斜接角度 的英文怎麼說

中文拼音 [xiéjiējiǎodù]
斜接角度 英文
miter angle
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 角度 : 1. [數學] （角的大小） angle; the degree [size] of angle 2. （看事情的出發點） point of view; angle
  1. T7 has the greatest spinous processes angulation, whereas the upper three thoracic ertebrae hae spinous processes that project directly posteriorly

    T7的棘突傾斜角度最大，然而其上三個胸椎的棘突直接朝向後方。
  2. The pedal angle can be changed as desired by adjusting the length of the link rod

    調節連接桿的長度，踏板的傾斜角度可以自動地變化。
  3. The limit of the thickness of the join on a mitered corner

    斜接角上聯接寬度的限制。
  4. The miter length can be large when the angle between two lines is small

    當兩條直線之間的角度很小時，斜接長度可能很大。
  5. Gets or sets the limit of the thickness of the join on a mitered corner

    Pen . miterlimit屬性獲取或設置斜接角上聯接寬度的限制。
  6. With the development of the network and the multi - processor system, the research, simulation and the impemeni of the system - level fault diagnosis which is the very important means to increase the reliability of the system, are becoming more and more important. on the system - leve1 fault diagnosis, based on the group theory of system - level fault diagnosis that has been put forward by pro f zhang, the paper constructs newly the theory bases, improves on the matrix method, reinforces and consummates group arithmetic of all kinds of test mode, for the first time, analyses and discusses the equation solution of all kinds of models, so al1 the consistent fault patterns ( cfp ) could be found, straightly and high efficiently, even if the sufficient and necessary condition of t - diagnosable is dissatisfied and the complexity of system - level fault diagnosis is greatly decreased, especialy in strong t - diagnosabl6 system. last the simulation system ' s function has been extended and the application hotspot and the development trend have been disscussed

    本人在張大方教授等人提出的基於集團的系統級故障診斷的理論基礎上，重新構建了系統級故障診斷的理論基礎，定義了系統級故障診斷測試模型的三值表示；改進了系統級故障診斷的矩陣方法，重新定義了測試矩陣、鄰接矩陣、結點對、結點對的相連運算、極大準集團和斜加矩陣，由此能直觀、簡便地生成集團和極大獨立點集；補充和完善了各類測試模型的系統級故障診斷的集團演算法，通過定義集團測試邊和絕對故障集，簡化了集團診斷圖，由此能較易地找到所有的相容故障模式，即使不滿足t -可診斷性，大大減少了系統級故障診斷的復雜度，尤其是對強t -可診斷系統；首次分析探討了各類測試模型的方程解決，由此從另一角度能系統地、高效率地求出所有的相容故障模式（ cfp ） ：擴充了系統級故障診斷模擬系統的功能，快速、直觀和隨機地模擬實驗運行環境，進行清晰和正確的診斷，同時提供大量的實驗數據用於理論研究，優化演算法和設計。
  7. This produces a sharp corner or a beveled corner, depending on whether the length of the miter exceeds the miter limit

    這將產生一個銳角或斜角，具體取決于斜聯接的長度是否超過斜聯接限制。
  8. This produces a sharp corner or a clipped corner, depending on whether the length of the miter exceeds the miter limit

    這將產生一個銳角或切除角，具體取決于斜聯接的長度是否超過斜聯接限制。
  9. Taking the bending stiffness, cable sag and cable inclination into consideration, the space vibration control of the cables using the visco - elastic dampers in cable - stayed bridges is investigated by joining the center difference method and the state space strategy. both the maximum modal damping ration and the optimal damper size are obtained, then the practical suggestions are proposed for the design of the dampers. the space nonlinear vibration equations of the cable - damper system are derived, and a new hybrid method for solving the cable - damper system is presented by combing the newmark method and pseudo - force technology

    綜合考慮了拉索抗彎剛度、垂度的影響，研究了粘彈性阻尼器對斜拉橋拉索的空間振動控制，聯合中心差分方法及狀態空間法，得出了拉索麵內、外振動各階模態可能達到的最大阻尼比及相應的最優阻尼器系數，並對斜拉橋拉索的阻尼器設計提出了參考建議：考慮拉索抗彎剛度、垂度及幾何非線性，導出了索-阻尼器系統的空間振動非線性方程組，結合newmark方法及偽力（ pseudo - force ）方法，創新地提出了求解非線性方程組的雜交方法，根據拉索-阻尼器系統的阻尼特性，在各種荷載作用下，對索-阻尼器系統的非線性瞬態振動響應進行了研究，從系統響應的角度更加直接地驗證了阻尼器的控制效果。
  10. Hold the test specimen by the edges at an angle above the pre - cleaned microscope slide. the specimens should not touch the slide

    手持測試樣本的邊端以一定的角度傾斜在光片的上方。樣本不應接觸光片。
  11. The radiation patterns at different scan angle from - 20 to 20 degree are presented, and the angle difference between the maximum / minimum field points of their main beam shows the bse of the radome. at different frequencies, the radiation from the antenna has been discussed when azimuth scan angle ranges between - 20 degree and 20 degree. the relationship between

    200 ~ 200范圍內天線的和方向遠區場、方位差方向遠區場;得到方位瞄準誤差、瞄準誤差斜率和功率傳輸系數隨掃描角和入射波頻率的變化關系;並將所得數據與文獻數據進行比較，表明間接射線法簡單、有效且精度較高。
  12. The influence of the slant on maximum stress in contact area is studied and the axial movement formula is modified. the idea of contact angle is presented to study the direct influence on the axial movement. 2

    研究了這種傾斜對接觸區最大壓應力的影響，對回轉窯軸向下滑計算公式進行了修正；提出了接觸角的概念，分析了這種傾斜對窯體軸向運動速度的直接影響。
  13. In the light of bankruptcy law and labour law, the authour points out the defects of laying - off the staff for bankruptcy and puts forwards that we must improve our system to regulate the activities of laying - off the staff for bankruptcy. how to make full use of the function of distributing labour resources of the market and maintain the stability and mobility of labour relations is a worthwhile subject to make a further study. here, the author just makes a superficial study about legal system of unilateral dissolution of labor contract, hoping to be of a little value to the perfection of china ' s legal system of unilateral dissolution of labour contract

    作者認為我們可從《勞動法》和《破產法》相銜接的角度，確立科學、合理的標準對困境企業進行認定、確立合理的裁員標準保護特殊群體的利益、加強工會組織的干預力度、加強對被裁人員的保護以及完善我國的各項配套措施等等，來對我國的經濟性裁員制度進行完8隨著我國經濟體制改革的深人以及叮的加入，我國的勞動用工制度也在發生變化，怎樣發揮市場機制在勞動資源的配置作用，維護勞動關系的穩定性和合理流動性，在傾斜保護勞動者利益的同時，平衡勞動者和用人單位雙方的利益，是一個很值得研究的課題。
  14. As the goal position is approached, the ball automatically speeds up to reverse the tilt and bring the ballbot to rest [ see box above ]

    接近它的目的地時，圓球會自動加速轉換傾斜角度，同時讓圓球機器人停止（請參閱上方從這里溜到那裡） 。
分享友人
分享到 Line

分享到臉書