會出現調制頻的高次諧波成分發生頻混疊而反折到低頻部分的現象。
  7. In accordance with the technological difficulties encountered in the process of insulation supervision based on the dissolved gases analysis ( dga ), several kinds of model and method are presented to improve the reliability and precision of fault diagnosis of the power transformer. main research content includes : by deeply studying the common transformer faults diagnosing methods, such as three - ratio methods and improved electrical committee agreements, several shortcomings such as uncertainness judgment when the fault reasons, phenomenon and principles come out together while can not consistent to each other etc. for this reason, the old methods can not fully meet the need to engineering practical application. considering fuzzy relationship matrix can fully represents the causality between fault symptoms and fault types, when diagnosing complex equipments with multiple symptoms and fault causes such as power transformer, a synthetic fuzzy diagnosing model is firstly proposed to diagnose transformer ' s insulation faults based on dga in this paper

    本文針對應用油中溶解氣體分析方法進行變壓器絕緣監督時所遇到的主要技術難點,提出了提高變壓器診斷的準確性、可靠性的種模診斷方法,主要研究內容有:通過對判斷變壓器常用的三比值法和改良電協研法的深入分析,其診斷準確較高,但對原因、現象和機理間同時存在不確定性和模糊性的變壓器等電氣設備的診斷,難于滿足工程應用的需要;在處理變壓器等結構復雜設備的多癥狀、多原因診斷時,模糊關系矩陣可以全面反映這種癥狀與類型間的因果關系,進而提出了變壓器診斷的模糊綜合診斷模型;同時作者還深入分析了模糊運算元的特性;針對常用的模糊評判結果的模糊集的集化方法的不足性,提出了將模糊綜合診斷與模糊規則推理結合起來進行診斷的方法,能達到較好的效果。
  8. For the backbone nodes, high - capacity dacs4 - 4 - 1 cross connect equipment with stm - 1s as its basic interfaces is used. between the various equipment, stm - 1 connections are directly used instead of tens of 2 mbits connections so that large amounts of hw equipment, power consumption, connecting lines between shelves and fault rate can be reduced, while network redundancy can be improved

    骨幹節點採用以stm 1為基本介面的大容量dacs4 - 4 - 1交叉機。各種設備之間直接使用stm - 1連接,不再使用十個2mbits連接,可以大大減少設備硬體數量,降低電源消耗,機架之間連接線顯著減少,降低發生,提高網路冗餘度,也可以降低建設和維護成本。
  9. Furthermore, this paper provides several forms of failure ratio in the operating phase taking the difference between the testing profile and the operating profile into account according to the concepts of the testing reliability and the operating reliability, then analyzes theoretically the difference between the testing reliability and the operating reliability based on the changing trends that the failure of decreasing and first increasing and the decreasing of the failure ratio, and makes a research on the influence of the two types of reliability on the software releasing time

    在此基礎上給出了考慮測試剖面與運行剖面差別的種運行階段失效的形式,然後根據失效遞減的和先增后減的變化趨勢,從理論上分析了測試可靠性與運行可靠性的差別,研究這兩種可靠度對軟體發布時間的影響。絕大多數軟體可靠性增長模型都假設軟體服從同一種分佈。
  10. Trend prediction and fault diagnosis tech., etc. the information intelligent processing technology facing the application is presented as an emphasis. after introducing the development situation and the whole pattern on related fields, this paper describes several algorithm applied in the simulation experiment, including direct multi - steps nonlinear autoregressive - moving average ( narma ) prediction model based on diagonal recurrent neural networks and fuzzy neural networks model based on generalized probability sum ( gps ) and generalized probability product ( gpp ), and lists the algorithm steps facing the application

    作為重點,本文辟用了較大的篇幅討論面向應用(主要是趨勢預測與診斷)的集成智能信息處理技術,在介紹相關領域的發展情況和總體格局之後,重點闡述了種基於神經網路的智能演算法,包括基於對角遞歸神經網路( drnn )的直接多步非線性自回歸滑動平均( narma )預測模型,以及基於廣義概和( gps )與廣義概積( gpp )兩種運算元的模糊神經網路模型,給出了它們的詳細演算法及面向應用的運算步驟。
分享友人