晶粒取向 的英文怎麼說
中文拼音 [jīnglìqǔxiàng]
晶粒取向
英文
grain orientation-
It was concluded that, the structure of ito thin films were influenced by many working parameters such as substrate temperature, oxygenous pressure and substrate and so on. it was indicated by sem spectra of zno thin films that the surface of the sample was leveled off, and the crystals were felsitic
結果表明，對于ito薄膜，薄膜的光電性能薄膜結構的擇優取向性和與襯底溫度、濺射氧氣壓等工藝參數有很大關系， ito薄膜的sem表明，樣品表面較平整，且晶粒也比較緻密。The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of
對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。Standard specification for flat - rolled, grain - oriented, silicon - iron, electrical steel, fully processed types
全處理型平軋的晶粒取向的硅鐵電工鋼用標準規范The zn / o ratio, c - axis orented and stress were improved by annealing, and also redusing the defect of zno flim, increasing the size of grain. but too high annealing temperature was adverse to recrystallization of zno thin film
退火能改善zno薄膜的鋅氧比、 c軸的擇優取向和應力狀態，減少薄膜中的缺陷，使晶粒長大，但是過高的退火溫度不利於zno薄膜的重結晶，使zno薄膜的質量變差。Presents the microstructure evolution in aluminum a nd copper after deformation by cold rolling in the strain range of 10 to 50 % red uction using tem and points out three types of dislocation structures are typica l and two of them are common for both materials and these two common types are f ound in non - cube grains and can be distinguished by crystallographic orientatio n of dislocation boundaries in the grains and the third type of structure is obs erved in cube grains, and concludes that grain orientation is important in deter mining the structure type but some other metallurgical parameters also have a ro le to play
採用tem對冷軋多晶銅與多晶鋁的形變顯微組織演變進行了對比研究.結果發現：多晶銅及多晶鋁形變顯微組織中均含有三類典型的位錯結構類型，其中的兩種結構特徵在兩種材料中是相似的，這兩種類型結構存在於非立方取向晶粒，可通過晶粒中位錯邊界的晶體學取向加以區別，另一類型結構存在於立方取向晶粒；晶粒的晶體學取向決定了其形變顯微組織類型，但其它冶金學因素對顯微組織也有影響We have found the best ways to optimize the growth of quality zno films and got highly c - axis oriented zno films. the microstructures of the films were observed by afm. after analyzing the crystal structures, the crystal tropism and the surface conformation flatness, we found the result that the substrate temperature of 400 ? is ideal for silicon substrates, which conforms to the result of the structure analyse. by analyzing the magnetism of zno films, we found that the films appropriately doped with fe, co ions have magnetism at room temperature and their magnetism can be improved by doping other little cu ion, but it is not certain that the content of cu is higher, the film has more magnetism, so it has the best content of cu. moreover, the films which have best crystal structures may not have the best magnetism
我們採用原子力顯微鏡（ afm ）方法觀察薄膜的顯微結構，利用所得的圖象信息對薄膜的晶粒結構、晶粒取向、表面形態平整度等進行分析討論，認為400的襯底溫度對硅襯底薄膜是合適的，與結構分析的結果一致。通過對薄膜磁性能的分析和研究，我們得出一些有意義的結果：適量過渡金屬離子fe 、 co摻雜的zno薄膜，在室溫下具有鐵磁性，而在此基礎上摻入少量的cu離子能改善薄膜的磁性。摻cu量有個最佳值，而且結構最好的薄膜磁性不一定最好。Effect of nitriding on grain oriented silicon steel bearing aluminum
滲氮對含鋁晶粒取向硅鋼的影響International standard grain - oriented electrical steel silicon steel sheet for electrical use
晶粒取向電器用硅鋼片主要工業標準The results indicate that : ( 1 ) as the drawing ratio increase, the mechanical properties, crystallinity and orientation of uhmwpe fiber all increase greatly, while the average crystal size decreases
結果表明:隨拉伸的進行， uhm筋胭e纖維的力學性能、結晶度、取向度均大大提高，而晶粒尺寸逐漸變小。R amp; d of preferred oriented ferroelectric thin film prepared by sol - gel method
凝膠法制備晶粒擇優取向鐵電薄膜的研究The gel c - s - h has the trend to crystallizing and transforming into low crystallized hydrates, which were similar to tobermorite. the incorporation of mineral mixtures improves greatly the orientation of ch either in interface zone or matrix zone and the crystal sizes also become small
由於礦物摻合料的晶核作用、填充密實和二次水化作用，明顯改善了界面過渡區和基體中ch的擇優取向，並且不論是在界面區還是基體中，結晶相的晶粒尺寸都發生了明顯的細化。The metastable austenitic phase of s s fiber at the interface of the fiber / cu composite would turn back to equilibrium with the interfacial energy and inter stain inducing, when the cu films were separated from s s fiber. so the magnetism value of the s s fiber declined. the information of grain - orientation at the interface of the fiber / cu composite can serve as a mechanism responsible for its declining coercivity, and a part of cu elements diffused into s s fibers
不銹鋼纖維銅復合體去除銅層后，原有的界面能及應力下降，使得原纖維界面處弱磁性的部分亞穩奧氏體，恢復到平衡態，它們對樣品s測試結果不再有貢獻；不銹鋼纖維銅復合體中，處于界面處的纖維晶粒具有很強的軸向取向排列，當晶粒取向性減弱，磁疇轉動的阻力增加，磁體的矯頑力上升。Tem was used to consecutively investigate the size and appearance of dibasic lead phosphite in the reaction process. it found that nanocrystal grain of lead oxide phosphite hydrate had favorite direction in the mlps method, many nanocrystal grain in near area would aggregate and assembled as nanowire, the diameter of the nanowire was about a crystal grain size and the length of nanowire could reach hundreds of nanometers, then they would gather to needle or bar like particles
利用tem對二鹽基亞磷酸鉛在反應過程中粒子的大小、形貌進行跟蹤觀察，並記錄下三個時間下的微粒照片，發現用微液相合成法制備的二鹽基亞磷酸鉛晶粒在生長團聚時存在取向規律，同一區域的晶粒會長成一條納米線，直徑有一個晶粒的大小，長度可以達到幾百nm 。The effect of deposited condition, include substrate temperatures, different substrates and annealing on the structural properties of zno films has been studied in considerable detail. it is found that the optimal conditions to deposit zno are below : the substrate temperature of 450c, the substrate of sapphire. the sample on this condition is 0. 3491
通過分析襯底溫度、不同襯底和退火對樣品結構的影響，得到了樣品的最佳制備條件：襯底溫度450 、藍寶石襯底，此條件下制備的樣品具有高度（ 002 ）取向性， （ 002 ）衍射峰半高寬僅僅0 . 3491 ，原子力顯微鏡（ afm ）分析表明zno薄膜具有密集堆積的均勻柱狀晶粒。Grain - oriented electrical steel sheet and strip delivered in the fully processed state
加工完畢出廠的晶粒取向的電工鋼片和鋼帶Grain - oriented steel
晶粒取向鋼Strip - wound cut cores of grain oriented silicon - iron alloy, used for electronic and telecommunication equipment
用於電子和電信設備的晶粒取向硅鐵合金帶繞切割磁芯Grain - oriented magnetic steel sheet and strip
晶粒取向磁鋼薄板和鋼帶Cold - rolled grain - oriented and non - oriented magnetic steel strip
冷軋晶粒取向無取向磁性鋼帶片The physical properties of cerarnics are ciosely related to their microstructure such as the grain scale, grain boundny, grain orientation, etc. it ' s helpful for the development
陶瓷的物理性能與其相應的微觀結構之間存在著密切的相互聯系，如晶粒尺度、晶界、晶粒取向等都對物理性能有影響。分享友人