散熱器冷卻管 的英文怎麼說

中文拼音 [sǎnrèqìlěngquèguǎn]
散熱器冷卻管 英文
radiator cooling tube
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 散熱器 : radiator; radiation; cooler; heat sink
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  1. This paper combines a liquid self - circulating radiator and flat heat pipe radiator, utilizes thermosiphon and self - circulating refrigeration principle, designs and produces a new form of heat pipe radiator

    本文結合液體自循環冷卻系統和扁平熱管散熱器，利用熱虹吸管原理以及液體自循環冷卻原理，設計並製造出一種新型的熱管散熱裝置。
  2. Brass strip for heat - exchanger tubing

    散熱器冷卻管專用黃銅帶
  3. Complex heat sink devices, including liquid cooled cold plates and stacked fins with heat pipes

    復雜的散熱器產品，其中包括液體冷卻的冷板塊和堆疊鰭片與熱管。
  4. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件：各種車用空調冷凝器、蒸發器、散熱器、空調器、調溫器、加熱器、中冷器、空氣乾燥器、冷卻風扇控制器、內部熱交換器、壓縮機、電動機、暖風機、暖風裝置、各種冷凝器電子扇、貯液灌、熱力膨脹閥；各種車用空調管路、開關、離合器、接頭、高低閥、換向閥及各種車用空調生產材料（車用鋁材、銅材等） 、生產設備、檢測設備等。
  5. At hot end of beat pipe, several measures were taken to eliminate heat, namely ( 1 ) traditional sensible heat elimination ; ( 2 ) exhaust air is processed by air washer, then passes through hot end ; ( 3 ) exhaust air is handled by wet film, then passes through hot end ; ( 4 ) sprays water at the top of hot end, respectively

    第一級採用熱管式間接蒸發冷卻器，熱端布置4種散熱方式： （ 1 ）傳統類型的顯熱散熱； （ 2 ）排風經過噴水室降溫后進入熱端； （ 3 ）排風經過填料式直接蒸發冷卻器降溫后進入熱端； （ 4 ）直接在熱端頂部淋水。
  6. The corrugated tank made of high quality cold - rolled - steel sheet manufactured with special production line. it can swell up or shrink compensating the oil from atmosphere. protect and delay the oil and the insulation against degradation, therefore enhance the operation reliability and free of maintenance under normal conditions

    全密封變壓器與普通油浸式變壓器相比，取消了儲油櫃，由波紋油箱的波翅代替油管作為冷卻散熱元件，波紋油箱由優質冷軋薄鋼板在專用生產線上製造，波翅可以隨變壓器油體積的脹縮而脹縮，從而使變壓器內部與大氣隔絕，防止和減緩油層的劣化和絕緣受潮，增強運行可靠性，正常運行免維護。
  7. This paper ’ s background is society need, and assimilates experience of former scholar to improve on a liquid self - circulating radiator for electronic component and develops a new form of more effective compound heat pipe radiator for electron component. at the same time, which is charged respectively by four natural working substance ? ? methanol, ethanol, acetone, water and a refrigeration ? ? r123

    本文正是在這樣一個社會需求背景下，吸取前人工作經驗，改進原有電子器件液體自循環冷卻系統，並開發出一種更為有效的電子器件復合型熱管散熱裝置，分別使用了四種天然工質? ?甲醇、乙醇、丙酮、水和一種製冷劑? ? r123進行試驗。
  8. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  9. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  10. This type of capacitor has an assembling full - sealed structure, and it is comprised of capacitor unit body, contain - er, insulation cooling impregnant, outlet ceramic bushing, pressure - releasing valve and temperature controller etc. the internal insulation cooling impregnant is isolated from external atmosphere so as to avoid aging of impregnant and ingress of moisture

    全密封集合式並聯電容器主要由電容器單元組成的器身波紋油箱絕緣冷卻油出線套管支持絕緣子壓力釋放閥及溫度控制器等部件構成。採用波紋油箱增大散熱面積降低產品溫升。
分享友人
分享到 Line

分享到臉書