晶界滑動 的英文怎麼說

中文拼音 [jīngjièdòng]
晶界滑動 英文
grain boundary slide
  • : Ⅰ形容詞(光亮) brilliant; glittering Ⅱ名詞1. (水晶) quartz; (rock) crystal 2. (晶體) any crystalline substance
  • : 名詞1 (相交的地方; 劃分的界限) boundary 2 (一定的范圍) scope; extent 3 (按職業、工作或性別等...
  • : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
  • 滑動 : slither; slippage; slipping; slide; sliding; run; sliding movement [motion]; glide; slump滑動閘門...
  1. But when heavyly loaded, the former is far better than the latter. the wear resistance of za27 alloyed with mn is no obviously better than that of common za27 alloy. under the sliding friction conditions, the wear resistance at high temperature of za27 is improved by alloyed si and reaches the highest level when the content of si is 1 - 3wt. %

    裂紋主要始於脆性相si相和mn相,裂紋沿擴展;在摩擦條件下(常溫) ,含si的za27合金在載重較小時,耐磨性與普通za合金相比沒有明顯提高,但在載荷較大的情況下,其耐磨性遠高於普通za27合金材料;加mn的za27合金與常規za27合金相比,耐磨性沒有明顯提高;在摩擦條件下, si的加入提高了za27合金的高溫摩擦性能。
  2. From an examination of the tensile behavior of cz ly12 alloys under different temperature and strain rate, two kinds of deformation and intergranular fracture behaviors were observed that were opposite to the characteristic strain rate range in fine - grained superplasticity. the mechanisms are described as follows. the high ductility achieved at high strain rate is generally attributed to the dominant role of gbs accommodating mechanisms, which is considered as dislocation creep within grains controlled by subgrains

    研究選用自然時效淬火態的ly12鋁合金,進行了一系列不同溫度和應變速率下的單軸拉伸試驗, 480下,觀察到與傳統細超塑性特徵區間相反的行為:較高應變速率下,態再結使粒細化,促進了移,亞控制的內位錯蠕變是移的主要協調機制。
  3. The microprocesses of deformation and fracture in 18 - 8 stainless steel were observed by in - situ tension in tem. it was found that the dislocations were emitted from the grainboundary and dislocation source inside a grain and slip along their slip system respectively. partial dislocation could also be emitted from the grainboundary, and moved into the grain, and that leaving behind a stacking fault

    摘要浙江人學博1 :學位論文採用透射電鏡態拉伸、原位觀察icrlsnigti不銹鋼形變與斷裂過程,發現不銹鋼變形時,內位錯源均可產生位錯,並沿各自的移系運
  4. The fiction coefficients of the five sliding pairs in different media were in the succession of, respectively. in distilled water : ual2o3 > ual2o3 / al2o3 > ual2o3 / al24zys > ual2o3 / al24zy > usic / sic in 1mol / l naoh : in air at 50 % relative humidity : and the friction coefficients of the sliding pairs a12o3 / a12o3, a12o3 / zta, a12o3 / a124zy and a12o3 / a124zys were in the order of u

    當載荷為60n ,頻率為10hz時,經過400om距離后,在水中a12o3 / a1203 , a1203億ta , a12o3 / a124zy和a12o3 / a124zys摩擦副均不能形成有效的潤膜,屬邊過程,磨損表面產生了裂紋,發生了粒拔出。
分享友人