時隙內容 的英文怎麼說
中文拼音 [shíxìnèiróng]
時隙內容
英文
time slot content-
It is composed of three mian protocols : call synchronization protocol, control frame transmission protocol based on arq mechanism and data transmisstion protocol based on slot precontract mechanism. one scan channel table is shared in the hfmanet. the nodes in the same dwell group work in the same scan channel, and the nodes in the different dwell group work in the different scan channel
該協議的網路拓撲結構採用分散式分群結構，協議不同於傳統的短波點到點及需要中心節點轉發的組網方式，而是初步實現了短波電臺之間多跳組網功能，其協議內容主要包括同步呼叫協議、基於arq的控制幀傳輸協議和基於虛電路及時隙預約方式的數據幀傳輸協議。Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively
本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed
本文對空芯動圈式直線同步電動機進行了深入細致的研究，內容包括： （ 1 ）採用電流模型推導出兩種計算永磁磁極二維氣隙磁場的解析公式（集中電流法、分佈電流法） ，同時介紹了兩種永磁電機氣隙磁場計算方法（磁荷法，直接求解拉氏方程法） ，分析各種方法的優缺點，討論電機參數對氣隙磁密的影響； （ 2 ）介紹了單層同心繞組的布置方式，根據安培定律推導出空芯動圈式直線永磁同步電動機的靜推力計算公式，分析靜態力?位移特性； （ 3 ）建立空芯動圈式直線永磁同步電動機動態模擬模型，模擬不同驅動方式下電動機起動、穩態運行時電磁力、速度、位移的變化情況。Main content in simulation is the spatio - temporal evolution of the set of descriptive variables characterizing tectonic mineralization state under coupling of various processes as following : ( 1 ) variables related to forming and property of ore - forming fluid, such as dissolution rate of minerals ( include metal minerals ) in rock, concentration and saturation of aqueous species in fluid, temperature, pressure, and ionic strength etc. ; ( 2 ) variables related to structural deformation and fluid flow, such as stress, deformation rate, fracture network, porosity, fracture permeability ; ( 3 ) variables related to precipitation and mineralization, such as nucleation rate of gangue and metal minerals, accumulation precipitation of various minerals, etc. ; ( 4 ) spatio - temporal coupling relation of various variables above, such as the coupling relationship between spatio - temporal evolution of fracture permeability and flow and focus of fluid and ore - forming
模擬的主要內容是在各種過程耦合作用下，以下描述構造成礦體系的主要變量的時空演化：與成礦流體的形成和性質有關的變量，如地層中礦物（包括成礦物質）的溶解速率、流體中各組分的濃度與飽和度、流體溫度、壓力、離子強度等；與構造變形和流體運移有關的各變量，如應力與變形速率、巖石孔隙度、構造（斷裂）滲透率等；與沉澱成礦有關的變量，如礦物（金屬礦物和脈石礦物）的成核速率、各礦物的沉澱量等；上述各有關變量間的時空耦合關系，如斷裂滲透率時空演化與流體流動、匯聚和成礦的耦合關系等。According to the experimental parameters of mpt, the main performance parameters of different propellants have been given by engineering performance computation under designed and working states, which has great importance for the experimental research and the future work. 2. for helium and argon, the factors which influence on mpt ' s vacuum steady work have been discussed such as the material of microwave tie - in, the distance between the probe and inner - conductor, the position of the inner - conductor, the input power of microwave, the mass flowrate of propellant and the vacuum pressure of environment, and the influence has been discussed of the microwave power and the mass flowrate of propellant on the pressure of the resonance cavity, thrust, reflected power and the temperature of the resonance cavity
論文的工作和新見解主要包括： 1在設計狀態和工作狀態下，根據mpt的實驗參數，對mpt使用不同工質時的性能進行了工程估算，這對mpt現階段的實驗研究和今後的研究有重要的指導意義； 2對于he 、 ar推進工質，討論微波的接頭材料、探針與內導體的間隙、內導體的位置、微波的輸入功率、工質的質量流量以及環境真空度對mpt真空啟動和穩定工作的影響，並探討微波的輸入功率、工質的質量流量對諧振腔壓強、推力、反射功率以及諧振腔溫度的影響； 3對于n _ 2 、 h _ 2 、 nh _ 3 、 h _ 2o推進工質，主要討論與he 、 ar工質不同的特性，並從長遠的眼光和工程應用的角度，認為其可行性不容置疑，潛在優勢不可忽略，是未來mpt應用的主流推進工質。Among them, the uncompetent pelitic series are cleaved in the srong - deformation zone with relatively high temperature, high pressure ; with weak hydrofracturing, the competent sodium - rich series dilatacying and forming microfracture ( ie, embryonic fracture ) in the core of the weak - deformation demain, which is a natural lens - like pumping centre with relatively low temperature, low pressure and high permeability
強變形帶中的非能幹性泥質巖系強烈劈理化，為相對高溫高壓帶；弱變形域內的能幹性鈉質巖系則伴隨弱水力壓裂作用發生擴容，形成雛形斷裂的微裂隙，同時，它是一個相對低溫、低壓、高滲透率的透鏡狀天然泵吸中心。The charging - discharging curves look like the letter " v " and have no flat plateaus due to the different sizes of the micropores. increasing the httmax, the micropores in ant samples become fewer and smaller, therefore the charging - discharging capacities decrease. when httmax = 2100, the charging - discharging capacity reaches the minimum since the number of the micropores reaches the minimum and the size of them become very small, the number of graphite crystallite in ant samples is still few and the size of them is also small
在htt _ （ max ） 2100的范圍內， ant試樣屬于亂層結構，石墨微晶尚未出現或數量很少，貯鋰機制為「孔隙貯鋰」 ，由於孔隙的大小不一，插鋰時克服阻力所需的電位也不同，因此充、放電曲線呈「 v 」字形，無平穩的充、放電電位平臺；隨著htt _ （ max ）的增大，試樣中孔隙逐漸變小、變少，充、放電容量也逐漸變小。The mostly content in this paper include the law of the influence upon the effective stress coefficient worked by the holes configuration which comprise the holes rate and the hole distributing, and the law of the influence upon the effective stress coefficient worked by the cracks configuration in rock which comprise the amount of cracks and the cracks distributing. by numerical value experiment, the variety laws of the effective stress coefficient worked by the cracks distributing, by the fractal dimension and the initial value have been work out. by referring to the formerly physical experiment datum and conclusion, the thesis has studied the influence upon the effective stress coefficient worked by the outside pressure and the liquid press inside rock and sum - up the variety law of the effective stress coefficient with the outside pressure and the liquid press
本文的主要內容包括：巖體孔隙裂隙結構對有效應力系數的影響規律，即：一是孔隙率大小及分佈形態對有效應力系數的影響規律，二是裂隙的條數和分佈形態對有效應力系數的影響規律，並得出了裂隙的分形參數，即：分形維數和裂隙初值的變化對有效應力系數的影響的相關規律，同時也搞清了裂隙分佈形態對有效應力系數的影響規律；參照已有的物理試驗結果，分別研究了巖石所受的圍壓和孔隙流體壓力的變化對有效應力系數造成的影響，從細觀的角度揭示了有效應力系數隨二者的變化規律。分享友人