斷裂槽 的英文怎麼說

中文拼音 [duànliècáo]
斷裂槽 英文
rupture groove
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 槽 : 名詞1 （盛牲口飼料或飲料等液體的器具） trough; manger （for water animal feed wine vat） 2 （兩邊...
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  1. The author also suggested that the fuxin block developed on the base of the geosyncline in the huabei craton, and had experienced three period process of orogeny, including hercynian folding orogeny in continental margin, mainly indo - sinian to early yanshanian intracontinental fold - faulting orogeny, and late yanshanian to early himalayaian intracontinental range - basin post orogeny

    認為阜新地塊是在克拉通裂陷槽基礎上發育起來的，經歷了海西期陸緣褶皺始造山、印支?早燕山陸內褶斷主造山、晚燕山?早喜馬拉雅陸內盆山後（重）造山等過程。
  2. The hongqiling cu - ni ore deposit is located to the northern flank of a contacting zone ( the huifahe fault systems ) between the north china platform and the jilin - heilongjiang syncline system

    摘要紅旗嶺銅鎳礦床地處華北地臺與吉黑地槽系接觸帶輝發河斷裂北側。
  3. Some conclusions are listed as follows : the plateform cover cap of ordos basin and its circumference areas can be divided into five tectonic sequences. the tectonic evolution of ordos basin can be classified in six stages : the basement formation phase ( from archeozoic to paleoproterozoic ) ; the aulacogen phase ( from mesoproterozoic to neoproterozoic ) ; the north china continental sea phase ( from sinian to early - paleozoic ) ; the north china intracratonic depression phase ( from late - paleozoic to early mesozoic ) ; large ordos inland basin phase and the formation of independent ordos basin ( mid - late mesozoic ) ; fault basin phase around the ordos basin ( cenozoic )

    通過研究有以下成果及認識：鄂爾多斯盆地及其周緣地區沉積蓋層可劃分為五大構造層序，盆地的形成和演化分為六大構造階段：太古代至古元古代基底形成階段、中新元古代克拉通內裂陷槽或坳拉槽演化階段、震旦紀?早古生代華北陸表海盆演化階段、晚古生代?早中生代華北克拉通坳陷演化階段、中生代中晚期大鄂爾多斯內陸盆地演化階段及獨立鄂爾多斯盆地的形成、新生代周緣斷陷盆地演化階段。
  4. Rift zones are elongated troughs bounded by faults

    斷裂帶是以斷層為邊界的狹長凹槽。
  5. Analysis of tendency of ductile fracture at corner of workpiece during grooveless rolling

    無槽軋制軋件角部的韌性斷裂趨勢分析
  6. Based on the theory of detonation dynamics and fracture mechanics and combined with engineering experiences, the parameters of soft rock tunnel hole charge and smooth blasting are analysized to enhance tunnel excavation proficiency in soft rock and smooth blasting. value scope of smooth blasting is acquired, which can give some experience for parameters design and construction of smooth blasting in soft rock tunnel excavation

    摘要為提高軟巖巷道掘進效率和光爆效果，利用爆轟動力學和斷裂力學理論，分析了軟巖巷道掏槽及光爆參數，結合工程實踐經驗，得出了軟巖巷道光面爆破參數的取值范圍，對軟巖巷道爆破參數的設計和施工具有一定的指導意義。
  7. From the results of constraining fault displacement and correlation between the sediments in these trenches, we found a complete paleoseismic activity history on the fault segment during that period of time

    由斷層位移量限定法和多探槽校驗法判定，這一時期該斷裂的古地震活動歷史是完整的。
  8. A detailed study on geomorphic surfaces and a set of trenches on the hohhot segment of daqingshan piedmont fault at three sites, kuisu, ulan blang, and qingshan grassland, revealed 7 paleoseismic events occurring on the fault segment since 19 ka bp

    摘要通過沿大青山山前斷裂呼和浩特段的奎素、鳥蘭不浪和青山牧場3個地點地貌面和探槽組的精細研究，揭露出該斷裂段距今約1 . 9萬年以來共發生7次古地震事件。
  9. It is therefore proposed in this paper to strengthen the exploration of such wide and deep subsags as chagannuoer and hongqi subsags, to lay emphasis on the exploration of superposed and residual fault depression, and to pay attention to the discovery of various oil and gas reservoirs including metamorphic buried hills, fracture slope breaks, and volcanic rocks, etc

    因此，指出下一步應加強類似查干諾爾，紅旗等寬深窪槽的勘探，重視具疊合型和殘留型斷陷的勘探，注重尋找包括變質巖潛山，斷裂坡折帶、火山巖等在內的各類油氣藏。
  10. With analysis on the forming process of a deep drawing part, the process of the reason for crack due to thinning and wrinkling during sheetmatel deep drawing is discussed, and the solution is also put forward

    摘要通過對備胎槽零件進行拉深成形的工藝分析，介紹了模具調試的過程，分析薄板料的深拉深成形危險斷面的變薄與起皺造成碎裂的產生原因、解決方法，以及採取的措施。
  11. Experiment on dynamic rock facture toughness using edge - notched disc specimen

    邊切槽圓盤試樣的巖石動態斷裂韌度實驗
  12. Waved lines can ' t be drawn in holes, grooves or outside the outlines, because there are no broken trails. if the cutting position is obvious, it needn ' t be signed

    波浪線不應畫在通孔、通槽內或畫在輪廓線外，因為這些地方沒有斷裂痕跡。剖切位置明顯的局部剖視圖可以不標注。
  13. The network carbide and acicular martensites that existed in the microstructure of the root grooves of the spline due to improper carburating and quenching process of the shafts, led to the initiation and propagation of the intergranular microcracks and were the main reason that caused the early fracture of the shafts

    由於滲碳淬火工藝不當，在二軸花鍵槽根部的組織中產生了網狀破化物和粗大的針狀馬氏體，在外力作用下形成沿晶顯微裂紋並擴展，是導致二軸疲勞斷裂的主要原因。
  14. Using the modal taking into effects of the notch width., this paper also compute the stress intensity factor of ccnbd suggest by isrm for rock fracture toughness test. and some conclusions have been made in this research

    本文還對國際巖石力學學會（ isrm ） 95年方法推薦的ccnbd斷裂韌度試樣採用考慮切槽寬度的模型進行了計算，得到一些有意義的結論。
  15. Most researchers working in rock field proposed that the hopkinson system be a ideal dynamic - loading equipment and the brazilian disc be a novel specimen. according to the above, this paper suggests a new method to test the dynamic strength and dynamic fracture toughness, firstly leads the cracked chevron notched brazilian disc ( ccnbd ) which was recommended by international society for rock mechanics ( isrm ) in 1995 in testing dynamic fracture toughness, which brings in a new way in dynamic testing for rock. it is expected that the work of this dissertation will provide important basis for the further research and application of mechanical behavior of rock

    結合巖石動力學領域普遍採用的動態加載設備即分離式hopkinson壓桿裝置和新穎的平臺巴西圓盤試樣，本文提出了一套測試巖石動態強度和動態斷裂韌度的新方法，並首次將國際巖石力學學會（ internationalsocietyforrockmechanics ? isrm ）於1995年推薦的人字形切槽巴西圓盤（ crackedchevronnotchedbraziliandisc ? ccnbd ）試樣引入動態斷裂韌度的測試中，為巖石的動態斷裂力學參數的測試找到了一條新的途徑。
  16. Disc specimens have great application in testing the mechanic properties of rock, such as the cracked chevron notched brazilian disk ( ccnbd ) and the cracked straight - through brazilian disc ( cstbd ) used in testing rock fracture toughness, the brazilian disc and the flatted brazilian disc ( fbd ) used in testing rock tensile strength

    圓盤類試樣在巖石的力學性質測試中有著廣泛的應用。如應用於巖石斷裂韌度測試的人字型切槽巴西圓盤（ ccnbd ） ，中心穿透直裂紋巴西圓盤（ cstbd ） ，應用於巖石抗拉強度測試中的巴西圓盤試樣和平臺巴西圓盤（ fbd ）等試樣。
  17. 1. the topographies of cutting grooves and cutting chips were observed by means of scanning electronic microscope, and sawing mechanism of concrete was analyzed, based on the properties and fracture mechanics of concrete. 2

    採用掃描電鏡（ sem ）和體視顯微鏡觀察單顆粒金剛石切削混凝土溝槽表面形貌和切屑形態，並結合混凝土的特性及斷裂力學性能，分析研究了混凝土材料的切削加工機理。
  18. Based on the theoretical analysis of splitting mechanics and by the dynamic photoelasticity experiment, we studied the judgment how rock and concrete split under the affection of notched blasting. we built up the splitting mechanics model of rock and concretes under the affection of notched blasting. beyond all above, we gain the mechanism of notched directional splitting controlled blasting

    本文在斷裂力學理論分析基礎上，通過動光彈爆破實驗，探討了在切槽爆破作用下巖石和混凝土的斷裂判據，建立了在切槽爆破作用下巖石和混凝土的斷裂力學模型，並由此得出切槽定向斷裂控制爆破機理。
  19. Therefore, it is very important to study the mechanism and the related parameters of notched directional splitting controlled blasting

    因此研究切槽定向斷裂控制爆破的爆破機理及相關參數，具有十分重要的意義。
  20. The direction of crack in rock can be well controlled towards a special way by notched directional splitting controlled blasting

    切槽定向斷裂控制爆破可使巖石沿特定的方向破裂，裂紋方向性好，產生的經濟效益非常明顯。
分享友人
分享到 Line

分享到臉書