斷油轉速 的英文怎麼說

中文拼音 [duànyóuzhuǎn]
斷油轉速 英文
cutoff speed rpm
  • : Ⅰ動詞1 (分成段) break; snap 2 (斷絕;隔斷) break off; cut off; stop 3 (戒除) give up; abstai...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 轉構詞成分。
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • 轉速 : speed; revolution; rotation rate; speed of revolution; rotating speed; rotational speed轉速指示器...
  1. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載,模擬機車運行,對機車的主發電動機的電流、電壓和柴機的等參數進行檢測,並對檢測結果進行處理,計算出模擬機車運行時的功率,並以此為依據,對機車的工作狀念進行判,通過水阻試驗,調整有關參數,使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  2. In this paper, the rotating machinery at high speed is studied. there are discussed about numerical calculating methods for non - linear dynamical system, the rotor system radial impact and rubbing dynamics behavior analysis having the nonlinear rigidity on the unsteady and non - linear oil film, the rotor system dynamics behavior analysis with bending - torsional - pendular coupling vibrations, application of wavelet, fractal and network in fault diagnosis. the main works in this paper are as follows : ( 1 )

    本文以高機械為主要研究對象,系統、深入地研究了非線性動力學系統的數值計算方法、具有非線性剛度的子系統在非穩態非線性膜力作用下的徑向碰摩動力學行為、子彎扭擺耦合振動的動力學分析、小波和分形理論及人工神經網路在故障診中的應用問題。
  3. Micro - controller was programed to measure the width of engine running speed signal successively, via pdiusbd12 these measured data are transmitted to pc, according to some algorithm, for pc program to analyze, process and display angular acceleration, thus diagnose diesel engine

    單片機連續採集信號的脈沖寬度,同時通過pdiusbd12將採集的數據上傳到個人電腦,供電腦按照特定的演算法分析和處理,以進行角加度波形顯示和柴機故障診
  4. Introduced working state real time monitoring and testing, fault diagnosis system and its key instrument, including the working principle of torsion, axial force, rotary speed as a whole sensor, the main parameter index of oil well using progressing cavity pump

    介紹了螺桿泵採系統工況實時監測與故障診系統及其核心儀器:扭矩、軸向力、一體化傳感器工作原理、主要參數指標。
  5. Abstract : introduced working state real time monitoring and testing, fault diagnosis system and its key instrument, including the working principle of torsion, axial force, rotary speed as a whole sensor, the main parameter index of oil well using progressing cavity pump

    文摘:介紹了螺桿泵採系統工況實時監測與故障診系統及其核心儀器:扭矩、軸向力、一體化傳感器工作原理、主要參數指標。
  6. Cutoff speed rpm

    斷油轉速
  7. According to the theory of developing viscous crude with screw pump and combined with the reservoir characteristic and oil property, fault block 70 is developed reasonably and effectively through a series of corollary technique including chemical pre - processing in the formation, viscosity decrease in the well bore, down - hole anchoring of screw pump, optimized design of screw pump, reasonable determination of the turning rate of screw pump, frequency alternating control, heat exchange and viscosity decrease in well head, monitoring of screw pump

    依據螺桿泵開采重的理論,結合澤70塊稠藏的特點和原物性,通過實施地層化學預處理、井筒降粘、螺桿泵井下錨定、螺桿泵優化設計、螺桿泵合理的確定、變頻控制、井口換熱降粘、螺桿泵監測等一系列螺桿泵配套工藝技術,使澤70塊得以合理有效的開發。
  8. The results show that there exists such nonlinear dynamical phenomena as chaos ang quasi - period movement when the rotational speed, mass eccentric and a synthesizing parameter of the system change. from different point of view, the chaotical phenomenen induced by double period bifurcation is found. in this paper, the dynamical model of bearing - elastical rotor with a cross - section of crack is estabilished

    結果表明,在這一非穩態膜力模型下,在、無量綱偏心及一包含諸多因素的綜合參數的變化過程中,在很大的范圍內,系統運動都會出現由不倍周期分岔導致的混沌現象和概周期運動。
  9. All collected data is transmitted to portable computer through parallel port by epp protocol, so diesel working status can be test in field and diesel ' s fault can be diagnosed without disassembly

    該儀器只有兩種傳感器,採用基於單片機的數據採集箱高採集柴機瞬時管壓力信號,使用便攜式電腦通過并行介面以epp協議進行數據採集控制和分析,以實現對柴機工作狀態的現場檢測與不解體故障診
  10. Added diagnostic function of engine system, abs, at and srs for atos f lift 2006. 2. added a diagnostic function of gas engine system, diesel engine system, abs, at, srs and power steering system for getz 2006

    2新增了getz車型2006年款下的汽發動機系統,柴發動機系統,自動變箱系統,防抱死剎車系統,安全氣囊系統和電動向系統的診功能。
  11. Abstract : the simulated calculation and analysis of the fluctuation of the instantaneous speed of a diesel engine are presented. the important factors, influencing the measurement precision of the instantaneous speed, are discussed. the correct measurement method is presented. the instantaneous speeds of diesel engine are measured and processed in a laboratory condition. compared the simulated instantaneous speed with the measured instantaneous speed, the simulated result is correspondence with the measured result. the characteristic parameters and the criteria of the instantaneous speed for detecting the leakage of valves in diesel engine are provided, and diagnosis accuracy is confirmed on 4120sg diesel engine

    文摘:對瞬時波動進行了模擬分析計算;實測了發動機的瞬時;對比了實測與模擬計算的瞬時波形,兩者相當一致;討論了影響瞬時測量精度的關鍵因素;提出利用瞬時進行故障診的特徵參數及判據,並在診4120sg型柴機氣門漏氣故障中得到證實
  12. The simulated calculation and analysis of the fluctuation of the instantaneous speed of a diesel engine are presented. the important factors, influencing the measurement precision of the instantaneous speed, are discussed. the correct measurement method is presented. the instantaneous speeds of diesel engine are measured and processed in a laboratory condition. compared the simulated instantaneous speed with the measured instantaneous speed, the simulated result is correspondence with the measured result. the characteristic parameters and the criteria of the instantaneous speed for detecting the leakage of valves in diesel engine are provided, and diagnosis accuracy is confirmed on 4120sg diesel engine

    對瞬時波動進行了模擬分析計算;實測了發動機的瞬時;對比了實測與模擬計算的瞬時波形,兩者相當一致;討論了影響瞬時測量精度的關鍵因素;提出利用瞬時進行故障診的特徵參數及判據,並在診4120sg型柴機氣門漏氣故障中得到證實
  13. Paper also introduces " locomotive diesel state monitoring and analyses system based on transient speed mode ? " which is appliance of power diesel in - line monitoring and analysis systemin railroad locomotive

    本文最後介紹了「基於瞬時模型的機車柴機狀態監測與分析系統」 ,該系統是電站柴機在線監測與分析系統在鐵路機車領域的應用實例。
  14. In large rotating machinery using filmatic bearing ( turbogenerator, air compressor, etc. ) there is a potential trouble from impefect installation or running conditions, a metals " contact between rotors and shells. the trouble is usully called rubbing. the advantage of ae technologe in the rubbing diagnosis and early detection is showed. instead of classical ae characteristic parameters ( counts, amplitude, energy, duration and the other ones ) a new feature extraction by frequency analysis of ae envelop signals is discussed. both research of ae process and field experements indicate that periodic components in the envelop spectrum related to rotational speed increase evidently at the beginning of rubbing production, hence are highly sensitive to the rubbing fault diagnosis. according to the new design an acoustic emission equipment for the rubbing diagnosis named buaa ae testing system is developed and described

    汽輪發電機、空氣壓縮機等採用膜支撐的大型動機械,由於安裝或運行中的原因,在子旋過程中,可能和器壁發生輕微的摩擦和碰擊,簡稱碰摩.聲發射技術在碰摩發生特別是故障早期診上有優越性.本系統的特點是沒有沿用傳統的計數、幅度、能量和持續時間等聲發射特性參數,而是在聲發射包絡信號的頻率分析中進行特徵提取.聲發射發生的過程分析和現場試驗都表明這種方法對碰摩檢測很敏感,在碰摩發生的起始階段,包絡譜中與同步的周期性分量顯著增加.根據這種新的設計思想自行研製了buaa碰摩聲發射檢測儀並對此作了介紹
  15. On the basis of advanced electric control technology, my works are carry on analysis and design about the hardware and software of ecu. the idle speed control aim is make gasoline keep well property under the low rotation. in accordance with 465q gasoline specific conditions, we take use of fuzzy control theory on idle speed control of gasoline, and make step - motor to idling executive body. appling intel 80c196kb chip, we program idling the main order, software time implement break sub - order and delay sub - order in compilation language

    控制的目的則是保證在較低的下保持汽機具有良好的性能,我們在分析465q汽機的具體情況的基礎上,把模糊控制理論用在汽機怠控制方面,用步進電機作為怠執行機構,並以intel的80c196kb單片機為主晶元設計了怠控制系統的軟硬體,用intel匯編語言設計了怠主程序,軟體定時器中服務程序,三相單三拍步進電機正反子程序,延時子程序匯編軟體。
分享友人