方向控制迴路 的英文怎麼說

中文拼音 [fāngxiàngkòngzhìhuílù]
方向控制迴路 英文
direction control circuit
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 方向 : direction; orientation
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Based on the hydromechanics principle, the hydraulic equipment can push compressive oil into actuators by the pressure and direction control circuits. the piston of actuator translates distributed pressure into centralized force of piston rod

    液壓加載根據液壓流體力學原理，利用液壓元件組成的壓力和方向控制迴路，將一定壓力的油液輸入液壓缸，由液壓缸內的活塞把分佈的油壓轉變為集中力，最後經活塞桿輸出。
  2. On the base of the character of hemisphere continuously vibrating, the method of actuation and measuring, the asymmetry compensating process and the measuring limit were studied, the control loop and the parameter design were introduced, which will be prepared for the future circuit design and the automobile security application

    本論文主要是在半球連續振動特性的基礎上，對陀螺儀的驅動及感測方法、非軸對稱的補償方法及感測極限進行研究，並詳細介紹其控制迴路與其參數的設計，為以後電路設計和面向汽車安全的應用打下了堅實的理論基礎。
  3. According to the test conditions, the double polarity inputting mode is adopted in the circuit of voltage - frequency converting part ; storage batteries are used in the optical emission part of optical fibre isolating and transmitting device, that can guarantee isolation between the main circuit and the testing system ; the 89c51 singlechip is used in the singlechip testing - controlling unit, the peripheral circuits are extended, data are transmitted through the serial port in this part ; the p opular software delphi5. 0 is used in the pc part, the communication between singlechip and pc by serial port, plotting of current wave, regulation of data ; the optical - electrical isolating and triggering are used in the controlling part, this can guarantee the veracity and reliability of breakers triggered, this triggering mode is also used in the triggering of the main closing breaker, the tested breaker and the assistant breaker, the triggering signals are sent out by a singlechip

    壓頻轉換部分電路中根據實際情況採用了雙極性輸入方式；光纖隔離傳輸裝置的光發射部分電源採用了蓄電池供電，確保了主迴路與測試迴路的完全隔離；單片機測控部分採用了89c51單片機，擴充了外圍電路，通過串口向pc機傳送數據； pc機與單片機之間的串口通訊、波形繪制、數據管理等都採用了軟體delphi5 . 0編寫。該測試系統中預留了輸出口，可以對合成迴路中的主合閘開關、被試開關、輔助開關進行觸發，信號由單片機發出，控制部分採用了光電耦合隔離觸發的方法。軟體設計主要集中在對電流信號的數據採集、數據處理、數據傳送、人機界面、波形繪制和數據管理，軟體部分又可分為單片機和pc機程序設計兩大部分。
  4. The respect drive system design : the servo valve commonly used in the closed - loop control system is replaced with the proportion direction valve, and controlled it with the methods of electrohydraulic proportional control. the system adopts the hydraulic circuits that prevent the simulating table letting down because it own weight take place

    驅動系統設計方面：用比例方向閥取代了液壓閉環控制系統中常用的伺服閥，採用電液比例技術對其進行控制，並在液壓油路中採用了防止因模擬轉臺自重而產生緩慢下滑的液壓迴路。
  5. Electro - hydraulic control principle applied in construction machinery is analyzed in this paper ; working principle and application characteristic of electro - hydraulic proportional is lucubrated ; technique and static characteristic of electro - hydraulic proportional decompression value and electro - hydraulic proportional direction value is emphatically analyzed and studied ; electro - hydraulic proportional control mode is setup. the hydraulic circuit which can be not only suit for handle operation but also for remote operation in the same construction machinery, and the hydraulic system design methods is also introduced that the proportion control use d for the steering devices and the working devices of the machine

    本文對工程機械上應用的電液控制原理進行了分析；對電液比例閥的工作原理和應用特點進行了深入研究；重點對電液比例減壓閥和電液比例方向閥技術特徵和靜態特性進行分析研究；建立電液比例控制模型；提出了在同一臺工程機械上，既能滿足遙控又能滿足手控的液壓迴路，以及採用比例量控制行駛和工作裝置的液壓系統設計方法。
  6. The method can eliminate the conventional fuzzy control system ' s steady - state errors and flutters. considering wind disturbance, the stabilized loop of pitch angle was designed and simulated with this method

    9採用帶優化修正函數無量化的模糊控制方法設計國產直九c海豚直升機的縱向姿態角穩定迴路系統。
  7. Abstract taking the electric control sircuit of the flanging machine as an example, this single electromagnet directional control calce is used to design the electric control circuit with several sequential cylinders

    摘要本文以卷邊機電氣控制迴路設計為例子來說明使用單電磁鐵換向閥進行多氣缸順序動作電氣控制迴路的設計方法。
  8. Form the practical engineering point of view, the longitudinal natural stability of anti - submarine helicopter is analyzed, the stabilized loop of the pitch angle is systematically studied. this paper is mainly on the design and simulation of the stabilized loop of pitch angle with classic control method and fuzzy control method and many useful results are achieved. the main work of this paper can briefly described as follows : after the mathematical models of aircraft was build with relevant date, the stabilized loop of pitch angel was designed and simulated

    本文從工程應用的角度出發，分析了國產直九c反潛直升機的縱向自然穩定性，分別應用古典控制和模糊控制的方法，系統地研究了國產直九c直升機的縱向姿態角穩定迴路、速度迴路、高度迴路、自動過渡等，對縱向姿態角穩定、速度、高度、自動過渡迴路進行了控制律的設計與模擬，取得了良好的控制效果。
分享友人
分享到 Line

分享到臉書