方程式論 的英文怎麼說

中文拼音 [fāngchéngshìlún]
方程式論 英文
theory of equations
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 方程式 : capeta
  1. The close agreement suggests the adequacy of the preceding theoretical equations.

    由於吻合程度好，說明上述理論方程式是適用的。
  2. At last, based on the theory of cubature, the multivariate linear regression equations are built up, and the traffic conversion coefficient of the controlled intersection junction are deduced

    最後，以容量法為理論基礎，建立多元線性回歸方程式，推導出信號交叉口車輛折算系數。
  3. In this paper, the problem of limit cycle for a cubic system is studied

    摘要討論三次系統（方程式略）的極限環問題。
  4. The branch of algebra that deals with quadratic equations

    二次方程式論處理二次方程式的代數學的分支
  5. In this study, we applied the reversibility of elastic wave to a discussion of the reverse time propagation of wave equation

    摘要本文應用波動方程式的可逆性討論彈性波的逆時影像重建。
  6. The paper proceeds from the transient equation for voltage and torque, analyze the electromechanic time constant of permanent - magnet dc servomotors based on the theory, and compare with the several testing methods which are used normal in the engineering, point out the difference and applying area also for the testing error which is led to possibly

    摘要為了準確評價伺服電動機的動態性能指標，從電機的電壓、轉矩平衡方程式出發，在理論上對永磁直流伺服電動機的時間常數進行了分析探討，並對工程實際中常用的幾種測試方法進行分析和比較，指出其差別和適用范圍以及可能造成的測試誤差。
  7. In this paper, we at fist analyse the distribution of magnetic field in the permanent magnet synchronous motor which rate power is 800w and calculate parameters of this motor on the basis of the traditional approach to ca1culating armature reactance, we put forward a new method which is based on the iteration of the electromotive force equation, and name it after " electromotive oprce method "

    本論文運用有限元方法分析一臺800w稀土永磁同步電動機內部電磁場的分佈情況，計算出相應的電機參數。並在傳統的計算電樞反應電抗的基礎上提出了一種基於電勢平衡方程式的計算方法，本論文稱之為「電勢法」 。
  8. The first example shows that the proposed model uses fewer fuzzy predicates achieving similar results with the traditional rule - based approach, while the second shows the performance can be significantly improved when the control - relevant constraints are considered

    本論文所提出的限制式模糊模塑架構與takagi - sugeno模糊模塑的差異，在於利用模糊限制式來取代一般的數學方程式。
  9. The wave - deviation methods are concerned, basing on the relations between the wave - deviation and spherical aberration, wave - color - deviation and color deviation. after the equation of optical system, initial structure resolved, the glass catalog having been allocated in the computer, the original solution can be worked out for the doublet and air - spaced doublet, triplet and air - spaced triplet rapidly and precisely. after a little modification by the computer, the satisfied results will be obtained

    論文由波像差與球差的關系，波色差與色差的關系推導出了波差法求解光學系統初始結構的方程式，再配以玻璃庫程序，可以較快、較準確地求解出雙膠合、雙分離、三膠合、三分離物鏡的初始解，然後再進計算機稍加校正，就可以得到滿意的結果。
  10. As the basis of enterprise growth management, sustainable growth theory mainly comprises sustainable growth rate and sustainable growth equation

    可持續增長理論是企業增長管理的理論基礎，可持續增長理論的核心內容是可持續增長率及可持續增長方程式。
  11. By use of - perturbation method with spatial discretization, the hydraulic transient system controlled by quasilinear partial differential equation was converted to a time - continuous linear system, so that the inverse problem of hydraulic transients under limited pressure could be sol ed with the optimal control theory for time - continuous systems

    採用-攝動法並經過空間離散，將由擬線性偏微分方程式控制制的有壓瞬變流系統轉化為時間連續線性系統，從而使有壓瞬變流限壓控制反問題能應用時間連續系統最優控制理論來求解。
  12. Reduce an equation, argument, issue to its simplest form.

    把某方程式、論據、問題化為最簡單形式。
  13. Equations of mesh, shorting contact line, undercutting limit line, meshing limit lines and the existence conditions, angle between the direction of relative speed and the direction of contact line, induced normal curvature about every point on the contact line are established. moreover, the paper also theoretically analyzed the error of the grinded gear surface. on the basis of the theory, the computer program is worked out to automatically produce the contact line and the boundary curves of mesh. analysis of meshing circs under different parameters can be done so that we can gain the best process condition

    首先對漸開面二次包絡理論進行了深入的探討，推導出了兩次嚙合的嚙合方程式、瞬時接觸線方程式、根切界限線方程式、嚙合界限線的方程式及其存在條件，相對運動速度方向與接觸線方向的夾角及接觸線上各點的誘導法曲率；此外，還對磨齒后工件的齒面誤差進行了理論分析；並在理論基礎上編制了相應的計算機程序，自動生成接觸線族及嚙合界限線，對不同參數條件下的嚙合情況進行分析，可以使工藝條件達到最佳狀態；最後研究了磨齒裝置，設計了磨齒機的傳動系統。
  14. Three parts are included as follows : first of all, the basic circuit equation of radial pm generator for autos is given. the effect of reciprocity of pm and winding ' s magnetic force upon winding ' s inductance and current upon magnetic circuit saturation are analysed. according to these, we can obtain optimized design

    首先，從本課題採用的徑向式結構的三相永磁同步發電機的物理模型出發，得出其基本電路方程式，並分析了永磁磁動勢與繞組磁動勢間相對位置的不同而對繞組電感不同的影響，相電流對磁路飽和效應的影響，為車用永磁發電機的優化設計提供了理論依據。
  15. And that this corrected equation is itself only an imperfect a roximation to an infinite set of quantum field - theoretical equatio

    而這個得以糾正的方程式就其本身而言也只是一個不完美的近似值，趨近於無窮無盡的一整套量子場論方程式。
  16. After all, it took many years for the quantum idea, as put forth by max planck, einstein and niels bohr, to be encapsulated into the schr ? dinger equation, and more time still to be made compatible with special relativity

    畢竟，普朗克、愛因斯坦、波耳提出的量子論也要隔好多年才有辦法納入薛丁格方程式，又隔了好一陣子才能與狹義相對論相容。
  17. According to the power equation of pipe ozone cell, this paper takes advantage of the advanced technology and experience of ozonier, analyses and discusses the approach of improving the power and efficiency of the ozone generator

    本文借鑒了國內外臭氧發生器先進技術和經驗，根據管式臭氧發生器放電室的電暈放電功率方程式，分析討論了提高臭氧發生器功效的途徑。
  18. Then. with the help of some good results of differential equations theory, some sufficient conditions for all solutions of the equations to be oscillatory are obtained. the way is to proof by contradiction and construct sequence

    1 ）的振動性，首先，利用積分變換，給出了幾個引理，將此類差分方程轉化為相應的微分方程或微分不等式，得出了新變量的一些重要性質；然後用反證法和構造序列的方法，充分利用微分方程理論中的一些重要結論，得到此類差分方程解振動的若干充分條件
  19. When the isotropic waveguide is under the isotropic disturbances, the coupling term due to polarization, which is presented in the coupled - mode theory of the wei - ping huang, is n ' t included in this rigorous vectorial coupled - mode theory, exactly, the rigorous vectorial cmt does n ' t contain the coupling term due to polarization which is include in the scalar coupled - mode theory because this term is counteracted with the other coupling term neglected under weakly guiding approximation. as for anisotropic disturbances, we get the coupled - mode equations with arbitrary dielectric tensors. from them, we obtain the coupled - mode equations of the slowly varying term c ( z ) which is more simplicity

    當受到各向同性微擾時，我們發現嚴格的矢量理論所得到的耦合系數表達式中並不包括wei - pinghuang的理論中的偏振耦合項，更確切的說，偏振耦合項正好與因弱導近似而忽略的項相抵消，這就是標量理論所得到結果（有偏振耦合項）與矢量理論在標量近似下的結果（不含偏振耦合項）不一致的原因所在；當各向異性微擾時，我們得到了包含微擾介電張量各個分量的橫電磁場耦合波方程，討論了微擾介電張量各個分量對耦合的影響，而且從橫電磁場耦合波方程出發得到了形式更加簡單的只含有橫電場系數的緩變分量c _ （ z ）的耦合波方程和耦合系數表達式，並以弱導近似下的單模光纖兩正交偏振模耦合為例對耦合系數在不同條件下的取捨做了定性的分析。
  20. In the paper, based on the method of low pair replacing with high pair, the problem of cam design was transferred to that of linkage design. by means of rotary unit vectors, the equations of displacement, velocity and acceleration of the replacement mechanisms were developed. and then, the virtual linkage ' s length and direction were deduced

    論文基於高副低代原理，將平面凸輪機構設計與再現函數的平面連桿機構設計統一為同一種方法，運用圓向量函數建立代換機構的位移、速度、加速度矢量方程式，求取虛擬連桿桿長和方向，由此展開凸輪理論廓線、實際廓線、曲率半徑和壓力角的求解，並得出用圓形刀具加工凸輪時刀具中心的軌跡方程。
分享友人
分享到 Line

分享到臉書