數控振蕩器 的英文怎麼說

中文拼音 [shǔkòngzhèndàngqì]
數控振蕩器 英文
nco number controlled oscillator
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Motion controller composed of general chip series is developed and quadruple differential circuit utilizing dual monostable multivibrators with schmitt trigger inputs and dual 4 _ line to l _ line data selectors or multiplexers is put forward

    本論文研製了一種用常規晶元系列組成的運動控制器，提出了採用單穩態多諧振蕩器和數據選擇器的四倍頻辨向電路。
  2. Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator

    本文研究了以低損耗、高q值聲表面波（其中包括聲表面瑞利波- - rayleighsurfaceacousticwave ，和聲表面橫波等）諧振器的工作原理、設計參數、製作工藝及其實驗結果，並且研究了以1ghzstw諧振器為頻控元件的高頻率、低相位噪聲聲表面波振蕩器，以及低相位噪聲聲表面波振蕩器的測試方法和最終的測試結果。
  3. The designs of the pfd, digital filter ocxo and fractional - n counter in the frequency synthesizer unit are discussed, based on the pll theory. in order to improve the precision of pll, some design methods of pfd are given, and its feasibility is validated by the fpga hardware implement

    2 .在鎖相理論指導下，第三章討論了頻率合成器設計中的鑒頻鑒相器、數字濾波器、恆溫壓控振蕩器和分頻電路設計。為了進一步提高頻率合成的精度，文中給出了提高鑒頻鑒相器性能的一些設計思想，結合fpga的硬體設計驗證了其可行性。
  4. On account of the low q - factor and small tuning range of the p - n junction varactor, the inversion - mode mos varactor is used in the lc voltage controlled oscillator in this thesis. the simulation results show that the designed lc voltage controlled oscillator has 15 % tuning range

    3 .由於lc壓控振蕩器中的pn結變容管品質因數低、調諧范圍小，本次設計的lc壓控振蕩器採用了強反型mos變容管，模擬結果表明，所設計的lc壓控振蕩器具有15 %調諧范圍。
  5. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  6. The thesis discussed a parameter extraction program for the mosfet level1 model. in the analysis and design of circuit, at first, the thesis described the system function of the new dc - dc switching converter. then several sub - circuits of converter ic such as oscillator, over - temperature shutdown circuit, auto - restart counter circuit and control circuit were completely discussed

    在電路設計中，本文首先分析了開關電源電路的基本拓撲結構和psm調制模式，接著對開關電源變換器進行了系統的原理分析並設計了總體框圖，然後詳細設計了振蕩器電路，熱保護電路，自動重啟計數器電路和主控門邏輯等子電路並進行了功能模擬。
  7. This instrument keeps constant temperature by circling air both. it use computer to control temperature and oscillation frequency, led digital display, it has stable performance, and its quality is reliable, its appearance is beautiful and digniful. it can be operated conveniently. it is the suitable instrument uhcih is used on researching and production by the trades of bioengineering. medicine. hygienist and so on

    該振蕩培養箱是利用旋轉空氣浴進行恆溫的振蕩器，溫度和振蕩頻率均採用電腦控制，用led數碼顯示.該振蕩器性能穩定，質量可靠，造型美觀大方，操作方便，實為生物工程、醫藥、衛生等行業科研和生產中使用的理想儀器。
  8. For digital audio encoding and decoding modules, delta - sigma modulation is introduced and audio data, preambles with accessorial data are multiplexed according to the digital audio interface standard ; for carrier wave, pll frequency synthesizer is used ; for frequency modulation, voltage control oscillator is taken ; for demodulation, pll frequency discrimination is adopted

    調制方式，並按照數字音頻介面標準對音頻數據、同步字和附加信息進行通道復用;對于載波信號，採取鎖相環頻率合成技術手段;對于頻率調制，採用壓控振蕩器;對于解調電路，採取鎖相環鑒頻電路。
  9. In the section of experiment, we focused on the research of optical system of optical parameter oscillation, computer controlling data sampling closed - circuit system and technology of computer controlling feed - back. in the section of optics, we used present condition to do the experiments about optical parameter effect and got a series of characteristic curve on power transition efficiency and output power

    本文的實驗部分主要側重於智能化光參量系統的光學部分、計算機控制數據採集閉環系統以及計算機控制反饋技術的研究。在光學部分，本論文利用現有實驗條件進行了參量振蕩器頻率調諧的研究，得到了調諧曲線，並做了輸出參量光的能量轉換效率以及輸出功率的實驗，得到一系列特性曲線。
  10. The single - chip function generator icl8038 can get synchronous sine wave of constant amplitude in pll as voltage control oscillation ( vco ), which is a basic signal source of static frequency converter

    單片函數發生器icl8038在pll中作為壓控振蕩器（ vco ）產生同步等幅正弦波，可作為靜止變頻器的基準信號源。
  11. Firstly, the theory basis of if digital receiver is introduced, which includes over - sampling digital mixing receiving scheme and mathematic model with which the scheme is proved correctly. secondly, the numerically controlled oscillator ( nco ) is designed and realized

    首先介紹了中頻數字接收機採用的過采樣數字混頻數字接收方案，然後給出數學模型，從理論上論證了該方案的可行性;二、數控振蕩器設計與實現。
  12. And designed a program used by this method to design a filter. the result complies with the analytic result. at the end of this paper, according to the project of airline broadcast, the author designd filter with high rectangular factor, five channelizing filter banks, saw programmable correlator implemented with multiplayer muti - chip technology, saw resonator

    本文的最後，結合某航空直擴數傳電臺的工程要求，設計了高矩形系數的前置濾波器、聲表面波濾波器組、採用多晶元組裝厚膜工藝技術的聲表面波可編程相關器和聲表面波壓控振蕩器，完成了解調解擴單元的硬體設計。
  13. Design and performance analysis of numerically controlled oscillator based on fpga

    的數控振蕩器設計及其性能分析
  14. Analyze the interpolation filter, timing - error detector and controller in loop of timing recovery detailedly

    詳細分析了定時恢復環路中的內插濾波器、定時誤差信號的提取、數控振蕩器。
  15. First, the theory, the merit and noise analyzing is expatiated on, and then the hardware realizing process of if digital receiver is introduced concretely

    首先闡述了數控振蕩器的工作原理、優點和噪聲分析，接著具體闡述了數控振蕩器的硬體實現。
  16. It is very difficult to realize digital rf, but we can realize digital if. digital if mainly include : digital up convert ( duc ^ digital down convert ( ddc ), a / tk d / a and number control oscillator ( nco )

    目前實現射頻數字化還有一定的困難，但可以實現中頻部分數字化。數字中頻處理主要包括數字上變頻、數字下變頻、 a d與d a的處理以及數控振蕩器等。
  17. In this dissertation, the method to design and realize the digital receiver in the field programmable gate array ( fpga ) has been discussed ; combining coordinate rotation digital compute ( cordic ) to design nco, we get a efficient structure without multiplications

    本論文正是運用現場可編成邏輯器件（ fpga ）設計與實現數字接收機問題開展研究，結合坐標旋轉數值計算（ cordic ）演算法實現數控振蕩器（ nco ） ，得到一種免乘法器高效可移植性好的數字接收機fpga實現結構，並在現有的硬體平臺上進行了接收機系統的調試，測試結果表明該接收機能夠達到系統指標要求。
  18. The thesis describes a prototype fractional frequency synthesizer which is supported by a project granted by the ministry of science and technology of pr china. firstly, based on the principle of pll, this paper briefly describes three basic pll components : phase detector ( pd ), low pass filter ( lpf ), voltage controlled oscillators ( vco ), analyzes the linearized pll and summaries the transfer functions of third - order pll with ideal intergrator filter respectively. based on a microwave vco, the single point frequency pll frequency ranging from 2. 2 to 2. 5ghz is developed

    首先，從鎖相環的基本理論、原理出發，分析了鎖相環中的三個基本部件：鑒相器、環路濾波器和壓控振蕩器，此後，針對線性化鎖相環進行了分析，研究了在使用比例積分濾波器時，三階鎖相環的環路參數計算；在電路實現時選用了lmx2353 ，在此基礎上，完成了2 . 2 ~ 2 . 5ghz范圍內的小數頻率合成器設計。
  19. This paper realized frequency modulation using the video signal to directly control the resonance loop ' s diode of the vco at the early stages, and then through using radio frequency bipolar junction transistor, designed a lc voltage controlled oscillator which was emulated by advance design system. in addition, it also implemented the design and debugged the hardware circuit

    本文第一次實驗採用視頻信號直接控制vco諧振迴路變容二極體的方式實現頻率調制，並且利用射頻雙極性晶體管（ bjt ）設計了一種lc壓控振蕩器，通過ads軟體進行了參數模擬，最後進行了硬體電路的製作和調試。
  20. The fourth, mainly talk about the phase noise in the pll, and discuss the specific affect on out put phase noise caused by different components in frequency synthesizer, such as mixer, amplifier, multipler, divider, oscillator, phase detector etc. the last part is about how to choice the natural frequency of pll in order to get the better performance in phase noise

    第二章從鎖相環的基本原理出發，介紹了鎖相環的幾個基本部件:鑒相器?環路濾波器和壓控振蕩器，對線性化鎖相環進行了詳細的分析，對數字鎖相環做了詳細的介紹，分析了鎖相環的相位噪聲模型，討論了頻綜中的混頻器
分享友人
分享到 Line

分享到臉書