故障部位 的英文怎麼說

中文拼音 [zhàngwèi]
故障部位 英文
trouble location
  • : Ⅰ名詞1 (事故) event; incident; happening; accident 2 (原因) cause; reason 3 (朋友; 友情) fr...
  • : Ⅰ動詞(阻隔; 遮擋) block; hinder; obstruct Ⅱ名詞(遮擋物) barrier; block; obstacle
  • : Ⅰ名詞1 (部分; 部位) part; section; division; region 2 (部門; 機關或組織單位的名稱) unit; mini...
  • : Ⅰ名詞1 (所在或所佔的地方) place; location 2 (職位; 地位) position; post; status 3 (特指皇帝...
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  • 部位 : (位置) position; place; region; location; localization; topo-
  1. Any machine can t leave lubricant, as if human needs drinking water. fixed time and quantity automatically lubricant equipment controlled by plc program gives all parts of machine to provide necessary " nutrition " and at the same time, it is very bright and has trouble only centesimal point and when it can t drink water, it can give an alarm

    任何機械都離不開潤滑,這就如同人類必須要喝水一樣,由plc程序控制的定時、定量自動潤滑裝置給機器的所有都供給必須的「營養」 ,同時還有:它特別聰明,百分之一「點」出,喝不到「水」 ,也會報警。
  2. In order to verify the effectiveness of steep - front impulse voltage test in finding the internal faults of composite insulator, some insulators with faults, including conductive channel, semi - conductive channels, airy channel, partial little air bubble that occur separately at different place, are modeled. steep - front wave impulse voltage test is made for these faulty insulator and normal insulator

    為了檢驗陡波試驗對于發現合成絕緣子內的有效性,分別模擬了絕緣子內不同有導電性、半導電性通道,小氣泡,金屬雜質,長氣泡以及芯棒與護套間不粘連的絕緣子,並從三維靜電場計算和用不同陡度的陡波試驗兩個方面進行了驗證。
  3. It is a new way in the development of aircraft flight line maintenance expert system. expertise and fault isolation manual that help maintainers quickly find fault causes and failure components were adopted to a great extent

    本研究充分利用維修專家的經驗並結合飛機排手冊,幫助航線維護人員快速準確地根據飛機現象定原因及件。
  4. It integrates the functions of servo amplifier, dynamic operator, position transmitter and remote communication. many new functions have added to its original ones, such as the real - time logical judgment, malfunctions self - diagnosis, alarm & protection, led display, on - line setting and adjustment of functional parameter and position transmitter, power - absence data auto - protection, watchdog system protection, and the long - range communication with pc

    系統集伺服放大器、電動操作器、置發送器及遠程網路式通信功能於一體,在保留對應分原有功能的同時,還新增了邏輯實時判斷、實時監控、 led動態顯示數據、功能參數設置、掉電數據自保護、 「看門狗」電路保護、置發送器在線調節、與遠程工控機數據通信等眾多功能。
  5. On the other hand, by meticulous diagnosis functions, such as signature analysis, trend analysis, spectrum analysis, the fault classification, position, severity and trend about the high - pressure getting rid of squama while running can be discovered and forecasted

    另外,該系統的精密診斷功能,包括歷史數據回放分析、趨勢分析、時域分析、頻譜分析,能對水泵的類型、、嚴重程度以及發展趨勢進行分析和預測。
  6. Secondly, introducing the image analyzing technology with reference to the disadvantages of the traditional ferr - graph analysis technology, and with the combination of characteristic parameter optimizing filtration so as to raise a description method of debris micro - morphologic character. thirdly, with the application of mode recognition method, completing the process of debris auto - recognition based on the collected information of the debris configuration characteristics ; and conducting the diagnosis on the aero - engine wear faults according to the theory of particle tribology. fourthly, introducing information fusion technology to solve the problem that a single method can not collect enough fault premonitory information to conduct the wear fault diagnosis, hence to conduct the research and exploration in the field of comprehensive diagnosis on the aero - engine ' s multi - fault premonitory information

    本文的研究工作主要包括以下五個分:首先,介紹航空發動機常見的磨損類型,研究磨損的失效機理,分析磨粒的產生機理、分類以及形態特徵:其次,針對傳統鐵譜分析技術的缺點,引入圖像分析技術,再結合特徵參數優化篩選,形成基於圖像的磨粒顯微形態學特徵描述方法:然後,基於提取到的磨粒形態特徵信息,應用模式識別方法完成磨粒自動識別,並根據顆粒摩擦學的基本原理進行航空發動機磨損的診斷與定:再后,鑒于單一方法不能提取足夠的徵兆信息進行磨損診斷,本文引入信息融合技術,開展航空發動機多徵兆信息綜合診斷方法的研究與探索;最後,基於航空發動機滑油光譜分析與鐵譜分析數據,應用時序模型、灰色模型以及組合模型進行磨損的預測方法研究。
  7. Diagnosis is composed of faults detection and location

    診斷分檢測和分。
  8. Testing system for 36e ' s whole entity, a part of testing system for 36e ' s entire entity, is developed for testing the whole entity of 36e, finding the fault location for more accurately diagnosis

    36e電子設備整體測試系統是36e電子設備綜合測試系統的一分,它對系統進行全面的性能測試,依據大修工藝規范確定系統置,縮小范圍。
  9. A repairperson viewing a broken piece of equipment could see instructions highlighting the parts that need to be inspected

    修理技工在檢查設備的故障部位時,可以看見一些重點式的說明,指出哪些零件需要檢查。
  10. Guide for determining fault location on ac transmission and distribution lines

    交流傳輸線和分配線的故障部位測定指南
  11. The author has analyzed the breakdown of cable network and has introduced some methods of tixture of the breakdown part

    摘要對有線網路的進行了分析,介紹了確定故障部位的方法。
  12. When it turns up abnormality > diagnoses fault > maintains system and estimates remained life, facility should be found fault component, mechanism -, character and development trend

    當設備出現異常、診斷、維修乃至估計剩餘壽命時,首先要找出重點故障部位、機理、性質以及發展趨勢。
  13. According to the real - time operation parameters, on - line monitoring of power transformer makes the possibility of extending their operating time, reducing the disk of expensive failures and providing the potential in changing the maintenance strategy

    它以變壓器當前的實際工作狀況為依據,識別的早期徵兆,並對故障部位嚴重程度及發展趨勢做出判斷,從而確定設備的最佳維修時機。
  14. From wavelet analysis, the fault feature of high speed wire rod processer in the heavy section mill of wisco is successfully extracted and from this effective method the same kind accident can be avoided and the fault situation can be confirmed for the future

    成功的通過小波分析提取出武鋼大型廠高速線材軋機齒輪箱輸出接手螺栓拉斷特徵,捕捉到信息,為今後判斷、預防同類事及事後確定故障部位提供了有效的分析手段。
  15. The research about the non - invasive inspection of pcb that is based on ir image is introduced. the detection principle, the components of hardware and software are introduced in this paper. some key technical problems and the project of software are presented in detail : graphics of user interface ( gui ) of the projection, gray scale transformation ( gst ), image contour extraction through edge detection algorithm based on the approaching contour optimization, image registration based on corner detection, the position of hidden trouble pcb through add - minus algorithm image

    本文介紹了利用紅外圖像對印製電路板進行不接觸式檢測的系統研究,主要介紹了本系統的檢測原理,硬體組成及軟體的製作,其中詳細地介紹了軟體的製作過程以及其中的幾個關鍵分:本系統的人機交互界面;圖像的灰度轉換;基於最優輪廓逼近的邊緣提取演算法進行輪廓提取;基於角點檢測的圖像配準;用差影法得到電路板的隱患或故障部位
  16. The typical faults of the automobile electrical control system are taken for example, and their technology condition features are described. ann is used for the fault pattern recognition. because the construction of electrical control system is complex, the fault symptoms have the basic feature that one fault is resulted from many reasons

    以汽車電控系統的典型為例,對癥兆的技術狀態特徵的描述、利用神經網路進行模式識別及其故障部位判斷與原因分析等問題進行了深入的研究。
  17. By specific situations and tasks, personal computers consider three decision projects. firstly, when personal computers turn up fault, the methods of checking fault can find fault component and mechanism. calculating and comparing the consumption of maintenance and replacement can made decision

    由個人計算機具體的情況和任務出發,考慮三種情況的決策:一是當個人計算機出現時,應用檢測方法,找出故障部位、機理,通過維修與更換費用的計算和權衡做出決策,以此來補償有形磨損。
  18. Besides, the system found a fault in the transformer, and the results detecting can be a warrant of state - repair. on the bases of a great deal of investigates and researches, the paper sums up the interfere sources on locale. especially the paper draws some valuable conclusion that the oil cycle style, running state, configuration, oil flow distributing of transformer, position of faults and destroy degree when confirming and choosing sampling position

    在大量調查研究的基礎上,分析歸納了變壓器多種現場干擾因素和不同取樣點對變壓器油色譜在線監測及診斷的影響,特別是變壓器油色譜在線監測在確定和選擇取樣點時,必須考慮變壓器油循環方式、運行狀態、變壓器結構、油流分佈、故障部位及嚴重程度等情況。
  19. Distribution fault detection, islation and restoration system is an important part in the distribution management system ( dms ) now. with the growing need of the reliability of power system, electricity utilities pay more attention to the fault detection, isolation and restoration

    配電網處理包括、隔離和恢復是配網管理系統的重要功能之一;在對供電可靠性要求更高的情況下,配電網處理系統已經為配電門所迫切需要。
  20. This thesis disusses the current states and the matter of the transformer condition monitoring and diagnosis fault. afer analying that dga can only reflect the fault type but ca n ' t confirm the fault location, part - discharging signal can realize fault location in theory but ca n ' t be carried out easily for the inconstant influence of circumstance, we present a method that conbinates the oli - gas and electric quanlities to monitor the transformer. using on - line monitoring of oli - gas conform the fault type. using on - line electric quanlities confirm the fault location. with this method, a fault diagnosis system and corresponding diangnosis flow are proprosed. the main work of this thesis consists of the following parts : 1

    本文主要研究了電力變壓器狀態監測與診斷的現狀以及存在的問題,針對目前dga (油中溶解氣體色譜分析法)只能定性分析變壓器的,不能進行,而局放電雖然能夠進行,但由於現場的干擾復雜多變,難以提取有效的局放電信號,從而提出了結合油氣量和電氣量兩個方面對變壓器進行狀態監測。通過油氣量在線監測,判斷其類型和性質;通過電氣量在線監測,對變壓器的關鍵件? ?繞組實現
分享友人