斜面試驗 的英文怎麼說
中文拼音 [xiémiànshìyàn]
斜面試驗
英文
inclined plane testing- 斜 : 形容詞(跟平面或直線既不平行也不垂直的) oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
- 面 : Ⅰ名詞1 (頭的前部; 臉) face 2 (物體的表面) surface; top 3 (外露的一層或正面) outside; the ri...
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 試驗 : trial; experiment; test
-
It canbe determined the enhancing effect of new steel fiber to shear resistance of beams by the test of tensile strength of steel fiber reinforced concrete, it is important to reduce test cose and increase research efficiency
可以通過鋼纖維混凝土抗拉強度試驗來確定新品種鋼纖維對梁斜截面上混凝土受剪承載力的增強作用,這對于降低試驗成本和提高研究效率具有重要工程價值。The multi - work condition declivitous impact testing system was introduced which has variable impacting angle, rigidity, and length of stroke, and has elastic booster to increase impacting intensity
摘要論述了多工況斜面沖擊試驗新系統,具有碰撞角度和壁障剛度可調,斜面沖程和沖擊角度可選,並裝有彈性助力系統以提高沖擊強度等特點。Geotextiles - determination of friction characteristics - inclined plane test
土工織物.摩擦特性測定.傾斜面試驗Testing of paper - determination of friction - part 2 : inclined plane method
紙張試驗.摩擦特性測定.第2部分:斜面法Geosynthetics - determination of friction characteristics - part 2 : inclined plane test
土工合成織物.摩擦特性的測定.第2部分:傾斜面試驗Test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method
用傾斜面法測試無塗層書寫紙和印刷紙靜磨擦系數的試驗方法Standard test method for monitoring ground movement using probe - type inclinometers
使用探針型傾斜儀檢測地面運動的標準試驗方法Trial panel to mastic aphalt pavement
斜拉橋-橋面瀝青路之試驗倉Test on blasted ore - formed inclined platform method for mining of deposit with multi - mined - out areas
多空區礦體斜面蹬碴落礦采礦方法試驗研究Based on tests of nine 1 / 2 - scaled model slabs under vertical loads, the paper analyzed load - deformation curve and proposed limit value of height - width ratio under axial loads. 2. based on aseismic tests, the paper put forward a model of concrete frame, silica brick and a combination of the two, proposed that the silica brick works as a 45 compression bar, analyzed the factors which may influence bearing capacity of the slab and advised a formula including the numbers of bays and of storeys of the frame
通過對墻板模型的抗震性能試驗研究,建立了由鋼筋混凝土框格、砌塊以及兩者協同作用三個部分組成的承載力極限狀態下的理論簡化計算模型;提出了墻板中填充塊等效斜壓桿寬度按45度計算的統一量化標準;分析了影響墻板承載力的主要影響因素,給出了表達墻板框格層數和跨數不同的斜截面承載力實用設計計算公式。The curves of the consolidation settlement in soft clay base of flood land are gained, which compare the effect of sand drain. the settlement - time curves in different period are also gained, which increase the height of embankment to 8m, based on the test data of hang - yong highway. furthermore, the consolidation settlement characters of these entity engineering are analyzed, and, the variation rules of the rate of grade and degree of the curves in different period in the whole section, the maximal settlement and the liner regression relations between the rate of grade and degree are calculated
本文利用大變形固結有限元分析程序( lscfea )中的小變形平面固結分析單元( sse2 ) ,結合實體工程項目進行了地基固結沉降的有限元計算,分別得出河灘相軟土地基在考慮砂井和未考慮砂井作用下的固結沉降曲線及杭甬高速公路試驗段在高堆載情況下的固結沉降曲線;並對以上曲線特徵進行了分析,得出各時間段曲線斜率、角度在整個斷面的變化規律,以及沉降最大值與斜率、角度變化之間的線性回歸關系。Preliminary conclusions are got through the analysis of the experimental data such as effect of the ice velocity on the ice force, ratio of components of forces when ice sheet acting on the vertical bank - head, ice force ratio of vertical to 45 incline as well as ratio of level ice force to the vertical ice force when acting on 45 incline
對試驗數據諸如冰速對冰力的影響、冰排作用於垂直面堤頭時各向分力的關系比、垂直面與45斜面冰力關系比以及作用於45斜面時其水平與垂直冰力的關系比等進行了分析,並得到初步結論。Standard test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method
用傾斜面法測試無塗層書寫紙和印刷紙靜磨擦系數的標準試驗方法Bi - material interfacial fracture theories are researched with a phenomenon that cracks extend along interface. a gradient invading model of interface crack at the crack tip can gain stress fields along interface. so a formula of energy release rate for 3d braided cmc is deduced and the corrected formula of the energy release rate is examined with test results
研究了裂紋沿界面擴展的雙材料界面斷裂理論,利用傾斜侵入界面的裂紋模型解析了裂紋尖端沿著界面的應力場,推導了表徵三維編織cmc復合材料斷裂韌性的能量釋放率公式g _ c ,並且用試驗結果驗證了能量釋放率公式的正確性。Calculation method and test investigation of oblique section consolidation of reinforced concrete bridge
橋梁加固鋼筋混凝土受彎構件斜截面承載力計算方法及試驗研究The point of this test was to find out if unfolding the aluminum foils wrapping the backs of the aerogel tiles would tilt or distort the aerogel significantly
此項試驗的目的是查明打開包裹在凝膠塊背面的鋁襯板是否會對凝膠塊造成顯著的扭曲或傾斜。By doing single fracture drainage experiments, this paper has successfully presented the logarithm function relationship between ratio of drainage discharge through upward and plumb drainage hole and the ratio of their equivalent diameters. the drainage effect will be the best when the included angle between drainage hole and fracture surface is 21 ~ 36
4 、通過單裂隙排水試驗,建立了傾斜孔和垂直孔的排水量之比與其交界線的等效直徑比之間的自然對數關系式,排水孔排水量基本隨其與裂隙面的交角減小而增大;對單組裂隙排水的初步分析表明,排水孔與裂隙面的夾角在21 ~ 36范圍內排水效果最佳。The main purpose of this paper is to realize the section properties and moment capacities of profiled sheets by experimental study and academic analysis for three types of profiled metal sheets which are called u450, u860and super combination profiled metal sheets produced by shanghai baosteel metallurgical construction corporation. its main contents include : ( l ) according to " european recommendations for the testing of profiled metal sheets ", the moment capacities of 32 full - size u450 and u860simple and continuous specimens are tested. ( 2 ) using the finite element program ansys and nonlinear finite element method, the moment capacities of super combination profiled metal sheets profiled are analyzed
主要內容有: ( 1 )依據《金屬壓型鋼板試驗歐洲建議》 ,進行了32塊1 : 1的u450 、 u860二類壓型鋼板試件簡支、連續板彎曲性能試驗研究; ( 2 )採用有限元程序ansys對超級組合壓型鋼板受彎性能進行了非線性有限元分析,分析中考慮了大變形與幾何初缺陷,得出其荷載?撓度曲線與極限荷載p _ ( max ) ,通過截面特性與曲線斜率、極限荷載的關系式得到截面特性;並將分析結果與同濟大學試驗結果進行對比分析。Experimental study on shear strengthening with cfrp in negative area of cantilever beams
碳纖維加固鋼筋混凝土矩形截面外伸梁斜截面試驗研究Geosynthetics - determination of friction characteristics - part 2 : inclined plane test iso 12957 - 2 : 2005 ; german version en iso 12957 - 2 : 2005
土工合成織物.摩擦特性的測定.第2部分:傾斜面試驗分享友人