曲柄轉軸 的英文怎麼說

中文拼音 [qūbǐngzhuǎnzhóu]
曲柄轉軸 英文
crank shaft
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 柄 : Ⅰ名詞1 （器物的把兒） handle 2 （植物的花、葉或果實跟莖或枝連接部分） stem 3 （言行上被人抓住的材...
  • 轉 : 轉構詞成分。
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  1. As the crankshaft rotates, the crankpin swings in a circle around the shaft.

    隨著曲軸的轉動，曲柄銷繞主軸作圓周擺動。
  2. The cap and rod have bearings which permit the crankpin to rotate freely within the rod.

    軸瓦蓋和連桿中有軸瓦，它允許連桿內的曲柄鎖自由地轉動。
  3. The load map and wearing maps of the crankshaft journals and crankpin are obtained under various operating conditions

    研究表明：氣缸壓力和轉速升高后，曲柄銷和主軸頸的磨損均呈現增加趨勢。
  4. It is composed of two components : level move and rotation. level move is realized by the co - operation of oil vat, handspike and synchronizer. rotation is realized by the brace and the triangle oriented axis

    平行移動是由液壓油缸推動，通過推動軸承傳到推桿、同步盤，並相互配合實現的；旋轉運動是由曲柄、三角架導向軸完成的。
  5. It is applied to sorts of locomotive engine, in course of revolving of crank and connecting rod mechanism, there are revolving of the crankshaft, swinging of the connecting rod and reciprocating motion, so its motion state is complex, and periodic unbalanced force, by a few components, is great

    曲柄連桿機構在高速運轉過程中，有曲軸的轉動、連桿的擺動及活塞的往復運動，其運動狀態復雜，各個部件所產生的周期性不平衡慣性力大，是引起發動機振動的主要原因。
  6. The sampling rate of the system can reach 3704 sps, and the crank angle is 1. 94 degree per sampling point corresponding to the crank speed of 1200r / min. in the mean time, the position signal of the piston could be collected by photo - electricity switch

    本研究首先設計和實現了摩擦力採集電子電路系統，裝置最大采樣率可達到3704sps ，在曲軸轉速為1200r / min時，對應曲柄轉角1 . 94度采樣點，並且可以採集用來確定活塞位置的光電開關的信號。
  7. Take out active plug of the water mouth, leak sewage, next, cover the plug, then turn bent axle handle for 10 seconds, thecentral axis drives mop roller at the speed of 120 circles, i. e. swinging, dehydration and dryness

    拉開導水口的活動塞子，排掉污水，再蓋回塞子封閉導水口。曲軸手柄旋轉10秒鐘，中心軸帶動滾筒旋轉達到120轉的速度高速甩水，產生離心力脫水。
  8. It whips and mixes the fresh air and crankcase fumes as it rotates.

    它旋轉時，把新鮮空氣和曲柄軸箱氣體攪混在一起。
  9. Pour detergent into the water inlet round hole on the cover of dehydrator, then connect the hose, turn bent faxle handle, waterrom 16 inlets spout to the cleaned part of rotating roller, so, under the function of centrifugal force, the high speed turningrotating roller can completely stir water, therefore achieve thecleanness effect

    ：洗滌劑從脫水器蓋子上加水口圓孔加入，接入水管，搖轉曲軸手柄，水就從上，而下於16個出水孔噴射向高速旋轉的滾筒需清潔部位，高速旋轉的滾筒在離心力作用下攪動產生水旋渦，從而達到洗滌效果。
  10. As a rigid rotor with special configuration, the crank is always integrated with its accessory components such as shaft and piston when it is under working conditions

    曲軸作為結構特殊的剛性轉子，在運行中總是與連桿，滑塊一起構成一個整體的曲柄連桿機構。
  11. This dissertation has presented a new method on the measuring and checking procedures of the dynamic unbalance of the motorcycle crank and made a deep research on its measuring device. what have been done is as follows : firstly, the dissertation has thoroughly discussed the basic theory of rotor unbalance such as its varieties ， characters and rules of the movement which is under the excitation of the inertial force and inertial moment induced by the unbalance mass. it also has deeply expounded the dynamic mechanics of the specially formed components ? crank, especially in the area of the crank integrated with shaft and piston

    本論文針對摩托車發動機曲柄連桿機構為研究對象，對曲柄連桿機構動平衡的測試提出了一種新方法，並對其數字化測試裝置進行了深入研究，完成的主要工作及取得的成果如下：首先，對動平衡理論進行了詳細的探討，論述了不平衡產生的原因，不平衡種類及轉子在不平衡量產生的慣性力激勵下的運動規律，並對曲軸這一結構特殊的剛性轉子的平衡理論進行了闡述，重點研究了曲柄連桿機構這一往復式機械構件的力學特性。
  12. This dissertation has presented a new method on the measuring and checking procedures of the dynamic unbalance of the motorcycle single - cylinder engine crank - connecting rod mechanism and made a deep research on its measuring device. what have been done is as follows : firstly, the dissertation has thoroughly discussed the basic theory of rotor unbalance such as its varieties, damages, characters and rules of the movement which is under the excitation of the inertial force and inertial moment induced by the unbalance mass. it also has deeply expounded the dynamic mechanics of the specially formed components - crank shaft, especially in the area of the crank - connecting rod mechanism

    本論文針對摩托車單缸發動機曲柄連桿機構為研究對象，對曲柄連桿機構動平衡的測試提出了一種新方法，並對其數字化測試裝置進行了深入研究，完成的主要工作及取得的成果如下：首先，對動平衡理論進行了詳細的探討，論述了不平衡產生的原因、危害，不平衡的種類及轉子在不平衡慣性力激勵下的運動規律，並對曲軸這一結構特殊的剛性轉子的平衡理論進行了闡述，重點研究了曲柄連桿機構這一往復式機械構件的力學特性。
  13. The massive walking - beam rose and fell above the deck ; at one end a piston - rod worked up and down ; and at the other was a connecting - rod which, in changing the rectilinear motion to a circular one, was directly connected with the shaft of the paddles

    甲板上露出一根很長的蒸汽機杠桿，兩頭一高一低地不停活動，這根杠桿的一端聯接著活塞柄，另一頭聯著輪機上的曲軸，這樣就把杠桿的直線推動力轉變為直接推動輪機的動力，從而使輪軸不停地旋轉起來。
分享友人
分享到 Line

分享到臉書