數值軸 的英文怎麼說

中文拼音 [shǔzhízhóu]
數值軸 英文
value axis
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 數值 : numerical value; numerial number; figure; magnitude; value數值表 numerical tabular; 數值天氣預報 ...
  1. The waves should be sheared waves for the anisotropic aeo device and longitudinal waves for the isotropic aeo device. geometrical relationships of anisotropic acousto - optic effect in ln crystal and kdp crystals are studied by tangent - match condition. curves of incident angle vs. abaxial angle, diffractive angle vs. abaxial angle, extreme frequency vs. abaxial angle and acousto - optic merit vs. incident angle vs. abaxial angle are systematically gained and the design parameters are also calculated

    利用相切-匹配條件法研究了鈮酸鋰晶體及kdp晶體的反常聲光互作用幾何關系，系統地得到了以離軸角為自變量的各參數的計算公式及相應的關系曲線，通過數值分析方法給出了聲光優值隨中心頻率的變化曲線並給出了器件的設計參數。
  2. Objective to simulate the growth of axons in the developing nervous system numerically

    摘要目的數值模擬神經系統在發育過程中軸突的生長情況。
  3. Detailed numerical results for a pgsm beam passing through a bifocal lens are presented. it implies that the degree of polarization is no longer uniformly polarized in general and propagation - induced polarization changes depend on the beam parameters and system parameters, such as beam coherence parameter

    通過對雙軸透鏡系統進行的數值計算表明， pgsm光束光場的偏振不再是均勻偏振，光束的偏振特性與光束參數和光學系統參數有關，不同相關狀態下場點的偏振度不同。
  4. On this foundation the article inducts in detail the method which is based on the relative settlement of calculating unit area end support ( qb ) force at the same time considering the feature of pedestal pile ' s " arch effect " the article introduces conception of pile effective length and finally obtain t he formula of calculating man - made pipe with bulb - shaped axial carrying capacity. the article uses marc program to calculate and analyze foundation soil ' s stress and displacement and gets the change curve chart and the proportion that is shared by king - pipe side soil friction resistance and pipe end counterforce respectively. the article inducts the structure of pedestal in detail on the basis of generalizing pedestal application cases of many countries

    在此基礎上論文詳細歸納了以相對沉降為依據確定單位面積端承力q _ b的計算方法，並考慮擴底樁的「拱效應」特點引入了有效樁長的概念，最後結合公路規范推出了比較實用的人工挖孔擴底樁軸向承載力計算公式。論文運用了marc程序對地基土的應力和位移進行了有限元數值計算分析，得到了地基土的應力和位移場的變化曲線和在加載過程中樁側土摩阻力和樁端反力各自所承擔的比例；本文還在總結各國挖孔擴底樁應用情況的基礎上就擴底樁的構造進行了詳細的歸納。
  5. Improved charting including multilevel category axis and user - definable value axis units

    增強的圖表包含有多級分類軸和用戶可定義的數值軸單元。
  6. Numerical simulation of macro - segregation with equiaxed grains movement

    等軸晶移動對宏觀偏析影響的數值模擬
  7. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式蒸發冷卻電機楔形氣隙中的流體流動、傳熱現象。本文在定子套筒和轉子表面光滑的假設下，針對蒸發冷卻電機定子套筒壁面基本恆溫的特點，將實際蒸發冷卻電機簡化為同軸套筒內筒加熱旋轉、外簡靜止定溫的物理模型。
  8. Second, adopting the linearity of oil film of the guide bearings, the transient response of the shafts is computed and analysis by integrating with willson method. because of the uncertain position of the shafts in the guide bearing, the model and solution method of nonlinear transient response of the shafts is discussed

    然後結合willson數值積分法，採用線性化油膜力，對機組軸系的線性瞬態響應進行了計算分析，根據機組軸系在瞬態響應中運動的不確定性，給出了由導軸承油膜力非線性所引起的主軸系統的非線性瞬態響應的建模及求解方法。
  9. In addition, it is applied to the condition when cooler are placed to both sides and ipsilateral all

    此外，該數值模擬對冷卻器分兩側（長軸的兩端）和集中一側布置兩種情況均可適用。
  10. Abstract : the intensity distribution in young ' s double pinhole interfer ence expriment is numerically calculate, and compared with the result of the nea r - axis approximation

    文摘:數值計算了楊氏雙孔干涉的光強分佈，與傍軸近似條件下的結果作了比較，並以圖形的方式顯示了干涉條紋的形狀
  11. In a negatively skewed distribution, the values are concentrated at the right end of the horizontal axis.

    在負傾斜分佈中，數值集中在橫軸的右端。
  12. The numerical computation for the secular variable of the semi - major axis, solar distance at perihelion, orbital periods and longitude of perihelion has been made for fifteen meteor streams by using the solution of gylden - meshcherckii equations

    利用g - m型變質量天體軌道根數變化方程的一階和二階解對15個流星群軌道半長軸、近日點距離、軌道周期和近日點經度因太陽質量損失造成的每世紀的長期改變效應做了數值計算，並得出計算結果。
  13. Then, the navier - stokes equations for 2 - d axisymmetric compressible turbulent flow were constructed and phoenics was used to simulate the 2 - d axisymmetric compressible turbulent flowfield of rocket jet

    其次，建立了二維軸對稱可壓縮湍流流動的平均navier - stokes方程，並利用phoenics軟體對二維軸對稱火箭噴流進行了數值模擬。
  14. The equations of motion governing the axisymmetric elastic deformation of finite orthotropic cylindrical shells, involving the effect of transverse shear and rotational inertia, are derived. by applying the reverberation method, the displacement and the resultant forces of the shell in the phase space are expressed. then the transient waves in the finite orthotropic cylindrical shell subjected to the axisymmetric impact are obtained by using inverse laplace transforms. furthermore, the transient solutions are decomposed to the generalized ray integrals and computed numerically

    分析了計及剪切變形和轉動慣性的有限長正交異性圓柱殼中彈性瞬態波的傳播問題，採用回傳矩陣法，在相空間中給出了位移和內力的表達式。再利用laplace逆變換，得到正交異性圓柱殼受軸對稱沖擊作用時彈性瞬態波解，然後將其分解為若干廣義射線積分之和，並用數值方法求解之。
  15. Based on the normal form obtained above, a global perturbation method is utilized to give the analysis for the global bifurcations and chaotic dynamics of the rotor - ambs system. the global bifurcations analysis indicates that there exist the heteroclinic bifurcations and the silnikov - type homoclinic orbit in the averaged equations

    利用全局攝動法研究了電磁軸承-轉子系統的全局分叉和混沌動力學，利用數值模擬方法分別對平均方程和原方程進行了分析，得到了的描述系統混沌運動的相圖和波形圖，從而驗證了理論結果的正確性。
  16. ( 2 ) taking the geology analysis as main way and combining the pre - test, predicating the tunnel ' s main geology condition ( rock quality, surrounding rock classification, long - wide joint, fault, ground water, crustal stress ), and predicating the main potential disaster ( collapse, breaking water, rockburst, large deformation ) ( 3 ) employing the stress test result and inverse analysis of the stress field, finding out the crustal stress " s distributing rule along the tunnel axes section : the highest crustal stress is 24mpa near the deepest spot, and predicting that the k2 + 260 ~ k3 + 000 likely to be the high crustal stress segment for this tunnel

    通過地質分析、類比分析、監控量測、數值模擬、神經網路等方法，對鷓鴣山隧道潛在的主要地質災害（塌方、涌水、巖爆和大變形）進行了預測預報（ 3 ）在現場地應力測試成果的基礎上，運用數值計算進行應力場反演，基本查明了沿隧道軸線剖面的地應力分佈規律：地應力量級在最大埋深附近達到最大值24mpa ，並預測k2 + 260 k3 + 000段將很可能成為鷓鴣山隧道的高地應力段。 （ 4 ）塌方往往與斷層破碎帶及千枚巖相聯系。
  17. ( 3 ) by choosing core faultage of axial site in luohu fracture zone i. e. geological cross section in huangbeiling faultage f8 as geological model and utilizing finite element numerical method, change tendency of huangbeiling faultage f8 under self - weight stress and building loads is stimulated. and long - term development trend of fracture zone is also predicted, which has an important guiding meaning for works of geological disaster prevention in district of luohu jiancheng

    （ 3 ）選取羅湖斷裂帶軸部的核心斷層?黃貝嶺f8斷層地質剖面作為地質模型，利用有限元數值方法模擬了黃貝嶺f8斷層在自重應力和建築物荷載共同作用下的變化趨勢，預計出斷層帶的長期發展趨勢，這對羅湖建成區的地質災害防止工作有重要的指導意義。
  18. The structure of the deformation bands was observed and photographed by a microscope with a camera accessory. a user material mechanical behavior ( umat ) subroutine was developed based on the crystal plasticity model, and with it, the anisotropic elasto - viscoplastic behavior in single crystals was described. slip systems " evolution was simulated by using finite element method with the subroutine

    本文使用數值模擬的方法對[ 001 ] 、 [ 011 ] 、 [ 111 ]以及偏軸加載的多種取向試樣進行了拉伸試驗模擬和循環模擬，研究了不同取向的試樣在加載過程中滑移系的演化情況，並對試樣的宏觀力學行為和細觀機理進行了評述。
  19. The numerical simulation of axisymmetric two - dimensional shock tube is studied, which has a conical convergent section, and its driving gas is the hot product of hydrogen oxygen detonation. finite volume tvd scheme is adopted and the mesh is local orthogonal. the primitive equations are euler s equations of multi - component flow. the new method of eliminating numerical oscillation at the interface of two materials is extended to two dimensions. the mechanical character of this shock tube is analyzed

    對由前向爆轟產生驅動氣體並具有局部錐形收縮截面的軸對稱激波管利用兩相常比熱完全氣體的歐拉方程組和有限體積tvd格式在局部正交的網格上進行了二維數值模擬。將消除兩種介質界面處數值振蕩的新方法成功地推廣到二維情況。分析了該激波管的力學特性。
  20. Abstract : according to the related principle of forming precision andmicrostructure on the condition of deformation and thermodynamic parameters, hot forming process control of large forgings, such as retaining rings and crand - shafts, is investigated by means of computer simulation combined with thermodynamic and micro - simulation in this paper

    文摘:本文採用熱力模擬、微觀模擬和計算機數值模擬相結合的模擬技術，根據變形條件、熱力參數與成形精度和組織結構的相關性原理，以護環、曲軸大鍛件為例，進行了熱成形可控性的研究。
分享友人
分享到 Line

分享到臉書