晶粒尺寸 的英文怎麼說

中文拼音 [jīnglìchǐcùn]
晶粒尺寸 英文
chisize
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
  • 寸 : Ⅰ量詞（長度單位） cun a unit of length （=1/3 decimetre）Ⅱ形容詞（極短或極小） very little; very ...
  1. They impinge on the final structure, grain size and properties of this alloy.

    他們對最終組織、晶粒尺寸和合金性能都有較大的影響。
  2. The resistance of sample l # ( 44nm ) and sample 2 # ( 50nm ) rises rapidly from 25k and 45k respectively, and an inflexion appears at the temperature in the resistance - temperature curves. the same inflexion appears at 75k in the resistance - temperature curves

    晶粒尺寸為44nm和50nm的1 #和2 #樣品的電阻率分別在25k和45k附近開始隨溫度的升高快速增大，在曲線上出現拐點。
  3. Grain size effects of sno2 varistor induced by doping pb

    2壓敏電阻的晶粒尺寸效應
  4. The crystalline structure changes of pp induced by pan - milling were characterized by x - ray diffraction and raman spectroscopy. xrd analyses show that when pp was co - milled with uhmwpe, crystal transformation of pp occurred, its crystallinity and crystallite size decreased, whereas, only slight reduction of crystallinity and crystallite size were observed and no crystal transformation was found when pp was co - milled with wtr chips, and amorphization of pp was strongly enhanced by co - milling pp with iron

    採用x -射線衍射研究了聚丙烯碾磨粉碎過程微觀結構變化， uhmwpe存在下pp發生晶型轉變、結晶度降低和晶粒尺寸減小；彈性材料wtr抑制pp塑性變形，碾磨導致分子堆積有序區域膨脹，晶面間距增大，結晶度下降；剛性材料金屬鐵與pp產生強烈摩擦，加快晶粒細化，晶格破裂導致非晶化。
  5. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。
  6. It is shown from results that increasing carburizing time further in the normal technology can not obviously deep the carburizing layer, but can cause nonmartensite microstructure at the bottom of the gear and coarse grain across the gear, these will heavily decrease the fatigue life of the gear

    結果表明：在正常滲碳淬火工藝基礎上再延長滲碳淬火1小時，齒輪滲碳層深度變化不大，但其齒根局部表面處有非馬組織，且晶粒尺寸易產生異常長大現象，從而致使臺架疲勞壽命明顯下降。
  7. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc （惰性氣體蒸發凝聚原位溫壓法）制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅（冷軋紫銅、電解銅）在酸性硫酸銅溶液和中性含氯溶液中，在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法（ cv ）和電化學阻抗譜（ eis ）等方法。 x -射線衍射（ xrd ）的方法用來估算納米晶銅晶粒尺寸。
  8. In acid copper sulphate solution, the nc copper has a more negative corrosion potential which is decreasing with reducing the grain size and diffusion impedance was only found in the as - prepared and as - annealed at 180 ? nc copper due to the diffusion within the pores and channels on the surface. both the tafel plots and eis study demonstrated that the nc copper exhibits a higher corrosion current and lower polarization resistance than its mc couterpart

    在酸性硫酸銅溶液中，納米晶銅的腐蝕電位比微米晶銅要負，並且隨著晶粒尺寸的減小而降低。 eis研究表明，未退火的和180退火的納米樣品中發現了擴散阻抗，與表面孔洞和通道中的擴散有關。極化曲線外推法和電化學阻抗研究都表明納米晶銅的腐蝕電流比微米晶銅高，而極化電阻要低。
  9. The adding of nano - particles and antioxidant ca n ' t affect the crystalline morphology of uhmwpe, but with the adding of antioxidant, the crystallinity increases and the average crystal size decreases, while the adding of nano - particles, the crystallinity decreases and crystal size increases

    納米粒子和抗氧劑的添加對uhmwpe的結晶形態都沒有影響，但加入抗氧劑后uhmwpe的結晶度變大，晶粒尺寸變小，而納米粒子的加入使uhmwpe的結晶度變小，晶粒尺寸變大。
  10. Suitable polycrystalline znsxse1 - x film with zinc sulfide cubic structure and ( 111 ) preferred orientation that provided a good matching with the requirements of lclv were deposited on ito coated glass by mbe method. room temperature photo - responsivity measurements performed on these thin films show that

    相比于用zns和se為生長源制備的znsxsel x薄膜，採用zns和znse化合物為源材料的實驗方法制備出的薄膜性能更優良，其晶粒尺寸普遍增大，柱狀晶形更完整。
  11. It is investigated in the paper the correlation between the microstructure and the mechanical properties, that is, the effect of the content of free carbon, free silicon, pore and granule size on the bending strength of the material. under 1800, we obtain material with a density of 3. 12 g / cm3, bending strength of 522mpa. it is considered that the increase of the bending strength of the material obtained upon the traditional rbsc material by 50 % is mainly owing to a higher density and a lower porosity than the rbsc material

    研究了高溫燒結材料中游離si含量，晶粒尺寸以及游離c和氣孔對材料強度的影響，對比了所得材料與傳統rbsc材料的顯微結構和力學性能的差別，在高溫燒結下制備了密度為3 . 12g / cm ~ 3 ，強度為525mpa的材料，比傳統rbsc材料提高了50 ，材料中更低的氣孔率和更高的密度是強度提高的主要原因。
  12. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  13. The size effect in steel is attributed mainly to the grain size of the material.

    鋼內的尺寸效應主要認為是由於材料的晶粒尺寸造成的。
  14. Relation between size - uniformity of si nanoparticles and oscillating stabilization time of the mixed region during laser ablation

    激光燒蝕過程中密度交疊區振蕩穩定時間與晶粒尺寸均勻性的關系
  15. After testing thermal conductivity ( k ), electrical conductivity ( ) and see - beck coefficient ( a ), the results demonstrate that for cosb3 nano - materials, with decreasing in grains size lattice thermal conductivity falls, electrical conductivity decreases and seebeck coefficient increases. thermoelectric performance figure ( zt ) cosbs nano - compound with grains size of 200nm has reached 0. 43

    通過對一系列不同晶粒尺寸cosb _ 3化合物的熱導率、電導率和seebeck系數的測定，討論了晶粒尺寸大小對結構納米化對熱導率、電導率和seebeck系數的影響，結果表明：隨著cosb _ 3化合物晶粒尺寸的減小，晶格熱導率_ l顯著降低，從而導致cosb _ 3化合物的熱導率的降低；電導率也有一定的降低；以及seebeck系數顯著增加。
  16. Effective particle size of high grade pipeline steels

    高鋼級管線鋼的有效晶粒尺寸
  17. Grain size simulation of 45 steel forging during upsetting

    鋼鍛件熱鐓粗過程晶粒尺寸模擬
  18. Grain size effects of co, ta - doped sno2 varistor induced by doping sr

    2壓敏陶瓷的晶粒尺寸效應
  19. Evaluating apparent grain size and distribution of cemented tungsten carbides

    鎢硬質合金錶觀晶粒尺寸及其分佈的評定
  20. Numerical simulation of austenite grain size during hot deformation of q345 steel

    345鋼熱變形奧氏體晶粒尺寸的數值模擬
分享友人
分享到 Line

分享到臉書