時效合金 的英文怎麼說

中文拼音 [shíxiàogějīn]
時效合金 英文
ageing alloy
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 時效 : 1 （在一定時間內能起的作用）effectiveness for a given period of time2 [法律] prescription3 [冶金...
  1. In this paper, 6013al / sicp / gr metal matrix composite ( mmc ) was produced by spray codeposition, by means of changing the medium of quenching, influence of five types of heat treatment system ( furnace cooling, air cooling, water quenching, dry ice quenching, liquid nitrogen quenching ) and different aging temperature on the damping was studied systematically

    本文採用噴射共沉積方法制備了6013al sicp gr金屬基復合材料（ mmc ） ，通過改變淬火介質，較為系統地研究了五種熱處理制度（爐冷、空冷、水冷、乾冰冷及液氮冷）以及不同時效溫度（ 120 、 150 、 170 、 190及210 ）對6013al sicp grmmc阻尼性能影響。
  2. Standard specification for pressure vessel plates, low - carbon age - hardening nickel - copper - chromium - molybdenum - columbium and nickel - copper - manganese - molybdenum - columbium alloy steel

    壓力容器用低碳時效硬化的鎳銅鉻鉬鈮和鎳銅錳鉬鈮合金鋼板的標準規范
  3. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  4. Review on the intergranular corrosion and exfoliation corrosion of aluminum alloys

    幾種時效工藝下1420鋁鋰合金性能研究
  5. Ha possesses well biocompatibility, which has been discovered through test and in clinical application. however, the relatively large dissolution or resorption rates of ha will result in the failure of the implants. fluoridated hydroxyapatite ( hfa ) in whose structure f " occupies partially the position of oh " in ha, is expected to be more resistant to body fluid and less soluble than ha and still possess almost the same bioactivity as ha

    生物活性羥基磷灰石薄膜（ ca _ （ 10 ） （ po _ 4 ） _ 6 （ oh ） _ 2 ， ha ）廣泛地應用於鈦合金硬組織種植體表面改性，臨床應用發現ha薄膜具有很好的生物相容性，但是ha薄膜在體內溶解速度有時可能會過快，引起種植體在體內失效，因此， ha薄膜長效性方面有待于提高。
  6. Evolution of intermetallic compounds in snag and snagcu lead - free solder joints during aging

    無鉛焊料接頭中金屬間化合物在時效中的演變
  7. The negative photoconductivity effect was found in the dimixing phthalocyanine composites. the experiment results indicated that the negative photoconductivity effects were closely related with the partial charge transfer from the center metals to phthalocyanine rings, and the separation efficiency of photocarriers was a key factor to the photoconductivity

    結果表明，共混復合后，其光電導性能表現出負效應，並發現酞菁中心金屬與其相連的氮原子之間的部分電荷轉移是引起復合體系光電導性能變化的根本原因，同時復合體系中的電子空穴對的分離效率是影響光電性能的一個重要因素。
  8. Effect of ageing and retrogression treatments on mechanical and corrosion properties of 7075 aluminum alloy

    時效和回歸處理對7075鋁合金力學及腐蝕性能的影響
  9. Effect of retrogression and reaging treatment on stress corrosion c racking resistance of super - high strength aluminum alloy

    雙級時效對1420合金模鍛材料組織和性能的影響
  10. The lcf behavior of a recrystallized zircaloy - 4 plate at room temperature and 400 show that alloy has better lcf property at rt than at 400, and cyclic hardening at 400 which could be attributed to the dynamic strain aging effects. it is noticeable that the hydrided plate has the same cyclic behavior as the above unhydrided sample at room temperature

    在400下，合金錶現出與常溫下不同的循環特性，其循環穩定滯后回線出現鋸齒狀波形，且在整個疲勞過摘要程中呈現出一致循環硬化的現象，這主要是因為合金在400下發生動態應變時效效應的結果。
  11. Aged alloy powder

    時效合金粉末
  12. Influences of electric field applying during solution process on mechanical properties, fracture characters and precipitates in aged alloys are studied

    研究了固溶過程中施加的電場對合金時效后的性能、斷裂特徵和析出相的影響。
  13. It is found that the electric, field improves elongations in 2090 and 2090 + ce alloys markedly, especially in 2090 alloy, but has little effect on strengths. at the same time, the electric field lessenes percentages of intergranular delamination and increases transgranular fracture and microscopic plastic deformation. besides, the electric field makes both average particle size and its distributing range of 8 " phase smaller, and reduces the half width of pfz in aged alloys

    研究表明：固溶電場可顯著提高2090合金及2090 + ce合金的延伸率，尤其是對2090合金，但對強度則無明顯的影響；同時，固溶電場減少合金的沿晶分層斷裂比例，並增加穿晶斷裂及微區塑性變形；固溶電場還使合金時效后相顆粒的平均尺寸減小、尺寸分佈范圍減小，並使pfz的寬度減小。
  14. Study on aging effect and mechanism of cu - 11. 1al - 6. 5mn - 1. 6zn - 0. 1zr shape memory alloy

    形狀記憶合金的母相時效效應及其機理研究
  15. Analysis on the factors which work on the ageing effect of board aluminum alloy parts solidifacation

    影響板類鋁合金零件固熔時效效果的因素分析
  16. Effect of be on ageing hardening behavior and oriented relation between precipitated phases and matrix of 7475 aluminum alloy

    低中高溫再多級時效處理對7175鋁合金組織和性能的影響
  17. The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied, and on the basis of this study, composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol. % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology. pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads

    本文研究了鑄態cu20ni20mn和cu20ni35mn合金的時效硬化特性及其與鑄造碳化鎢的界面特性，並在此基礎上以不同尺寸（ 42 362 m ）的鑄造碳化鎢顆粒為增強體，採用真空熱壓液相燒結技術制備了不同顆粒含量（ 0 45vol . ）的鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料；以不同粒度的sic為磨料，在不同載荷條件下利用銷?盤磨損試驗機測試了復合材料的二體磨料磨損性能。
  18. The time taken to reach maximum hardness decreased and the corresponding maximum hardness decreased with increasing aging temperature. the better properties of al - mg - si - mn - cr alloy were obtained after 8h at 175 ' c. the al - mg - si - mn - cr alloy resembles al - mg - si alloy in the way of the age hardening mechanism

    在同一溫度下，隨著時效時間的延長，合金硬度逐漸上升，在達到時效硬度峰值后又逐漸降低，隨著時效溫度的升高，中南大學碩士學位論文川mg st mn cr合金組織與性能的研究合金達到時效硬度峰值的時間縮短，而相應的時效硬度峰值在減小。
  19. 5. the comprehensive capacities of the azsm alloy were markedly promoted than that of the as - cast azsm alloy which was aged at 200 ?, air - cooled and furnace - cooled after solid - solution, aged at 90 ? and aged in nature after solid - solution

    5 ）鑄態azsm合金經200時效3小時、固溶4小時后空冷和爐冷、 400固溶-水淬90時效和自然時效的綜合性能較鑄態有顯著的提高。
  20. The electric field strengthens the laminate boundary of 2090 alloy. the laminate strengthening mechanism translates into boundary strengthening and grain inner toughening with more ductility fracture and less intergranular fracture. the ductility property is enhanced with no change of intensity

    對鋁理合金sem實驗發現，電場固溶和時效強化了晶界，和晶內塑性的改善，斷裂特徵出現由分層沿晶斷裂向塑性斷裂轉變，斷麵塑性變形特徵增加。
分享友人
分享到 Line

分享到臉書