施加載荷 的英文怎麼說

中文拼音 [shījiāzǎihé]
施加載荷 英文
applied load
  • 施 : Ⅰ動詞1 （實行; 施展） execute; carry out 2 （給予） exert; impose 3 （施捨） give; hand out; best...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 施加 : exert; bring to bear on; impose
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. The bird strike is similar to adding a high velocity rate loading to the aircraft wndshield, and thus results in the wndshield ' s high stain rate deformation

    飛鳥對于風擋的撞擊，類似於對于風擋施加一高速率的載荷，從而引起風擋材料以很高的應變速率變形。
  2. Dead weight loading simulating that of the bolts was applied at the bolt holes through the agency of steel balls and buttons.

    螺栓荷載是用死荷重來模擬的，以鋼球和壓鈕作為代用件，通過它們將此荷載施加於螺栓孔。
  3. The live loads were applied by a standard system of ring dynamometers with attachment points distributed uniformly on the upper surface of the decking.

    用一系列標準環式測力計施加活荷載，其接觸點均勻分佈於面板的上部表面。
  4. The emission observed while holding at the proof load provides another piece of information regarding the imminence of failure.

    在驗證載荷施加期間，檢測聲發射還能額外地提供有關破壞臨近程度的信息。
  5. Loads exerted by irish potatoes in shallow bulk storage structures

    淺桶式散裝儲藏結構中愛爾蘭馬鈴薯施加的載荷
  6. At zero applied load, the crack is closed along the perimeter of the specimen but open in the center.

    在施加零載荷處，試樣周邊的裂紋是閉合的，而中心則是張開的。
  7. The pivot and race surfaces were true surface of revolution and were correctly centered when no load was applied.

    軸樞和套圈的表面是準確的旋轉表面，並在未施加載荷正確對中。
  8. In this test, a special bolt - jack is used to exent of prestressing force to brace angles as the whole structure is under dead - load. in this state brace angles withstand partly load before twice - load and the stress and strain of concrete are decreased. in this way the aim of removal of load and strengthening can be reached

    本試驗中採用專用螺栓千斤頂在恆定荷載水平下對混凝土柱角鋼撐桿施加預壓應力，使外包角鋼在二次受力前即分擔部分荷載，使混凝土應力水平和應變水平降低，達到卸載與加固同步進行的目的。
  9. The external forces include reactions (r)as well as applied loads(p).

    外力包括反力R和施加力荷載P。
  10. Considering the similitude law for shaking table test, we study the test results and obtain some conclusions which are a ) generally, the silty soil in test box liquefies and the liquefied time has relation with the amplitude of acceleration, b ) when the intensity is on and above eight degree, the silty soil deposit will be liquefied dramatically, c ) the relationship of the pore water pressure is relevant to the cycle loading which represents when the cycle loading ranges from little to great, the relationship is represent as a concave curve, or else as a protruding curve and tends to stability. ( 3 ) based on the triaxial compression test and the resonant column test, some studies are made such as a ) the duncan - chang parameters of constitutive model, b ) the dynamic shear modulus ratio and c ) the damping ratio of the site soil deposits. in order to deal with the test data, a computer program is compiled

    （ 2 ）利用小型振動臺進行了k _ 0固結狀態下粉土的振動液化模擬研究，通過分析正弦荷載作用下的試驗資料，驗證了粉土的孔隙水壓力增長模式的合理性；從微分方程推導了基於土體振動臺模型試驗的相似律，並從模型實體、孔壓時程曲線和相似律等方面做出了分析，得出了如下結論：在小型振動臺試驗中，模型箱中的粉土都發生了液化，液化的時刻和輸入加速度幅值有關，而對頻率的變化不太敏感；粉土在相當於8 9度地震烈度的加速度幅值作用下可能產生嚴重的液化；孔壓的增長曲線形狀與施加的荷載有關：當施加荷載為由小到大的形式時，曲線形狀為上凹的曲線；當施加荷載為等幅的正弦荷載或荷載幅值由大到小時，曲線形狀為上凸的曲線，且逐漸趨于穩定。
  11. Loads are commonly applied with universal testing machines, hydraulic cylinders dead weights, or some form of pressure.

    通常是用萬能試驗機、液壓缸重物或某種形式的壓力施加載荷。
  12. The external forces include reactions ( r ) as well as applied loads ( p )

    外力包括反力r和施加力荷載p 。
  13. In the test, static - dynamic method is used to measure the stiffness, the eight stiffness coefficients of the radial part and the two stiffness coefficients of the thrust part can be obtained though loading slowly to the testing bearing which is in a equilibrium position

    首先，對處于平衡位置的測試軸承分別沿水平方向、鉛垂方向及軸向緩慢施加載荷，根據靜動法原理求得各個轉速下測試軸承徑向部分內、外膜8個剛度系數以及推力部分內、外膜2個剛度系數。
  14. This paper introduces the preloading model set technological in heating furnace, preloading model set technological can increase the quality of heating furnace and the life of furnace lining highly

    摘要在加熱爐中採用預加載荷支模工藝，能提高加熱爐施工質量，大大提高爐襯壽命。
  15. Loading for buildings - code of practice for dead and imposed loads

    建築物負載設計.固定負載和施加載荷實用規程
  16. Then the initial stress was calculated with proper load and the assembly process simulation

    模擬裝配夾緊過程施加載荷約束，並計算該過程中鋼板彈簧內部產生的預應力。
  17. This makes it possible to know the load by studying the pbg property or to change the pbg property by loading

    這樣，就可以通過測量光子晶體的光帶隙性能來判斷壓力的大小，也可以通過施加載荷來調制透射光的波長。
  18. These methods are following : ( 1 ) in order to build fem model conveniently and enhance calculating speed, interceped a finite length and built a 2d - symmetry model. ( 2 ) in order to apply loads conveniently, kept the entrance of cold fluid. ( 3 ) in order to obtain numerical results in steady situation, lengthened export and import ends

    這些方法主要有： （ 1 ）為了便於建立模型並提高計算速度，對于實際工程中採用的長徑比特別大的換熱管採取截取有限長度的方法並建立二維對稱簡化模型； （ 2 ）提出採取保留冷流體入口端，截取有限長度的方法施加載荷； （ 3 ）適當延長翅片管的出口端和入口端，以便獲得穩定工況的數值解。
  19. Theoretical research on the type and mainframe tripled frequency converter : on the basis of building finite element models, dividing grid, application of load in the software of ansys, the dynamic and static performances are calculated, the value of the deformation, the first natural frequency and corresponding mode of the frequency converter are obtained, finally, the dynamic performances of the frequency converter are analyzed

    對型三倍頻組件和主機三倍頻組件的理論研究:採用通用ansys軟體對組件進行合理建模，劃分網格，施加載荷，在此基礎上對它們進行了靜態分析和動態分析，得到最大變形量、低階固有頻率和相應的振型，並對組件的動態性能進行了分析。
  20. According to the loading characteristics of bonded post - tensioned prestressed concrete frames, a program is worked out to perform a nonlinear finite element analysis for the static staff in both the stretching wire stage and the loading stage

    摘要根據后張有粘結預應力混凝土框架結構的受力特點，編制了適用於預應力建立和施加外荷載兩個階段的靜力桿件非線性有限元分析程序。
分享友人
分享到 Line

分享到臉書