數學變數 的英文怎麼說

中文拼音 [shǔxuébiànshǔ]
數學變數 英文
mathematical variable
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 數學 : mathematics
  1. The basic dynamic variables are then the operators associated with the creation and annihilation of quanta.

    基本動力學變數是與產生和消滅量子相聯系的算符。
  2. With the help of the electronic computers, engineers employ it to figure out nearly all kinds of engineering problems ranging from astronavigation, construction, waterpower projects, ship - building and mechanical engineering etc. owing to the strong power of finite element method, one kind of software pack which based on the method is exploited and named algor feas to resolve problems on structure analysis for trusses and shells. this paper also employ algor feas software pack to analyze and compute the cableway towers, giving the accurate result on stress and displacement both in location and whole. finally, we also bring out some advice on structure improving

    在此分析過程中：首先將物理模型簡化為力學模型，主要是將塔架結構按空間桿單元簡化為空間桁架結構，目的是將力學模型變換為數學模型；這一過程主要是利用autocad2000建立塔架的計算模型；再者，利用algorfeas軟體包讀入autocad建立的塔架計算模型生成初始數據卡利用計算機進行編程進行風載計算，再將計算結論整合入algorfeas產生的初始數據卡中，生成計算數據卡；接著，利用algorfeas軟體包計算塔架在不同載荷情況下的應力圖，位移圖，並且求出在不同載荷條件下的最大位移和最大應力等；然後，對塔架的穩定性進行分析；最後；根據計算結果提出改進建議。
  3. The changes in molecular weight, mass, mechanical strength, microstructure of fibers and ph value of the buffer solution with time in vitro had been studied. the study shows that degradation mechanism of pdlla / ha compound fiber was indicative of an autocatalysis process and simple noumenon hydrolysis

    通過對試樣的性能測試和形貌觀察，研究了pdlla ha復合纖維在降解過程中其分子量、重量和力學性能以及緩沖溶液ph值等一系列參數的變化規律，並探討了復合纖維的降解機理。
  4. In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis

    論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。
  5. Stability of rock slopes is generally controlled by the structure of rock masses, especially the soft structure surfaces. analysis of rock mass structures is a key to establish geological models and numerical simulation and a foundation to assess the stability of rock slopes. the weak structure surfaces are mainly bedding planes, faults, joints, schistosity plane and contact zones of intrusive bodies. since they are different in genesis and scale, the rock masses are different in features and mechanical intensities. based on the combination of rock structure bodies, 15 basic modes of deformation and failure of rock slope are systematically summarized. the deformation and failure of rock masses actually result from the recombination and rearrangement of these rock bodies. there are 11 types of rock mass structures and various deformation and failure of bank slopes are present in the reservoir area of the three gorge project

    巖體結構，特別是軟弱結構面對基巖斜坡變形與破壞具有顯著的控製作用，巖體結構模式分析是建立斜坡地質模型和數學模型的關鍵和評價斜坡穩定性的基礎。巖層層面斷裂構造節理裂隙片理與劈理以及侵入體和圍巖的接觸帶等是控制基巖斜坡穩定的軟弱結構面，這些成因不同大小不一的結構面將巖體分割成性質各異力學強度不均的各種巖體結構體，構成了15種基巖斜坡變形破壞的巖體結構基本模式。不同結構體的重新組合與排列是斜坡失穩的內在原因。
  6. Couched in mathematical language within the framework of the quantum theory, it gave a satisfying explanation of beta decay.

    如按量子理論的觀點表達為數學語言，就可對衰變作出滿意的解釋。
  7. In the alchemy of his brain, trigonometry and mathematics and the whole field of knowledge which they betokened were transmuted into so much landscape

    這家人所象徵的三角數學和整個知識領域經過他頭腦的煉金術一冶煉便變成了美妙的景物。
  8. We model the piezoelectric bimorph and get the displacement - voltage relationship and force - strain relationship theoretically

    建立了壓電雙晶片的復合梁模型，並對它的微位移電壓特性、夾持力應變特性進行了數學分析。
  9. Static mathematic model of drum accommodation and control is presented, and instruction model control strategy of sample intervals is presented based on differences between characteristic equations of lifting frame and characteristic equations of top and bottom board change among the sampling spots, the rules of this method are few, simple, easy to operate and meet controlling demands

    給出了滾筒調控靜態數學模型，並根據調高機構的調控特徵方程與采樣點間頂底板變化特徵方程的差異，給出了在其采樣區間內的指令式控制策略，其方法的規則條日少、簡單易運算、符合實際控制要求。
  10. Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system

    發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。
  11. In the second part ( including chapter 4 ), this paper applies gray level coocurrence matrix and image texture feature quantities to evaluate eliminate effect through computing the same sampling region selected. the results show that the three methods can eliminate solar eclipse impact on the satellite vis imagery so that the topography, cloud system texture and ocean current are distinct and differentiable and it is good for analyzing the clouds and weather systems on the cloud image. comparing the three methods, the improved geometry - model method is the most effective

    研究結果表明：原幾何模型法、改進的幾何模型法和數學函數模型法基本都能消除日食對雲圖的影響，經過訂正處理后，各種特徵紋理變細，結構變清晰，信息增加，有利於雲圖上雲和天氣系統的識別和分析；三種方法的比較認為，改進的幾何模型法訂正效果最好，原幾何模型法的效果較差，數學函數模型法更加快速、簡便，但其涉及的主觀因素較多。
  12. Based on the empirical equations used for calculating the cost of main and distribution pipes of gravity sprinkler irrigation project, equations for calculating. 4. economical hydraulic gradient, pipe length and the minimum cost of the main pipe were derived through theoretical analysis and mathematical transformation

    3 .在建立的自壓噴灌工程主幹管和配水管道的造價計算經驗公式基礎上，通過理論分析和數學變換，推導得出了自壓噴灌主幹管經濟水力坡度、經濟管長和最低造價計算公式。
  13. Based on the representation of interval rational bezier curves and surfaces and by a serial of mathematical transformation, the degree reductions of them are converted to those of polynomials with upper bounds, then several algorithms are presented, with linear programming and optimal approximation methods. by relaxation of some constrained conditions, approximation effects of some of them are further improved

    根據區間有理bezier曲線、曲面的特點，通過一系列數學變換，將其降階問題轉化為多項式的保上界降階逼近，再應用線性規劃和最優逼近方法求解，給出幾種逼近演算法，並探討通過約束不等式的鬆弛，進一步改進逼近效果。
  14. In the module of data management, the ado programming technology was combined with access database to sort and manage the data. in data processing module, the matlab and vc + + co - programming scheme was presented in which the original data were transformmed geometrically so that the 3d data model was established. the graphical display module was developed on the base of opengl and vc platform with which the 2d geological drawings and 3d geological drawings could be accomplished

    在數據管理模塊中，選用ado數據庫開發技術，結合使用access數據庫對數據進行分類管理與存儲；在數據處理模塊中，提出了利用matlab vc ~ （ + + ）聯合編程的方案，通過使用matlabc c ~ （ + + ）數學函數庫完成了反演數據的幾何變換以及三維數據模型的建立；在圖形顯示模塊中，以圖形介面opengl作為繪圖語言，在vc平臺下進行開發，實現了二維地質圖件和三維地質圖件的繪制。
  15. The mathematical transformation is fixed and the airfoil is moved to generate different airfoil geometries

    數學變換是固定機翼的翼型幾何移到產生不同
  16. Abstract : the paper drives the computer imaging mathematics transform of submarine simulat ion, the formulas that drive finally could be used for simulation directly

    文摘:文章對潛艇模擬中的計算機成像數學變換公式進行推導，推導出的最終公式可直接用於模擬。
  17. Synthetic aperture radiometer applies the interferometric principle to sample in the spatial frequency domain and retrieves the image by fourier or other numerical transformation

    綜合孔徑輻射計利用孔徑綜合原理在空間頻率域中采樣，通過傅立葉變換或其他數學變換獲取反演亮溫圖像。
  18. Abstract : in order to solve the double parameters enveloped in the geartooth flank generating, the complicated double parameter envelope is simplified to the generating process between work - piece and imaginary crown generating gear by means of mathematical transformation. the equation of the imaginary crown generating surface and the partial derivatives are deduced, so the differential geometric parameters of the generating surface can be obtained. by analyzing the generating motion between the imaginary crown generating gear and the work - piece, all the first to third order geometric parameters of the generated tooth flank at any given point can be calculated

    文摘:為了解決直接求解展成法加工中存在的復雜雙參數包絡問題時的困難，提出通過數學變換，將此包絡問題轉化為假想平面產形輪與工件之間的展成問題來進行研究.推導了假想產形面的方程和各階偏導矢，於是可獲得產形面的微分幾何參數.通過分析假想平面產形輪與工件之間的展成運動，即可得到被展成齒面上任意指定點的全部一至三階微分幾何參數
  19. The essential properties like randomicity ; dynamic ; coupling ; nonlinear and so on of the system of pipelines - soil under dynamical loads was studied through loads, soil, and pipelines - soil etc three aspects, so this chapter offers the basic job for the dynamical response of the pipelines - soil system. eular - bernonulli beam model and tomosimko beam model were adapted to study the inherence vibration properties of the pipelines under dynamical loads, and the analytical answers of the chanmical results were brought out in the fifth chapter

    荷載的作用，最終要通過土體介質的傳遞到達管道本身，從而使得管道發生力學性狀響應，因此，文中以粘彈性理論為基礎，通過數學變換、推導，提出了荷載在土體中的傳播特性和計算方法，使得管道的動力激勵部分問題得解。
  20. Fatigue is a common, non - specific, subjective symptom associated with several somatic and psychiatric illnesses

    摘要疲勞為臨床常見的癥狀，現代醫學著重於生物學變數的理論基礎對此癥狀常缺乏有效的診斷與治療。
分享友人
分享到 Line

分享到臉書