斷裂性試驗 的英文怎麼說

中文拼音 [duànlièxìngshìyàn]
斷裂性試驗 英文
breaking-down test
  • : Ⅰ動詞1 (分成段) break; snap 2 (斷絕;隔斷) break off; cut off; stop 3 (戒除) give up; abstai...
  • : 裂動詞[方言] (東西的兩部分向兩旁分開) open
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  • 試驗 : trial; experiment; test
  1. Standard test method for outdoor evaluation of tire sidewall component cracking resistance

    輪胎側壁組件抗能的室外評定標準方法
  2. A charpy test is usually much less expensive to perform than a fracture toughness characterization experiment.

    夏比(沖擊)通常要比的費用低得多。
  3. Fracture mechanics toughness tests - method for determination of kic, critical ctod and critical j values of welds in metallic materials

    機械韌.第2部分:金屬材料焊接的kdownidownc值臨界ctod值和臨界j值的測定方法
  4. In the first part of this dissertation, theory of fracture mechanics of the frozen soil has been presented. a general strength theory based on fracture mechanics was proposed, and the validity of the theory using in frozen soil was discussed. the fracture toughness values for different kinds of cracks extension were determined, such as the plane strain fracture toughness for mode i cracking ( kic ), fracture toughness for mode cracking of frozen soil and the intersection of frozen soil and concrete

    論文第二章為凍土力學的基本理論,包括力學在凍土研究中的工程適用、條件適用、平面應變韌度測的適用條件等,給出了凍土韌度k _ ( c ) 、 k _ ( c ) 、 -型復合的基本原理及方法,並基於weibull脆破壞理論推導了凍土三點彎曲樣k _ ( c )尺寸效應系數,為後面的工作提供理論基礎。
  5. Methods of test for rubber and plastics hoses and hose assemblies - physical tests - determination of fracture resistance of rigid polymer helical reinforcement in thermoplastics hoses

    橡膠和塑料軟管組件的方法.第103部分:物理.第7節:熱塑軟管用剛聚合物螺紋鋼筋耐測定
  6. The test results show that, the fracture properties of adherence of new and old concrete are evidence lower than the new concrete itself

    結果表明,新老混凝土粘結能明顯低於新混凝土整體件的能。
  7. A ; insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜絕緣護套材料的通用方法.第4部分:聚乙烯與聚丙烯復合物專用方法.第2節:預處理后的伸長率預處理后的翹曲在空氣中熱老化后的翹曲增加量測量長期穩定
  8. Testing method for fracture toughness of fine ceramics at elevated temperature

    高溫下細陶瓷方法
  9. Insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用方法.聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和伸長度.高溫處理后的卷繞.在空氣中熱老化后的卷繞.質量增加的測量.長期穩定.催化銅氧化降解的方法
  10. Fracture mechanics toughness tests - method for determination of fracture resistance curves and initiation values for stable crack extension in metallic materials

    機械韌.金屬材料穩定紋延伸的抗曲線和初始值的測定方法
  11. Standard practice for fracture toughness testing of aluminum alloys

    鋁合金的標準實施規程
  12. Standard practice for plane - strain fracture toughness testing of aluminum alloys

    鋁合金的平面應變的標準實施規程
  13. Fracture mechanics toughness tests - method for determination of fracture toughness of metallic materials at rates of increase in stress intensity factor greater than 3. 0 mpa m0. 5 s - 1

    機械韌.應力強度因子大於3 . 0 mpa m0 . 5 s - 1的增長速度下金屬材料的測定方法
  14. The main contents of this paper are as follows : 1. the fracture test results of 87 adhesive specimens of new and old concrete are presented. the failure patterns and main influencing factors of the specimens are discussed and analyzed, such as interfacial roughness, types of adhesive agent, size of the aggregate, adhesive ages of new and old concrete

    進行了四組24水平共計87個新老混凝土粘結件的,討論了新老混凝土粘結的機理及影響能的主要因素,如老混凝土界面的粗糙度、界面劑類型、混凝土粗骨料最大粒徑、粘結齡期等。
  15. A. common test methods for insulating and sheathing materials of electric cables - part 4 : methods specific to polyethylene and polypropylene compounds - section 2 : elongation at break after pre - conditioning - wrapping test after pre - conditioning - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test appendix a - test method for copper - catalysed oxidative degradation appendix b

    電纜絕緣和鎧裝材料的通用方法.第4部分:聚乙烯與聚丙烯復合物專用方法.第2節:預處理后的伸長率.預處理后的纏繞.空氣中熱老化后的纏繞.增加量的測量.長期穩定
  16. Common test methods for insulating and sheathing materials of electric cables. part 4 : methods specific to polyethylene and polypropylene compounds. section two : elongation at break after pre - conditioning - wrapping test after pre - conditioning - wrapping test after thermal ageing in air measurement of mass increase - long - term stability test appendix a. test method for copper catalysed oxidative degradation appendix b

    電纜絕緣和護套材料通用方法第4部分:聚乙烯和聚丙烯混合料專用方法第2節:預處理后伸長率-預處理后卷繞-空氣熱老化后的卷繞-測定質量的增加附錄a :長期熱穩定附錄b :銅催化氧化降解方法
  17. Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用方法.第4 - 2部分:聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和伸長度.高溫處理后的卷繞.在空氣中熱老化后的卷繞.質量增加的測量.長期穩定.催化銅氧化降解的方法
  18. 2. based on the adhesive fracture test results of new and old concrete with the three point bending test method, the main influence factors of the adhesive fracture toughness are analyzed by means of the square - residual method. the multi - factor formula of adhesive fracture toughness is put forward, which will give the reference to the repairing and strengthening of concrete structures

    在新老混凝土粘結的基礎上,對影響新老混凝土粘結能的主要因素進行了顯著分析,各因素對粘結韌度影響的顯著大小依次為界面粗糙度、界面劑類型、粘結齡期、混凝土強度、混凝土粗骨料最大粒徑等;並給出了新老混凝土粘結韌度的多因素計算公式,可為工程設計和加固維修提供參考。
  19. Insulating and sheathing materials of electric cables. common test methods. part 3 : methods specific to pvc compounds. section 1 : pressure test at high temperature. tests for resistance to cracking

    電纜絕緣和護套材料.通用方法.第3部分:聚氯乙烯化合物專用方法.第1節:高溫下的壓力.耐斷裂性試驗
  20. Test method of interlaminar fracture toughness of carbon fiber composite laminates in hot - wet environments part 2 : test method of mode interlaminar fracture toughness

    碳纖維復合材料層合板濕熱環境下層間方法.第2部分:型層間方法
分享友人