斜接觸 的英文怎麼說

中文拼音 [xiéjiēchù]
斜接觸 英文
angular contact
  • : 形容詞(跟平面或直線既不平行也不垂直的) oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • 接觸 : 1. (交往) come into contact with; get in touch with 2. (沖突) engage 3. (挨上; 碰著) contact; touch
  1. Stability of rock slopes is generally controlled by the structure of rock masses, especially the soft structure surfaces. analysis of rock mass structures is a key to establish geological models and numerical simulation and a foundation to assess the stability of rock slopes. the weak structure surfaces are mainly bedding planes, faults, joints, schistosity plane and contact zones of intrusive bodies. since they are different in genesis and scale, the rock masses are different in features and mechanical intensities. based on the combination of rock structure bodies, 15 basic modes of deformation and failure of rock slope are systematically summarized. the deformation and failure of rock masses actually result from the recombination and rearrangement of these rock bodies. there are 11 types of rock mass structures and various deformation and failure of bank slopes are present in the reservoir area of the three gorge project

    巖體結構,特別是軟弱結構面對基巖坡變形與破壞具有顯著的控製作用,巖體結構模式分析是建立坡地質模型和數學模型的關鍵和評價坡穩定性的基礎。巖層層面斷裂構造節理裂隙片理與劈理以及侵入體和圍巖的帶等是控制基巖坡穩定的軟弱結構面,這些成因不同大小不一的結構面將巖體分割成性質各異力學強度不均的各種巖體結構體,構成了15種基巖坡變形破壞的巖體結構基本模式。不同結構體的重新組合與排列是坡失穩的內在原因。
  2. Analyze the stresses distributing of helical gear in long direction using 3dcbem. optimize the shape of dentiform using cvm as the optimize algorithm. the result were satisfied

    作者編制了齒輪前處理程序,應用邊界元應力分析程序3dcbem分析了沿齒寬方向的輪齒應力的分佈。
  3. The squeegee is the engine which deflects the stencil and makes it contact with the substrate

    刮墨刀是令模版傾至可以與基質的引擎。
  4. Ultrasonic angle beam examination by the contact method

    式超聲射探傷方法
  5. Yuli brand drive optical network lights and the colourful new torpedo lights product range, is use of new improved power spring - loaded device access by luminous objects bottom cathode metal with top of spring - loaded contacts, contacts larger, use more flexibility, and must change the old generation network light bending of " spring - loaded " installation use error - prone, lean, exposed the defects

    "魚利"牌勁光網標燈及彩光新魚雷燈系列產品採用全新改良的電源彈簧裝置,由發光器底部負極金屬片與彈簧頂部面更大使用更加靈活方便.傾底解決了老一代網標燈彎尾彈簧安裝使用時易偏差、傾、外露的毛病。
  6. This then allows the lower plate lug to make contact of its two corners with the slanting walls of "v" groove.

    這便於下面的極板年的兩角與「V」字形溝槽的兩個傾的壁相
  7. Through systemic analyzing on spiral helical gear transmission with different basic parameters, the essay found out rules of how can such basic parameters influence spiral helical gear engagement characteristics. so it brings forward the auxiliary assembling mode of adopting one straight gear and one helical gear on condition of little axial angle as well as treasures to ameliorate ill engagement performance on condition of large axial angle, another two jobs of the essay are to clarify the wrong concept that spiral helical gear can only transmit movement but not impetus and to provide a brief and practical method of analyzing contact for gear pairs whose surface equations can be written out directly

    通過對不同基本參數的螺旋齒輪傳動進行系統研究,找出了螺旋齒輪基本參數對其嚙合特性的影響規律,提出小軸交角條件下可採用一直齒輪、一齒輪的齒輪副組合方式,給出了大軸交角條件下嚙合性能不良的改進措施。澄清了螺旋齒輪只能傳遞運動不能傳遞動力的誤區,為能夠直寫出齒面方程的齒輪副進行齒面分析提供了一種簡便、實用的新方法。
  8. In this paper, to counter a flexible beam undergoing large overall motion impacting a fixed slope surface under the effects of grativity, the normal contact model is established based on the hertz theory and non - linear damping term, the tangential contact model is developed by adopting linear tangential contact stiffness to consider the effects of friction force during impact process, and the consistent linear dynamic model including impact is derived by using mode assumption method and lagrangin equation

    針對在重力場下作大范圍回轉運動的柔性梁與一固定面發生碰撞的情況,根據hertz理論和非線性阻尼項建立法向碰撞模型。引入線性切線剛度建立切向碰撞模型,以考慮過程中由於切向相對速度的換向作用引起的摩擦力的變化。利用假設模態法和lagrangian方程建立系統含碰撞過程的一致線性化的動力學模型。
  9. Contacts the ground insufficient 10 square meters, also unidirectional incline

    地面不足10平方米,且單向傾
  10. Finite element analysis of oblique multi - body contact between roller and tyre

    回轉窯托輪滾圈的有限元分析
  11. In this paper, select li 3 # and grease 7014 as basis grease. select nano diamond and sio _ 2 are selected as additives, design 14 recipe using k and l10 as appraise norm study the dose of nano particle to the effect of contact fatigue of ceramic and steel friction has the conclusion that proper quantities nano particle which put in two grease can improve the contact fatigue life of ceramic using sem and edax, nano particles fatigue resistance mechanism are analyzed. which can improve the contact fatigue life of ceramic and steel friction

    本文選用3 #通用鋰基脂和7014號寬溫航空潤滑脂作為基礎脂,選取納米金剛石粉和納米二氧化硅微粒作為添加劑,設計了14種配方。利用威布爾率k和額定壽命l10作為評價指標,研究了納米微粒的用量對陶瓷球/鋼副的疲勞壽命的影響,得出在所選兩種基礎脂中添加合適用量的納米微粒添加劑可以提高陶瓷球的疲勞壽命。利用sem和edax ,初步揭示了納米微粒提高陶瓷/鋼副滾動疲勞的機理。
  12. The noise of the high contact ratio gears with the medial sloping contact path is reduced lower than 1 - 2 db, and the noise of the gears with the large sloping contact path is lower ed more

    跡線中度傾的高重合度弧齒錐齒輪平均降低噪聲1 2分貝,跡線大傾的高重合度弧齒錐齒輪平均降低噪聲2 3分貝。
  13. Hold the test specimen by the edges at an angle above the pre - cleaned microscope slide. the specimens should not touch the slide

    手持測試樣本的邊端以一定的角度傾在光片的上方。樣本不應光片。
  14. There are 3 types of reservoir for the continuing subsidence type basin, there are diapir reservoir, fault reservior, drape reservoir, and the source rock is apart from the reservoir, they are contact by fault ; and there are anticline reservoir, fault reservoir, incline reserve ir, mudstone reservoir under the denudation area, and the source rock is contact with the reservoir

    以沉降為主要趨勢的盆地的油氣藏有底辟構造油氣藏、斷層油氣藏、披覆構造油氣藏,其烴源巖與油藏在空間上是分離的,並通過斷層相連;剝蝕區以下的油氣藏有背油氣藏或斷層油氣藏、向油氣藏及泥質巖油氣藏,其烴源巖和油氣藏可有密切的關系。
  15. If the racquet is tilted or laid back at contact you do not get this brushing effect

    如果網拍在球時是傾的或者被向後地放置,你不會得到這一梳刷的效果。
  16. Ps : the oblique surface of talfon is the ball contacting surface ; ball and spindle shall be matched correctly

    鐵氟龍度面為球珠面;球珠與軸心配對位置必須載放正確。
  17. The influence of the slant on maximum stress in contact area is studied and the axial movement formula is modified. the idea of contact angle is presented to study the direct influence on the axial movement. 2

    研究了這種傾區最大壓應力的影響,對回轉窯軸向下滑計算公式進行了修正;提出了角的概念,分析了這種傾對窯體軸向運動速度的直影響。
  18. Its program has been completed with visual basic ( 6. 0 ). the object functions of fuzzy optimization design were the maximums transmission efficiency and the minimum volume of its construction and their weighted object function of them. the keep with bounds were included the contacting strength and winding strength and deforming strength and the sizes of constructions of pdew

    採用visualbasic ( 6 . 0 )語言,編制了以傳動效率最高、空間結構尺寸最小的單目標模糊優化、以及上述兩個目標的加權綜合多目標的模糊優化;約束條件綜合考慮蝸桿的強度、彎曲強度以及剛度,空間結構尺寸等,並採用線法對約束條件進行了模糊處理的模糊優化設計程序。
  19. The analysis of i - v characteristic and microstructure shows that the failure of device results from the gate sinking and ohmic contact degradation

    通過溫度坡試驗,對器件試驗前後的i - v特性的對比分析和微結構的分析表明,歐姆退化和柵下沉共同導致了器件的失效。
  20. This then allows the lower plate lug to make contact of its two corners with the slanting walls of " v " groove

    這便於下面的極板年的兩角與「 v 」字形溝槽的兩個傾的壁相
分享友人