時間掃描 的英文怎麼說

中文拼音 [shíjiānsǎomiáo]
時間掃描 英文
time scan
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 掃 : 掃構詞成分。
  • 描 : 動詞1. （照底樣畫） copy; depict; trace 2. （在原來顏色淡或需改正之處重復塗抹） retouch; touch up
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. In this thesis, the oxygen sensitive materials and glucose sensitive materials had been developed by thermo - polymerization method including carrier covalence method and carrier covalence - cross linking method, and the properties had been investigated using the detection experiment of oxygen and spectrophotometer, at the mean time, the applications of oxygen sensitive materials in fiber optical gaseous oxygen sensor and fiber optical dis solved oxygen sensor, and that of biology sensitive materials in fiber optical dextrose sensor had been studied in this paper. major content of this work includes five aspects as follows : ( 1 ). oxygen sensitive materials had been prepared by carrier covalence method, and the preparation mechanism of the materials had been investigated by fi - ir, sem, and the detection experiment of oxygen

    本論文主要包括以下五個方面的內容： （ 1 ）載體共價法制備氧敏感材料：通過紅外光譜、掃描電鏡圖譜和氧測試實驗探討該氧敏感材料的制備機理，通過氧測試實驗評價該氧敏感材料的氧敏感性和穩定性，同時研究了各種因素對該氧敏感材料性能的影響（ 2 ）載體共價?交聯法制備氧敏感材料：通過紅外光譜、掃描電鏡圖譜和氧測試實驗探討該氧敏感材料的制備機理，通過氧測試實驗和分光光度計評價該氧敏感材料的氧敏感性和穩定性，同時研究了各種因素對該氧敏感材料性能的影響（ 3 ）氧敏感材料在光纖氣態氧傳感器中的應用：該傳感器的響應時間為10s ，檢測下限為5ppm ，檢測精度為0 . 5 ，具有較好的重復性和穩定性，遲滯較小，使用壽命至少為1年，適合各種環境下氣態氧濃度的檢測。
  2. The simulation results suggest that, at the end of the scanning line, the dissymmetric temperature field and the great temperature gradient result in the balling phenomenon and great thermal stress, which could lead to the destruction of the sintering samples in this region. because of the coupling effect between scanning lines, the balling phenomenon is increased as the increase of the scanning lines, thus the over short scanning lines should be avoided in the sintering process. different scanning strategies have significant influence on the sintering

    模擬結果表明，掃描端點溫度場的不對稱及較大的溫度梯度造成了端點球化現象，並在端點處產生較大的熱應力，使燒結成形試樣易在此處破壞;激光掃描線間的耦合作用使端點球化現象隨掃描線的增加而逐漸顯著，燒結時應避免過短的掃描線;不同掃描策略對燒結成形有很大影響，交替掃描會影響燒結試樣的質量，實際製造時應採用單向掃描策略。
  3. The scanning of the film by the photometer in the spacial domain is equivalent to the operation of a filter on a signal flowing through it in the time domain.

    在空間域用光度計進行掃描，和時間域中濾波器對所通過的信號進行運算等效。
  4. Calculated the open pore rate, porosity and average leaching time. photomicrograph of representative porous microstructure of matrix were taken by scanning electron microscope ( sem )

    計算平均開孔率、空隙率、氯化鈉瀝清時間，並進行支架表面與內部孔徑和空隙開放情況的掃描電鏡觀察。
  5. The mathematical model by which the forming time can be precisely calculated is ratiocinated. this model shows that in sls the scanning " delay " phenomenon can make the actual forming time greatly exceed the theoretical time, and the total number, total length of the scanning lines and the scanning speed have different effects on the scanning " delay "

    本文推導出了sls成型時間精確計算的數學模型，該模型顯示在sls加工中的掃描「延時」現象會造成實際成型時間遠遠大於理論時間，並且掃描線條數、掃描線總長和掃描速度對掃描「延時」有不同程度的影響。
  6. The disadvantage of repetitive sweeps is that they take a long time.

    重復掃描的缺點在於需要較長的時間。
  7. Scan disk will take sometime ; best go do something else for few hours after the scan started. it could taker longer if its larger hard drive

    掃描磁盤需要一些時間；在掃描啟動后的幾個小時里最好做其它事情。更大的硬盤可能花費更長的時間。
  8. This avoid high cost by using post - pruning measure which require many times for scanning disk data and amount of cpu time. so we gain a high efficiency

    這避免了后剪枝策略所需的高昂代價，減少了掃描磁盤數據的次數和大量的cpu時間，進一步提高了演算法的效率。
  9. By analyzing the microstructure of as - cast alloys with different surplus of samarium added, the optimum surplus of samarium is decided. by comparing the microstructure of the alloys annealed for different time, the ideal and economical annealing time is confirmed. the microstructure and phase composition of alloys during the whole preparation of sm2fe17nx are analyzed using the scanning electron micrograph with energy - dispersive x - ray analysis and x - ray diffraction patterns

    本論文首先就熔煉工藝參數對鑄態組織微結構的影響進行了探討，並制定出一套較為合適的熔煉工藝；通過對不同釤加入量的鑄態組織微觀結構的觀察分析，確定了原料配置過程中釤的最佳補償量；通過對採用不同退火時間的合金組織進行比較，確定了理想、經濟的退火時間；同時還利用掃描電子顯微圖像和x射線衍射圖譜，比較了整個制備過程中，試樣微結構和相組成的變化情況。
  10. The dependence of oxygen precipitation and induced - defects in heavily as - doped silicon on heat treatment process was studied by annealing and ig process, chemical etching, scanning electron micrograph ( sem ) and transmission electron microscopy ( tem ). a developed ig technique was suggested and the mechanism of the influence of as on oxygen precipitation formation in heavily as - doped silicon was discussed

    本文通過化學腐蝕、光學顯微鏡、掃描電鏡（ sem ） 、透射電境（ tem ）等分析技術，對重摻砷硅單晶在單步退火工藝和內吸雜退火工藝中氧沉澱及誘生缺陷的形態，形核與熱處理溫度、時間的關系等進行了研究。
  11. The primary theory of absorption and desorption was also explained. the effects of primary process parameters, such as hydrogen pressure, time and temperature on the magnetic properties of ndfeb have been researched. the structure and magnetic properties have been analyzed by means of optical metallographic microscopy, scanning electronic microscopy, x - ray diffraction analysis, infrared oxygen detector and magnetic properties measurement

    本文設計了燒結ndfeb的氫爆制粉設備，對設備調試以及使用過程中出現的主要問題進行了簡要的說明，提出了一系列解決方法；闡述了吸氫、脫氫的基本原理；研究了氫氣壓力、通氫時間、氫爆溫度等基本工藝參數對磁性能的影響；利用金相顯微鏡和掃描電子顯微鏡， x射線衍射分析，紅外線測氧分析及綜合磁性測量儀等手段分析了材料的組織結構和磁性能。
  12. 3. passive and active time - domain demodulation schemes were demonstrated based on a fiber bragg grating used as a tunable filter controlled by a piezoelectric stack, which was driven by an electrical sine wave signal. the measured strain applied on the sensor axially could be judged by observing the interval of the output between notches within a driving period in time - domain

    利用匹配濾波技術，分別採用無源和有源方式，藉助受pzt驅動的解調光柵，將待測應變信息變為時序負脈沖間隔的變化，利用常規的示波器觀測同一掃描周期中兩負脈沖在時域中間隔的變化來確定待測應變的變化。
  13. Can take a few minutes to complete, as it scans the partition for bad blocks

    格式化交換分區，可能要花一些時間來完成，因為它可能要掃描壞區。
  14. Simply insert a business card in the scanner, store the card image and convert the card into text data. in one click export the information to your personal contact database and instantly update your contacts into microsoft outlook, palm, lotus notes, act !,

    具備頂尖ocr文字辨識引擎，支援twain規格掃描，可瞬間辨識儲存數位化資料，並可匯入至個人數位助理筆記型電腦，輕松省下重復輸入名片的大量時間。
  15. The laser unit, because of its monochromaticity and small divergency, is used as sensor ’ s light source. devices and chips provided with high - speed responsing and processing capabilities are employed. as a result, the achieved uncertainty of time measuring is 125 ps, demonstrating an accuracy improvement in magnitude of an order

    在設計製作中採用了單色性和方向性好的激光作為光源，選取了高速響應和有高速處理能力的一系列器件、晶元，因此時間測量的精度達到了125ps ，比以往的測試方法提高了1個數量級以上，速度測量精度達到掃描速度的0 . 1 % 。
  16. On the base of above it, this paper discuss the synthesis of optimum distributed arrays by nonuniform spacing in the sense of dolph - chebyshev. having derived the equations of optimum element distribution, we analyze the exponentially spaced array, which are optimum when the elements are isotropic and equally weighted, and the array by general raised cosine function. the formulate for estimating the sidelobe envelope, beamwidth of the array pattern and clean region width are obtained

    推導了最佳陣元分佈方程，分別對陣元無方向性和等加權時的最佳分散式陣列? ?指數間隔陣列和採用廣義升餘弦加權的最佳分散式陣列進行了分析，推導了天線方向圖旁瓣包絡、波束寬度，干凈掃描區寬度的估計公式，給出了近軸旁瓣電平與陣列參數的關系。
  17. The project adopts pulsed laser ranging in noncoherent detect mode, uses a 905nm pulsed laser diode as the laser source, detects object with a single apd, adopts an optics - mechanics scanner in object space to obtain images, and obtain distance images and intensity images of object simultaneously

    該研究方案採用直接探測脈沖激光測距體制，以波長為905nm的脈沖半導體激光器作為激光光源，利用單元apd探測器進行探測，採用物空間掃描的光機掃描方式進行掃描成像，能同時獲得目標的距離圖像和強度圖像。
  18. There were three more products which all took significantly longer amounts of time, considering the amount of data scanned and length of time to scan

    有三個以上的產品都持著延長了大量的時間，考慮到數據量的掃描和時間掃描
  19. The serpentine feed is the core of a frequency scanning antenna feed system, which produce proper amplitude and phase distribution for the antenna arrays. most of all, it make the beam scanning over a large angle range by means of changing operating frequency

    它為天線陣提供要求的幅度、相位分佈，更為重要的是當頻率發生少許變化時使線源的等相位面產生顯著的傾斜，完成波束在空間掃描。
  20. Time - scanning fls indicated the process of denaturing by urea was faster than that of recovering its activity

    熒光時間掃描光譜表明cml的腺變性是一個相對較快的過程，而腺變性的復性則是一個相對緩慢的過程。
分享友人
分享到 Line

分享到臉書