旋翼軸 的英文怎麼說

中文拼音 [xuányìzhóu]
旋翼軸 英文
main rotor shaft
  • 旋 : 旋Ⅰ動詞1 （旋轉） whirl 2 （用車床切削或用刀子轉著圈地削） turn sth on a lathe; lathe; pare Ⅱ名詞...
  • 翼 : Ⅰ名詞1 （翅膀） the wing of a bird 2 （像翅膀的東西） the wing of an aeroplane etc : 鼻翼 wing of...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 旋翼 : helicopter rotor
  1. In 1945 c. j. ghu turned his attention to rotorcraft and designed a co - axial helicopter, known as the humming bird model a

    1945年，朱家仁先生製造了一架共軸雙旋翼直升機，即蜂鳥一號。
  2. On the basis of axial vortex theory, the aerodynamic performance of tilt - rotor model has been built, and using it to analyze the aerodynamic performance of xv - 15, comparing to the actual data to prove the model ’ s validity, finally studied the variety of aerodynamic performance relative to the variable rotor diameter

    以軸向渦流理論為基礎，建立了適合於傾轉旋翼機氣動分析模型，以xv - 15傾轉旋翼機作為算例，通過結果的對比，表明本文的氣動模型能較好的分析傾轉旋翼機的氣動性能，並在氣動性能的基礎上分析了直徑變化對傾轉旋翼機氣動性能的影響。
  3. The dynamo runs at rull speed to drive main shaft, then the main shaft makes the emulsifying wings in emulsification grove rotate, which absorbs the liquid in its brand groove into ring groove through guide vanes on upper and lower sides of the groove. the vanes spins circularly at high speed with the main shatf as center, and the blade and emulsificaton groove cut and crush it continuously. after that. it gers squeezed by the vanes highspeed centrifugal rotation. at last, it finishes isotropt emulsification tratment within extremely short time after continuous circulating mixing

    由電動機全速運轉帶動主軸，經主軸轉動乳化框槽內之乳化翼片，使其將桶槽內之液體經框槽上、下兩側之導流葉片吸入環狀框槽內，經以主軸為中心高速圓周旋轉葉片；連續使乳化翼端刀面與乳化框間極小之間系高頻率之強力切割剪斷、粉碎，再借葉片高速離心旋轉排擠，持續循環混合，以極短之時間即可完成均質乳化之處理。
  4. The design of configuration and other primary structures of the helicopter have been finished. in order to analysis the stability and control of the helicopter, a flight mechanical modeling has been founded based on a single - rotor helicopter

    本文以常規單旋翼帶尾槳的直升機配平和操穩計算方法為基礎，建立了帶涵道共軸式直升機飛行動力學模型，對碟形無人直升機進行了配平和操縱性和穩定性分析計算。
  5. Then a real - time quasi - steady turboshaft twin - engined model is founded by simulating the rotor speed fluctuation

    為模擬大負載情況下旋翼轉速的波動，建立了雙發準定常渦輪軸發動機實時模擬模型。
  6. During the design of new type attack helicopter, we need to assembly the engine, the gear box, the driving shaft and the rotor system together on the ground, so that we can use it to test its performance and try whether they work in harmony

    在某新型武裝直升機的研製過程中，需要把發動機、減速器、傳動軸和旋翼系統在地面進行裝配，做地面試驗，以檢驗各子系統的性能和相互間的協調性。
  7. A technology for designing a dishing axial - symmetric unmanned helicopter that based on a coaxial rotor system shrouded by a toroidal shell is studied in this thesis

    本文研究碟形軸對稱無人直升機的總體設計技術，這種特型的無人直升機是將一副共軸式旋翼置於涵道中，外形為碟狀。
分享友人
分享到 Line

分享到臉書