整流電路 的英文怎麼說

中文拼音 [zhěngliúdiàn]
整流電路 英文
rectification circuit
  • : Ⅰ形容詞1 (全部在內; 完整) whole; all; complete 2 (整齊) neat; tidy; orderly Ⅱ動詞1 (整理; 整...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  • 電路 : [訊] circuit (ckt); electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. This paper introduces a power controlling system for electrosurgical generator based on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    介紹了基於可控硅整流電路的高頻刀控制系統,並針對該類型刀的輸出功率隨壓波動而發生漂移的問題,採用了一種功率補償的方法,實現輸出功率在不同的壓的波動下保持恆定。
  2. This paper introduces a power controlling system for electrosurgical generator baaed on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    摘要介紹了基於可控硅整流電路的高頻刀控制系統,並針對該類型刀的輸出功率隨壓波動而發生漂移的問題,採用了一種功率補償的方法,實現輸出功率在不同的壓的波動下保持恆定。
  3. Full bridge rectifier

    全橋整流電路
  4. At the same time, the control circuit must realize power regulating of the rectifying circuit and the inverter circuit and keep some parameters impervious to the interferer. this paper has researched high frequency solid induction heating power supply

    同時,控制必須對整流電路、逆變等系統主部分進行功率控制,使在各種擾動下維持系統各參量不偏離其設定值。
  5. Thirdly, the relative theories of the limiter and rectifier are studied. in order to make the passive responder work stably under the conditions of large dynamic range of the receiving power and the high efficiency requirement, a two - stage limiter circuit and a voltage - doubler rectifier circuit with several diodes parallel are developed

    3 ,對應答器地面裝置中的能量轉換進行了研究,針對應答器地面裝置接收到的載波功率具有大動態范圍的特點以及系統能量轉換的高效率要求,設計了一種兩級級聯二極體限幅和多管並聯的倍壓整流電路
  6. Analysing for converter control system in adjustable speed of ac motor with high quality

    調速系統中具有高性能指標的整流電路控制系統分析
  7. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試向偏置線圈輸入偏置和小信號測試,兩者產生的偏置磁場在控制線圈產生感應信號,檢測檢測控制線圈端壓並提取含有轉子位移信息的壓信號,該信號經半波整流電路和低通濾波后得到與轉子位移成正比例的直信號,再由pid控制器轉換為轉子位移的控制信號,最後控制信號輸入功放產生控制,實現閉環控制。
  8. Chopper synchronizing rectifier circuit

    斬波同步整流電路
  9. The controlled silicon rectifier is a kind of electric and electron component and the mostly component of it is thyristor. during the working, thyristor will produce a great quantity of heat. so, the central problem of this article is cooling

    可控硅整流電路中的主要部件是大功率硅器,大功率硅器是一種以晶閘管為主的子器件,晶閘管是可控硅整流電路中最主要的發熱元件,因此,文章主要針對晶閘管的散熱問題展開研究。
  10. Using the digital technology improves the performance traditional thyristor welding machine, according to the characters of the double inverse star from rectifier circuit, set the parameters with micro - controller accurately, design the dependable trigger circuit, lead the feedback of voltage for the operation program, so the voltage of main circuit be carried out very steadily

    摘要利用數字控制技術對傳統晶閘管焊接源進行改進,根據雙反星型晶閘管整流電路的特點,採用單片機進行精確設定,設計了高可靠性觸發迴,結合壓反饋進行程序運算控制,實現了主輸出壓的精確調和可靠運行。
  11. The series h - bridge multilevel converter ' s power circuit is composed of uncontrolled rectifier with filtering capacitor and single phase h - bridge voltage - type inverter

    串聯h橋多平變頻器的主迴從結構上可分為三相容濾波不可控整流電路和單相壓型全橋逆變
  12. In the second chapter, it has introduced the super - frequency induction heating power supply in detail, including its rectifier, its inverter and its parallel - resonant load

    第二章對超音頻感應加熱源做了詳細的技術分析,包括它的整流電路、逆變和並聯諧振槽
  13. Voltage analysis of capacitor - filtered three - phase - bridge rectifier circuits

    容濾波型三相橋式整流電路壓分析
  14. Among these a three - phase voltage - style pwm rectifier is selected, and voltage space vector pwm is employed. and its principle, mathematics models and the selection of control parameters are studied in details. in addition to, a fast algorithm for space vector pwm, the method of decomposition matrix proposed in this paper can simplify the calculation process and with which we may omit the triangular function tables

    分析總結了現有的三相整流電路拓撲及其控制策略,選擇以三相壓型pwm器為研究對象,並採用壓空間矢量pwm控制策略;分析研究了器的工作原理,建立了數學模型;研究了控制方法及其參數設計;提出了壓空間矢量的pwm快速演算法,不需要三角函數表,由dsp實時計算得到精確的工作矢量及零矢量的作用時間。
  15. After that, the evaporative cooling commute circuit system was build - up. the temperature of thyristor and the thermal resistant between thyristor and air was calculated. the corresponding parameter was compared in different cooling system

    文章在對晶閘管傳統冷卻方式深入透徹理解的基礎上,從理論上分析了可控硅整流電路採用蒸發冷卻技術的可行性以及引入調壓系統的可行性和必要性,進而又進行了實驗研究。
  16. The design and simulation of the circuit, which is designed to drive a power mosfet with a 500v breakdown voltage and maximum ia operation current, is implemented. the circuit can be used as a pre - regulator for electronic ballast. the ic solution also provides a voltage - regulator with the functions such as undervoltage lockout, and overvoltage protection

    設計目的是使作為子鎮器的前端變換器可以驅動耐壓為500v ,最大工作為1a的橫向功率mos ,對整流電路的直輸出壓進行穩壓,並實現過壓、欠壓保護,提高用效率,經過理論分析使經校正後的功率因數達到0 . 95以上。
  17. A fault diagnosis method of 24 - wave controlled rectifier circuit

    一種二十四脈波可控整流電路的故障在線診斷方法
  18. Chapter three : presents the fabrication process of micro - switch with cantilever beam and designed the masks. chapter four : designed circuit to actuate the micro - switch, analyzed the dynamic and static property of voltage doublers circuit

    第四章設計出了微開關驅動壓的升壓,對倍壓整流電路的輸入特性和負載特性進行了分析,設計了實際圖。
  19. In theory analysis, the voltage waveforms of the 12 - pulse waveform controlled rectifier circuit and three - phase thyristor converter under fault and normal condition are analyzed and researched in detail, all the faults states are summarized and classified according to the aberrant voltage waveforms

    在理論分析方面,本文對三相橋式整流電路、 12脈波可控整流電路等大功率子裝置整流電路在正常運行及故障狀態下的壓波形進行了詳細分析和研究,按照壓波形對故障狀態進行了總結和歸類。
  20. In particular, the magnetic integrated techniques of the doubler - current rectifier topology applied for the secondary circuit of the transformer are researched carefully

    同時對隔離型拓撲的變壓器副邊整流電路以及磁集成技術在倍拓撲中的應用進行深入研究。
分享友人